/openbmc/linux/lib/ |
H A D | Kconfig.kcsan | 77 than default value. 97 limited number of CPUs, a larger value helps to improve performance 99 conservative value; we should almost never observe "no_capacity" 130 memory operations are used to set up a watchpoint. A smaller value 131 results in more aggressive race detection, whereas a larger value 139 KCSAN_SKIP_WATCH. If false, the chosen value is always 174 reported if it was only possible to infer a race due to a data value 207 bool "Only report races where watcher observed a data value change" 212 the data value of the memory location was observed to remain
|
/openbmc/linux/drivers/mmc/host/ |
H A D | sdhci-sprd.c | 593 static int sdhci_sprd_get_best_clk_sample(struct mmc_host *mmc, u8 *value) in sdhci_sprd_get_best_clk_sample() argument 602 if (value[i]) { in sdhci_sprd_get_best_clk_sample() 637 u8 *value; in sdhci_sprd_tuning() local 640 value = kmalloc(SDHCI_SPRD_MAX_RANGE + 1, GFP_KERNEL); in sdhci_sprd_tuning() 641 if (!value) in sdhci_sprd_tuning() 664 value[i] = !mmc_send_tuning_cmd(card); in sdhci_sprd_tuning() 666 value[i] = !mmc_send_tuning_data(card); in sdhci_sprd_tuning() 669 best_clk_sample = sdhci_sprd_get_best_clk_sample(mmc, value); in sdhci_sprd_tuning() 690 kfree(value); in sdhci_sprd_tuning()
|
/openbmc/qemu/hw/virtio/ |
H A D | virtio-balloon.c | 300 int64_t value; in balloon_stats_set_poll_interval() local 302 if (!visit_type_int(v, name, &value, errp)) { in balloon_stats_set_poll_interval() 306 if (value < 0) { in balloon_stats_set_poll_interval() 311 if (value > UINT32_MAX) { in balloon_stats_set_poll_interval() 316 if (value == s->stats_poll_interval) { in balloon_stats_set_poll_interval() 320 if (value == 0) { in balloon_stats_set_poll_interval() 328 s->stats_poll_interval = value; in balloon_stats_set_poll_interval() 329 balloon_stats_change_timer(s, value); in balloon_stats_set_poll_interval() 336 s->stats_poll_interval = value; in balloon_stats_set_poll_interval()
|
/openbmc/openbmc/poky/meta/recipes-devtools/expect/expect/ |
H A D | expect-configure-c99.patch | 181 double value; 182 value = strtod(infString, &term); 187 value = strtod(nanString, &term); 192 value = strtod(spaceString, &term);
|
/openbmc/linux/drivers/leds/ |
H A D | leds-gpio.c | 37 enum led_brightness value) in gpio_led_set() argument 42 if (value == LED_OFF) in gpio_led_set() 60 enum led_brightness value) in gpio_led_set_blocking() argument 62 gpio_led_set(led_cdev, value); in gpio_led_set_blocking()
|
H A D | leds-lp3944.c | 76 static int lp3944_reg_read(struct i2c_client *client, u8 reg, u8 *value) in lp3944_reg_read() argument 84 *value = tmp; in lp3944_reg_read() 89 static int lp3944_reg_write(struct i2c_client *client, u8 reg, u8 value) in lp3944_reg_write() argument 91 return i2c_smbus_write_byte_data(client, reg, value); in lp3944_reg_write()
|
/openbmc/openbmc-test-automation/pldm/ |
H A D | test_pldm_bios.robot | 73 [Documentation] Verify if attribute value table content exist for 74 ... GetBIOSTable with table type attribute value table. 109 ... Fail Invalid GetBIOSAttributeCurrentValueByHandle value found. 150 # Split the string and remove first and 2nd last value from the list and
|
/openbmc/linux/include/uapi/sound/ |
H A D | asequencer.h | 193 signed int value; member 231 unsigned int value; member 240 signed int value; /* affected value (e.g. tempo) */ member 252 unsigned short value; /* optional data */ member
|
/openbmc/linux/drivers/net/ethernet/microchip/sparx5/ |
H A D | sparx5_netdev.c | 17 #define ifh_encode_bitfield(ifh, value, pos, _width) \ argument 26 __ifh_encode_bitfield((ifh), (value), (pos), width); \ 29 static void __ifh_encode_bitfield(void *ifh, u64 value, u32 pos, u32 width) in __ifh_encode_bitfield() argument 36 u64 encode = GENMASK_ULL(bit + width - 1, bit) & (value << bit); in __ifh_encode_bitfield()
|
/openbmc/linux/drivers/media/platform/chips-media/ |
H A D | coda-h264.c | 167 static int rbsp_write_bits(struct rbsp *rbsp, int num, int value) in rbsp_write_bits() argument 172 ret = rbsp_write_bit(rbsp, (value >> num) & 1); in rbsp_write_bits() 203 static int rbsp_write_uev(struct rbsp *rbsp, unsigned int value) in rbsp_write_uev() argument 207 int tmp = value + 1; in rbsp_write_uev()
|
/openbmc/linux/drivers/soc/aspeed/ |
H A D | aspeed-p2a-ctrl.c | 321 u32 value = 0; in aspeed_p2a_disable_all() local 324 value |= p2a_ctrl->config->regions[i].bit; in aspeed_p2a_disable_all() 326 regmap_update_bits(p2a_ctrl->regmap, SCU2C, value, value); in aspeed_p2a_disable_all()
|
/openbmc/linux/Documentation/devicetree/bindings/usb/ |
H A D | msm-hsusb.txt | 62 "do not overwrite default value at this address". 64 Will update only value at address ULPI_EXT_VENDOR_SPECIFIC + 1. 73 (no, min, max) where each value represents either a voltage 74 in microvolts or a value corresponding to voltage corner.
|
/openbmc/linux/drivers/accessibility/speakup/ |
H A D | speakup_keypc.c | 190 jiffy_delta_val = jiffy_delta->u.n.value; in do_catch_up() 208 full_time_val = full_time->u.n.value; in do_catch_up() 241 jiffy_delta_val = jiffy_delta->u.n.value; in do_catch_up() 242 delay_time_val = delay_time->u.n.value; in do_catch_up()
|
/openbmc/linux/Documentation/hwmon/ |
H A D | lm63.rst | 61 value have to be masked out. The value is still 16 bit in width. 67 store the value in an 8-bit register and have a selectable clock divider 69 value for measuring the speed of the fan. It can measure fan speeds down to
|
/openbmc/linux/drivers/crypto/intel/qat/qat_common/ |
H A D | adf_heartbeat.c | 98 static int get_timer_ticks(struct adf_accel_dev *accel_dev, unsigned int *value) in get_timer_ticks() argument 135 *value = ticks; in get_timer_ticks() 244 u32 *value) in adf_heartbeat_ms_to_ticks() argument 254 *value = time_ms * (clk_per_sec / MSEC_PER_SEC); in adf_heartbeat_ms_to_ticks()
|
/openbmc/linux/drivers/iio/adc/ |
H A D | stmpe-adc.c | 58 u32 value; member 89 *val = info->value; in stmpe_read_voltage() 126 *val = ((449960l * info->value) / 1024l) - 273150; in stmpe_read_temp() 202 info->value = (u32) be16_to_cpu(data); in stmpe_adc_isr()
|
/openbmc/u-boot/board/ti/beagle/ |
H A D | beagle.c | 332 u32 value; in misc_init_r() local 335 value = readl(&prog_io_base->io1); in misc_init_r() 336 value &= ~(PRG_I2C2_PULLUPRESX); in misc_init_r() 337 writel(value, &prog_io_base->io1); in misc_init_r()
|
/openbmc/u-boot/common/ |
H A D | miiphyutil.c | 240 unsigned short *value) in miiphy_read() argument 253 *value = (unsigned short)ret; in miiphy_read() 268 unsigned short value) in miiphy_write() argument 274 return bus->write(bus, addr, MDIO_DEVAD_NONE, reg, value); in miiphy_write()
|
/openbmc/linux/drivers/gpio/ |
H A D | gpio-sprd.c | 98 unsigned int offset, int value) in sprd_gpio_direction_output() argument 102 sprd_gpio_update(chip, offset, SPRD_GPIO_DATA, value); in sprd_gpio_direction_output() 112 int value) in sprd_gpio_set() argument 114 sprd_gpio_update(chip, offset, SPRD_GPIO_DATA, value); in sprd_gpio_set()
|
/openbmc/linux/drivers/gpu/drm/tegra/ |
H A D | sor.h | 222 #define SOR_XBAR_CTRL_LINK1_XSEL(channel, value) ((((value) & 0x7) << ((channel) * 3)) << 17) argument 223 #define SOR_XBAR_CTRL_LINK0_XSEL(channel, value) ((((value) & 0x7) << ((channel) * 3)) << 2) argument
|
/openbmc/qemu/target/mips/tcg/ |
H A D | ldst_helper.c | 57 target_ulong value, unsigned bits) in get_lmask() argument 61 value &= mask; in get_lmask() 64 value ^= mask; in get_lmask() 67 return value; in get_lmask()
|
/openbmc/linux/Documentation/admin-guide/mm/ |
H A D | swap_numa.rst | 70 The current swap device's priority is set as: user can set a >=0 value, 72 value in the swap_avail_list is the negated value of the swap device's 76 as the promoted value. So if multiple swap devices are attached to the same
|
/openbmc/openbmc/meta-security/recipes-ids/suricata/files/ |
H A D | CVE-2024-45797.patch | 108 bstr_free(h->value); 117 + bstr_free(h->value); 130 bstr_free(h->value); 139 + bstr_free(h->value);
|
/openbmc/linux/drivers/net/ethernet/ibm/ehea/ |
H A D | ehea.h | 125 #define EHEA_BMASK_SET(mask, value) \ argument 126 ((EHEA_BMASK_MASK(mask) & ((u64)(value))) << EHEA_BMASK_SHIFTPOS(mask)) 128 #define EHEA_BMASK_GET(mask, value) \ argument 129 (EHEA_BMASK_MASK(mask) & (((u64)(value)) >> EHEA_BMASK_SHIFTPOS(mask)))
|
/openbmc/phosphor-networkd/src/ |
H A D | inventory_mac.cpp | 158 std::variant<std::string> value; in getfromInventory() local 159 reply.read(value); in getfromInventory() 160 return stdplus::fromStr<stdplus::EtherAddr>(std::get<std::string>(value)); in getfromInventory() 224 if (objPath.str.find(pattern.value()) != std::string::npos) in registerSignals()
|