/openbmc/linux/Documentation/devicetree/bindings/iio/adc/ |
H A D | st,stm32-adc.yaml | 12 in single, continuous, scan or discontinuous mode. Result of the ADC is
|
/openbmc/linux/drivers/video/fbdev/omap2/omapfb/dss/ |
H A D | hdmi5_core.c | 855 audio_dma.mode = HDMI_AUDIO_TRANSF_DMA; in hdmi5_audio_config()
|
/openbmc/linux/drivers/spi/ |
H A D | spi-qcom-qspi.c | 503 mstr_cfg |= message->spi->mode << SPI_MODE_SHFT; in qcom_qspi_prepare_message()
|
/openbmc/linux/tools/include/uapi/sound/ |
H A D | asound.h | 772 unsigned int mode; /* For input data only, frame incoming data */ member
|
/openbmc/linux/fs/ |
H A D | Kconfig | 73 --mode=fsdax --map=mem
|
/openbmc/linux/drivers/platform/mellanox/ |
H A D | mlxbf-bootctl.c | 975 .attr = { .name = "bootfifo", .mode = 0400 },
|
/openbmc/linux/Documentation/devicetree/bindings/net/wireless/ |
H A D | qcom,ath11k.yaml | 73 - description: Signal bits used to enable/disable low power mode
|
/openbmc/linux/kernel/ |
H A D | params.c | 679 mk->mp->attrs[mk->mp->num].mattr.attr.mode = kp->perm; in add_sysfs_param()
|
/openbmc/linux/arch/powerpc/platforms/powernv/ |
H A D | pci.c | 663 if (edev->mode & EEH_DEV_REMOVED) in pnv_pci_cfg_check()
|
/openbmc/linux/drivers/firmware/efi/ |
H A D | efi.c | 182 return attr->mode; in efi_attr_is_visible()
|
/openbmc/linux/Documentation/i2c/ |
H A D | smbus-protocol.rst | 40 read mode.
|
/openbmc/linux/include/uapi/sound/ |
H A D | asound.h | 772 unsigned int mode; /* For input data only, frame incoming data */ member
|
/openbmc/linux/net/sched/ |
H A D | act_tunnel_key.c | 493 metadata->u.tun_info.mode |= IP_TUNNEL_INFO_TX; in tunnel_key_init()
|
/openbmc/linux/drivers/staging/rtl8712/ |
H A D | rtl871x_cmd.c | 510 psetop->mode = (u8)networktype; in r8712_setopmode_cmd()
|
/openbmc/linux/Documentation/arch/x86/x86_64/ |
H A D | boot-options.rst | 201 Disable firmware first mode for corrected errors. This
|
/openbmc/linux/arch/arm/boot/dts/st/ |
H A D | ste-ux500-samsung-skomer.dts | 703 /* Change unused pins to GPIO mode */
|
/openbmc/linux/arch/arm/boot/dts/ti/omap/ |
H A D | omap4-sdp.dts | 648 mode = <3>;
|
/openbmc/linux/drivers/staging/rtl8192e/ |
H A D | rtl819x_HTProc.c | 425 switch (ieee->mode) { in HT_PickMCSRate()
|
/openbmc/linux/Documentation/powerpc/ |
H A D | qe_firmware.rst | 80 5) If necessary, device drivers that need the virtual traps and extended mode
|
H A D | papr_hcalls.rst | 23 a *pSeries guest*. A pseries guest runs in a supervisor mode (HV=0) and must
|
/openbmc/linux/drivers/staging/media/atomisp/i2c/ |
H A D | mt9m114.h | 259 unsigned int mode; member
|
/openbmc/linux/arch/arm/boot/dts/samsung/ |
H A D | exynos5250-snow-common.dtsi | 101 * even though we run in polling mode.
|
/openbmc/linux/arch/arm/boot/dts/marvell/ |
H A D | mmp3.dtsi | 446 mrvl,i2c-fast-mode;
|
/openbmc/linux/drivers/bluetooth/ |
H A D | btmtkuart.c | 678 tci_sleep.mode = 0x5; in btmtkuart_setup()
|
/openbmc/linux/drivers/iio/frequency/ |
H A D | ad9523.c | 767 (st->spi->mode & SPI_3WIRE ? 0 : in ad9523_setup()
|