| /openbmc/linux/arch/arm/boot/dts/ti/omap/ |
| H A D | logicpd-torpedo-baseboard.dtsi | 165 data-lines = <16>;
|
| /openbmc/openbmc/poky/meta/classes/ |
| H A D | devtool-source.bbclass | 90 f.write('# Ignore local files, by default. Remove following lines'
|
| /openbmc/u-boot/ |
| H A D | MAINTAINERS | 22 One pattern per line. Multiple F: lines acceptable.
25 One pattern per line. Multiple N: lines acceptable.
44 One regex pattern per line. Multiple K: lines acceptable.
|
| /openbmc/openbmc/poky/documentation/dev-manual/ |
| H A D | licenses.rst | 41 begins with one and not zero. Also, the included lines are
42 inclusive (i.e. lines five through and including 29 in the
60 The first line locates a file in ``${S}/src/ls.c`` and isolates lines
|
| /openbmc/linux/Documentation/driver-api/dmaengine/ |
| H A D | provider.rst | 12 a given number of requests lines.
19 The request lines actually correspond to physical lines going from the
|
| /openbmc/linux/Documentation/PCI/ |
| H A D | pci.rst | 313 All interrupt handlers for IRQ lines should be registered with IRQF_SHARED
314 and use the devid to map IRQs to devices (remember that all PCI IRQ lines
319 IRQ lines which run from the PCI device to the Interrupt controller.
|
| /openbmc/linux/Documentation/scsi/ |
| H A D | ncr53c8xx.rst | 1213 When this option is set to a non-zero value, the driver checks SCSI lines
1215 The driver just reads SCSI lines and checks all lines read FALSE except RESET.
1429 you must ensure that lines of the wide part of the SCSI BUS are pulled-up.
1596 This register reflects the state of the SCSI control lines the
1600 Actual value of control lines on the SCSI BUS.
1603 Actual value of data lines on the SCSI BUS.
|
| /openbmc/qemu/docs/devel/ |
| H A D | qapi-code-gen.rst | 907 # multiple lines
912 # multiple lines
920 # multiple lines
926 If a list item's text spans multiple lines, then the second and
927 subsequent lines must be correctly indented to line up with the
1001 The second and subsequent lines of tagged sections must be indented
1133 The last line's de-indent is wrong. The second and subsequent lines
|
| /openbmc/linux/Documentation/admin-guide/device-mapper/ |
| H A D | snapshot.rst | 154 The snapshot-merge and snapshot status lines end with:
|
| /openbmc/linux/Documentation/trace/coresight/ |
| H A D | coresight-ect.rst | 51 (e.g. UART), or be propagated off chip as hardware IO lines.
|
| /openbmc/linux/Documentation/devicetree/bindings/net/ |
| H A D | ibm,emac.txt | 50 MDIO lines for the PHY used by this EMAC.
|
| /openbmc/qemu/scripts/coccinelle/ |
| H A D | errp-guard.cocci | 26 // lines which fit into 80 characters but not to coccinelle default,
|
| /openbmc/openbmc/poky/meta/recipes-devtools/gcc/ |
| H A D | gcc-multilib-config.inc | 95 # replace lines like
|
| /openbmc/docs/designs/ |
| H A D | gpio-based-cable-presence.md | 142 the lines to come from the same chip. See
|
| /openbmc/linux/Documentation/driver-api/media/ |
| H A D | camera-sensor.rst | 99 is pixels and the unit of the ``V4L2_CID_VBLANK`` is lines. The pixel rate in
|
| /openbmc/linux/drivers/net/wan/ |
| H A D | Kconfig | 10 lines, are used to interconnect Local Area Networks (LANs) over vast
|
| /openbmc/linux/arch/arm/boot/dts/allwinner/ |
| H A D | sun8i-a83t-bananapi-m3.dts | 329 * and external pull-ups on all the data lines. It should be set
|
| /openbmc/linux/Documentation/scheduler/ |
| H A D | sched-stats.rst | 68 CONFIG_SMP is not defined, *no* domains are utilized and these lines
|
| /openbmc/linux/Documentation/arch/x86/ |
| H A D | shstk.rst | 109 depending on what is enabled. The lines look like this::
|
| /openbmc/linux/Documentation/devicetree/bindings/arm/ |
| H A D | arm,vexpress-juno.yaml | 166 the CS. All interrupt lines between the motherboard and the tile
|
| /openbmc/linux/Documentation/w1/slaves/ |
| H A D | w1_therm.rst | 33 lines of ASCII output. The first line contains the nine hex bytes
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | submitting-patches.rst | 75 * Please align continuation lines with '(' on the previous line.
|
| /openbmc/linux/Documentation/translations/zh_TW/process/ |
| H A D | coding-style.rst | 487 * with beginning and ending almost-blank lines.
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6ul-14x14-evk.dtsi | 158 data-shift = <2>; /* lines 9:2 are used */
|
| /openbmc/linux/Documentation/power/ |
| H A D | suspend-and-interrupts.rst | 12 Device interrupt request lines (IRQs) are generally disabled during system
|