| /openbmc/linux/Documentation/devicetree/bindings/power/supply/ |
| H A D | richtek,rt5033-charger.yaml | 51 Phandle to a USB connector according to usb-connector.yaml. The connector
52 should be a child of the extcon device.
|
| /openbmc/linux/net/rxrpc/ |
| H A D | Kconfig | 43 Say Y here to inject a delay into packet reception, allowing an
45 /proc/sys/net/rxrpc/rxrpc_inject_rx_delay, setting a number of
|
| /openbmc/linux/Documentation/devicetree/bindings/display/mediatek/ |
| H A D | mediatek,dither.yaml | 18 For a description of the MMSYS_CONFIG binding, see
53 register offset and size. Each GCE subsys id is mapping to a client
|
| H A D | mediatek,postmask.yaml | 17 For a description of the MMSYS_CONFIG binding, see
50 register offset and size. Each GCE subsys id is mapping to a client
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | ti,cdce925.yaml | 50 Crystal load-capacitor value to fine-tune performance on a
58 spectrum clocking parameters for a board
|
| /openbmc/linux/Documentation/devicetree/bindings/net/ |
| H A D | intel,dwmac-plat.yaml | 30 - const: snps,dwmac-4.10a
101 compatible = "intel,keembay-dwmac", "snps,dwmac-4.10a";
|
| /openbmc/linux/Documentation/devicetree/bindings/display/bridge/ |
| H A D | chipone,icn6211.yaml | 15 It has a flexible configuration of MIPI DSI signal input and
25 description: virtual channel number of a DSI peripheral
|
| /openbmc/linux/Documentation/devicetree/bindings/regulator/ |
| H A D | renesas,raa215300.yaml | 13 The RAA215300 is a high-performance, low-cost 9-channel PMIC designed for
17 battery charger provide a highly integrated, small footprint power solution
|
| H A D | richtek,rt6245-regulator.yaml | 13 The RT6245 is a high-performance, synchronous step-down converter
31 it will be treat as a default-on power.
|
| /openbmc/linux/Documentation/devicetree/bindings/serial/ |
| H A D | rs485.yaml | 11 hereafter shall be given to a half-duplex capable UART node.
18 description: prop-encoded-array <a b>
|
| /openbmc/linux/Documentation/devicetree/bindings/gpio/ |
| H A D | socionext,uniphier-gpio.yaml | 14 pattern: "^gpio@[0-9a-f]+$"
108 // UNIPHIER_GPIO_PORT() is a helper macro to calculate 29 * 8 + 4.
|
| /openbmc/linux/tools/lib/thermal/ |
| H A D | Makefile | 94 LIBTHERMAL_A := $(OUTPUT)libthermal.a
124 …*.o *~ *.a *.so *.so.$(VERSION) *.so.$(LIBTHERMAL_VERSION) .*.d .*.cmd LIBTHERMAL-CFLAGS $(LIBTHER…
|
| /openbmc/linux/Documentation/devicetree/bindings/display/panel/ |
| H A D | advantech,idk-2121wr.yaml | 14 The IDK-2121WR from Advantech is a Full-HD dual-LVDS panel.
15 A dual-LVDS interface is a dual-link connection with even pixels traveling
|
| /openbmc/linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | nvidia,tegra234-pinmux-common.yaml | 19 "^pinmux(-[a-z0-9-]+)?$":
31 # properties but the per-SoC bindings define which of them apply to a
|
| /openbmc/linux/drivers/staging/ |
| H A D | Kconfig | 5 This option allows you to select a number of drivers that are
7 are placed here in order to get a wider audience to make use of
|
| /openbmc/linux/drivers/ata/pata_parport/ |
| H A D | comm.c | 25 #define j44(a, b) (((a >> 3) & 0x0f) | ((b << 1) & 0xf0)) argument
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-driver-uacce | 27 isolation strategy. This size is a configured integer value, which is the
30 a number of threshold based on your hardware.
|
| /openbmc/linux/arch/arm/boot/dts/broadcom/ |
| H A D | bcm2837-rpi-3-a-plus.dts | 10 compatible = "raspberrypi,3-model-a-plus", "brcm,bcm2837";
145 * by a single GPIO. We can't give GPIO control to one of the drivers,
|
| /openbmc/linux/arch/m68k/ |
| H A D | Kconfig.bus | 12 HP300 machines. If you are using such a system you almost certainly
44 name of a bus system, i.e. the way the CPU talks to the other stuff
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6qdl-emcon-avari.dtsi | 105 sgtl5000: audio-codec@a {
125 boardid: gpio@3a {
|
| H A D | imx25-eukrea-mbimxsd25-baseboard.dts | 3 * Copyright 2013 Eukréa Electromatique <denis@eukrea.com>
64 tlv320aic23: codec@1a {
|
| /openbmc/linux/drivers/clk/qcom/ |
| H A D | clk-alpha-pll.h | 65 #define VCO(a, b, c) { \ argument
66 .val = a,\
|
| /openbmc/linux/arch/alpha/lib/ |
| H A D | ev67-strchr.S | 59 cttz t0, a2 # U0 : speculative (in case we get a match)
76 cttz t3, a2 # U0 : speculative (in case we get a match)
|
| /openbmc/linux/arch/um/drivers/ |
| H A D | Makefile | 23 LDFLAGS_pcap.o = $(shell $(CC) $(KBUILD_CFLAGS) -print-file-name=libpcap.a)
25 LDFLAGS_vde.o = $(shell $(CC) $(CFLAGS) -print-file-name=libvdeplug.a)
|
| /openbmc/linux/mm/ |
| H A D | percpu-stats.c | 25 static int cmpint(const void *a, const void *b) in cmpint() argument
27 return *(int *)a - *(int *)b; in cmpint()
|