| /openbmc/linux/Documentation/devicetree/bindings/net/dsa/ |
| H A D | mscc,ocelot.yaml | 16 There are multiple switches which are either part of the Ocelot-1 family, or
17 derivatives of this architecture. These switches can be found embedded in
|
| H A D | dsa-port.yaml | 37 routes to neighbouring switches
|
| H A D | microchip,ksz.yaml | 7 title: Microchip KSZ Series Ethernet switches
|
| /openbmc/qemu/hw/xtensa/ |
| H A D | xtfpga.c | 70 uint32_t switches; member
78 s->switches = 0; in xtfpga_fpga_reset()
97 return s->switches; in xtfpga_fpga_read()
|
| /openbmc/linux/Documentation/driver-api/rapidio/ |
| H A D | rapidio.rst | 27 A typical RapidIO network is a combination of endpoints and switches.
266 device ID are queried against a table of known RapidIO switches. Each switch
272 chain of switches) does not have any endpoint (except enumerator) attached to
274 In the case of a chain of switches without endpoint, one fake device ID is used
275 to configure a route through the entire chain and switches are differentiated by
278 For both endpoints and switches the enumerator writes a unique component tag
|
| /openbmc/linux/Documentation/networking/dsa/ |
| H A D | configuration.rst | 88 DSA switches. These switches are capable to tag incoming and outgoing traffic
167 A minority of switches are not capable to use a taging protocol
168 (DSA_TAG_PROTO_NONE). These switches can be configured by a VLAN based
302 The existing DSA switches do not have the necessary hardware support to keep
370 Typically, DSA switches are attached to the host via a single Ethernet
|
| /openbmc/linux/Documentation/devicetree/bindings/i2c/ |
| H A D | i2c-mux.yaml | 17 For i2c multiplexers/switches that have child nodes that are a mixture of both
|
| /openbmc/openbmc/meta-openembedded/meta-oe/recipes-devtools/android-tools/android-tools/libselinux/ |
| H A D | 0001-libselinux-Do-not-define-gettid-if-glibc-2.30-is-use.patch | 13 …D_GLIBCXX_ASSERTIONS -fexceptions -fstack-protector-strong -grecord-gcc-switches -specs=/usr/lib/r…
|
| /openbmc/linux/Documentation/devicetree/bindings/usb/ |
| H A D | gpio-sbu-mux.yaml | 15 a family of hardware solutions which switches between these modes using GPIO
|
| /openbmc/linux/drivers/mux/ |
| H A D | Kconfig | 29 switches.
|
| /openbmc/linux/Documentation/devicetree/bindings/power/ |
| H A D | rockchip,power-controller.yaml | 132 while power domain switches state.
140 while power domain switches state.
|
| /openbmc/linux/drivers/thunderbolt/ |
| H A D | icm.c | 400 struct icm_fr_pkg_get_topology_response *switches, *sw; in icm_fr_get_route() local
408 switches = kcalloc(npackets, sizeof(*switches), GFP_KERNEL); in icm_fr_get_route()
409 if (!switches) in icm_fr_get_route()
412 ret = icm_request(tb, &request, sizeof(request), switches, in icm_fr_get_route()
413 sizeof(*switches), npackets, ICM_RETRIES, ICM_TIMEOUT); in icm_fr_get_route()
417 sw = &switches[0]; in icm_fr_get_route()
424 sw = &switches[index]; in icm_fr_get_route()
436 sw = &switches[index]; in icm_fr_get_route()
445 kfree(switches); in icm_fr_get_route()
|
| /openbmc/u-boot/drivers/i2c/muxes/ |
| H A D | Kconfig | 29 tristate "TI PCA954x I2C Mux/switches"
|
| /openbmc/openbmc/meta-openembedded/meta-oe/recipes-extended/fluentbit/fluentbit/ |
| H A D | 0004-build-Make-systemd-init-systemd-detection-contingent.patch | 25 # JOURNALD_DEFINITIONS - Compiler switches required for using Journald
|
| /openbmc/linux/Documentation/devicetree/bindings/arm/ |
| H A D | microchip,sparx5.yaml | 14 gigabit TSN-capable gigabit switches.
|
| /openbmc/linux/drivers/usb/typec/mux/ |
| H A D | Kconfig | 37 switches used with USB Type-C Alternate Modes.
|
| /openbmc/linux/drivers/net/dsa/ocelot/ |
| H A D | Kconfig | 5 This is an umbrella module for all network switches that are
|
| /openbmc/linux/drivers/net/ethernet/alteon/ |
| H A D | Kconfig | 27 bytes/frame) however it requires that your switches can handle this
|
| /openbmc/u-boot/arch/arm/mach-sunxi/ |
| H A D | rmr_switch.S | 14 @ This code below switches to AArch64 and starts execution at the specified
|
| /openbmc/linux/tools/perf/util/ |
| H A D | parse-events.l | 317 context-switches|cs { return sym(yyscanner, PERF_TYPE_SOFTWARE, PERF_COUNT_SW_CONTEXT_SWITCHES);…
326 cgroup-switches { return sym(yyscanner, PERF_TYPE_SOFTWARE, PERF_COUNT_SW_CGROUP_SWITCHES); }
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-tty | 10 console switches.
19 console switches.
|
| /openbmc/openbmc/meta-openembedded/meta-oe/recipes-devtools/nodejs/nodejs/ |
| H A D | 0004-v8-don-t-override-ARM-CFLAGS.patch | 21 Note that this also switches to Thumb(2) mode (in my case). No obvious
|
| /openbmc/qemu/docs/specs/ |
| H A D | standard-vga.rst | 7 command line switches:
|
| /openbmc/linux/arch/arm/boot/dts/marvell/ |
| H A D | kirkwood-openblocks_a6.dts | 65 pmx_dip_switches: pmx-dip-switches {
|
| /openbmc/linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3566-anbernic-rg353ps.dts | 59 simple-audio-card,pin-switches = "Internal Speakers";
|