| /openbmc/linux/arch/arm/boot/dts/ti/omap/ |
| H A D | am437x-gp-evm.dts | 706 link-frequencies = /bits/ 64 <70000000>;
747 link-frequencies = /bits/ 64 <70000000>;
|
| H A D | am437x-sk-evm.dts | 600 link-frequencies = /bits/ 64 <70000000>;
|
| H A D | am43x-epos-evm.dts | 703 link-frequencies = /bits/ 64 <70000000>;
|
| /openbmc/linux/arch/arm/boot/dts/renesas/ |
| H A D | r8a7778.dtsi | 501 /* Audio clocks; frequencies are set by boards if applicable. */
|
| /openbmc/linux/Documentation/admin-guide/pm/ |
| H A D | amd-pstate.rst | 98 an idle state. This would be equivalent to the highest frequencies
170 operating frequencies supported by the hardware. Users can check the
|
| H A D | intel-speed-select.rst | 869 speed-select-turbo-freq-clip-frequencies
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-devices-system-cpu | 440 nominal frequency) range of frequencies.
444 nominal frequency) range of frequencies.
|
| H A D | sysfs-bus-iio | 122 frequencies, we can specify the available values with:
125 - a range with minimum, step and maximum frequencies like
712 frequencies from 62500000 Hz to 8000000000 Hz.
716 A frequency doubler generates frequencies from
719 A frequency quadrupler generates frequencies from
2080 per channel sampling frequencies.
|
| /openbmc/linux/Documentation/admin-guide/media/ |
| H A D | vivid.rst | 403 interlaced, for pixelclock frequencies between 25 and 600 MHz. The field
461 interlaced, for pixelclock frequencies between 25 and 600 MHz. The field
1211 frequencies of the radio receiver and transmitter are not identical, so
1410 - The SDR radio should use the same 'frequencies' for stations as the normal
|
| /openbmc/u-boot/doc/ |
| H A D | README.b4860qds | 102 controllers, less serdes lanes, less SGMII interfaces and reduced target frequencies.
|
| /openbmc/linux/arch/arm/boot/dts/ti/davinci/ |
| H A D | da850.dtsi | 51 * Original silicon was 300MHz max, so higher frequencies
|
| /openbmc/u-boot/board/freescale/m54455evb/ |
| H A D | README | 18 - common/cmd_bdinfo.c Clock frequencies output
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | lm93.rst | 158 The LM93 supports several different frequencies for the PWM output channels.
|
| /openbmc/linux/Documentation/driver-api/media/ |
| H A D | dtv-frontend.rst | 101 frequencies are specified in kHz, while, for terrestrial and cable
|
| /openbmc/linux/arch/arm64/boot/dts/qcom/ |
| H A D | sc7280-herobrine.dtsi | 467 link-frequencies = /bits/ 64 <1620000000 2700000000 5400000000>;
|
| H A D | sc7180-trogdor.dtsi | 823 link-frequencies = /bits/ 64 <1620000000 2700000000 5400000000>;
|
| /openbmc/linux/arch/arm64/boot/dts/freescale/ |
| H A D | imx8mq-librem5.dtsi | 1086 link-frequencies = /bits/ 64
|
| /openbmc/linux/Documentation/arch/m68k/ |
| H A D | kernel-options.rst | 530 <vmin> and <vmax> are the minimum and maximum, resp., vertical frequencies
789 <vmin> and <vmax> are the minimum and maximum, resp., vertical frequencies
|
| /openbmc/linux/Documentation/fb/ |
| H A D | matroxfb.rst | 332 frequencies for them. So driver does not check this and allows you to
|
| /openbmc/qemu/docs/devel/ |
| H A D | clocks.rst | 71 - ``_hz`` for handling frequencies in hertz
|
| /openbmc/linux/Documentation/scheduler/ |
| H A D | sched-energy.rst | 400 least _requests_ frequencies calculated using the utilization signals.
|
| H A D | sched-util-clamp.rst | 734 jumping between frequencies depending on the order tasks wake up, and their
|
| /openbmc/linux/Documentation/networking/device_drivers/hamradio/ |
| H A D | z8530drv.rst | 581 only one transmitter that can be switched between frequencies.
|
| /openbmc/u-boot/cmd/ |
| H A D | Kconfig | 647 bool "clk - Show clock frequencies"
|
| /openbmc/linux/Documentation/networking/ |
| H A D | can.rst | 1352 clock frequencies. Disabling CONFIG_CAN_CALC_BITTIMING saves some
|