Home
last modified time | relevance | path

Searched refs:SD (Results 251 – 275 of 554) sorted by relevance

1...<<11121314151617181920>>...23

/openbmc/u-boot/board/freescale/ls1012aqds/
H A DREADME33 - SDHC2 controller: 1-/4-bit SD/MMC card supporting 1.8 V devices
/openbmc/u-boot/arch/arm/mach-aspeed/ast2600/
H A DKconfig17 4 Serial ports, 4 USB ports, VGA port, PCIe, SD card slot,
/openbmc/linux/Documentation/translations/zh_CN/scheduler/
H A Dsched-design-CFS.rst55 任务未来执行的“时间线”。因此没有任何“数组切换”的旧包袱（之前的原始调度器和RSDL/SD都
/openbmc/linux/arch/arm/boot/dts/nxp/imx/
H A Dimx6ull-dhcom-picoitx.dts6 * DHCM-iMX6ULL-C080-R051-F0409-SPI-E2-CAN2-SD-RTC-ADC-I-01D2
H A Dimx6qdl-dhcom-som.dtsi88 * Special SoM hardware required which uses the pins from micro SD card. The
91 * the board device tree file, the micro SD card must be disabled and the uart1
405 &usdhc2 { /* External SD card via DHCOM */
413 &usdhc3 { /* Micro SD card on module */
/openbmc/linux/arch/arm64/boot/dts/apple/
H A Dt600x-j375.dtsi94 /* SD card reader */
H A Dt600x-j314-j316.dtsi109 /* SD card reader */
/openbmc/linux/arch/arm/boot/dts/broadcom/
H A Dbcm2837-rpi-zero-2-w.dts90 /* Used by SD Card */
H A Dbcm2835-rpi-zero-w.dts92 /* Used by SD Card */
/openbmc/linux/arch/riscv/boot/dts/microchip/
H A Dmpfs-m100pfsevp.dts76 /* Set to low for eMMC, high for SD-card */
/openbmc/u-boot/doc/
H A DREADME.ramboot-ppc85xx6 - In case of SD and SPI boot this is done by BootROM code inside the chip
43 - In case of SD card and SPI flash bootloader this is done by On Chip BootROM inside the Si itself.
H A DREADME.android-fastboot129 * MMC and SD cards: ``mmcsd``
134 controller, SD/MMC controller) or disk index. The partition index starts
/openbmc/linux/arch/arm/boot/dts/st/
H A Dste-hrefv60plus.dtsi192 // External Micro SD slot
216 /* SD card detect GPIO pin, extend default state */
H A Dste-snowball.dts246 // External Micro SD slot
464 regulator-name = "V-MMC-SD";
541 /* SD card detect GPIO pin, extend default state */
/openbmc/linux/arch/arm64/boot/dts/xilinx/
H A Dzynqmp-sck-kv-g-revA.dtso8 * SD level shifter:
131 * SD 3.0 requires level shifter and this property
/openbmc/u-boot/board/ti/ks2_evm/
H A DREADME191 2. Create SD card partitions as per steps given in Hardware Setup Guide.
193 4. Insert SD card and Power on the EVM.
194 The EVM now boots with U-Boot image from SD card.
/openbmc/linux/Documentation/devicetree/bindings/mmc/
H A Dk3-dw-mshc.txt7 a SoC with storage medium such as eMMC or SD/MMC cards. This file documents
H A Drenesas,sdhi.yaml7 title: Renesas SDHI SD/MMC controller
134 turned off, external SD card detection cannot be
/openbmc/u-boot/board/menlo/m53menlo/
H A Dimximage.cfg17 /* Boot Offset 0x400, valid for both SD and NAND boot. */
/openbmc/u-boot/doc/SPI/
H A DREADME.ti_qspi_flash16 MLO/u-boot.img will be flashed from SD/MMC to the flash device
/openbmc/u-boot/board/k+p/bootscripts/
H A Dtpcboot.cmd19 # If not set - eMMC/SD boot
/openbmc/u-boot/board/amlogic/odroid-c2/
H A DREADME.odroid-c260 and then write the image to SD with:
/openbmc/linux/Documentation/scheduler/
H A Dsched-domains.rst69 SD_* to get an idea of the specifics and what to tune for the SD flags
72 Architectures may override the generic domain builder and the default SD flags
/openbmc/linux/Documentation/devicetree/bindings/pinctrl/
H A Daxis,artpec6-pinctrl.txt50 - drive-strength: 4, 6, 8, 9 mA. For SD and NAND pins, this is for 3.3V VCCQ3.
/openbmc/linux/arch/arm64/boot/dts/amlogic/
H A Dmeson-gxl-s905x-hwacom-amazetv.dts122 /* SD card */

1...<<11121314151617181920>>...23