Searched hist:"7 e3f7375" (Results 1 – 2 of 2) sorted by relevance
/openbmc/linux/drivers/input/touchscreen/ |
H A D | Makefile | 7e3f7375 Thu Jun 11 01:27:22 CDT 2009 Wan ZongShun <mcuos.com@gmail.com> Input: add support for touchscreen on W90P910 ARM platform
The touchscreen works in two modes, wait trigger mode and auto-semi mode. The device starts in wait trigger mode and waits until pressure is detected, then device sets WT_INT bit and raises an interrupt. The driver should put the device into auto-semi mode and prepare for reading first X and then Y coordinates. When coordinate data is ready the driver sets ADC_INT bit and raises interrupt again.
[dtor@mail.ru: various cleanups] Signed-off-by: Wan ZongShun <mcuos.com@gmail.com> Signed-off-by: Dmitry Torokhov <dtor@mail.ru> 7e3f7375 Thu Jun 11 01:27:22 CDT 2009 Wan ZongShun <mcuos.com@gmail.com> Input: add support for touchscreen on W90P910 ARM platform The touchscreen works in two modes, wait trigger mode and auto-semi mode. The device starts in wait trigger mode and waits until pressure is detected, then device sets WT_INT bit and raises an interrupt. The driver should put the device into auto-semi mode and prepare for reading first X and then Y coordinates. When coordinate data is ready the driver sets ADC_INT bit and raises interrupt again. [dtor@mail.ru: various cleanups] Signed-off-by: Wan ZongShun <mcuos.com@gmail.com> Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
|
H A D | Kconfig | 7e3f7375 Thu Jun 11 01:27:22 CDT 2009 Wan ZongShun <mcuos.com@gmail.com> Input: add support for touchscreen on W90P910 ARM platform
The touchscreen works in two modes, wait trigger mode and auto-semi mode. The device starts in wait trigger mode and waits until pressure is detected, then device sets WT_INT bit and raises an interrupt. The driver should put the device into auto-semi mode and prepare for reading first X and then Y coordinates. When coordinate data is ready the driver sets ADC_INT bit and raises interrupt again.
[dtor@mail.ru: various cleanups] Signed-off-by: Wan ZongShun <mcuos.com@gmail.com> Signed-off-by: Dmitry Torokhov <dtor@mail.ru> 7e3f7375 Thu Jun 11 01:27:22 CDT 2009 Wan ZongShun <mcuos.com@gmail.com> Input: add support for touchscreen on W90P910 ARM platform The touchscreen works in two modes, wait trigger mode and auto-semi mode. The device starts in wait trigger mode and waits until pressure is detected, then device sets WT_INT bit and raises an interrupt. The driver should put the device into auto-semi mode and prepare for reading first X and then Y coordinates. When coordinate data is ready the driver sets ADC_INT bit and raises interrupt again. [dtor@mail.ru: various cleanups] Signed-off-by: Wan ZongShun <mcuos.com@gmail.com> Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
|