| /openbmc/u-boot/doc/device-tree-bindings/gpio/ |
| H A D | nvidia,tegra186-gpio.txt | 17 varies between the different GPIO controllers.
36 The number of ports implemented by each GPIO controller varies. The number of
37 implemented GPIOs within each port varies. GPIO registers within a controller
50 number of interrupt signals generated by a controller varies as a rough function
90 order the HW manual describes them. The number of entries required varies
|
| /openbmc/linux/Documentation/devicetree/bindings/gpio/ |
| H A D | nvidia,tegra186-gpio.yaml | 28 features available, varies between the different GPIO controllers.
47 The number of ports implemented by each GPIO controller varies. The number
48 of implemented GPIOs within each port varies. GPIO registers within a
63 varies as a rough function of the number of ports it implements. Note
110 required varies depending on compatible value.
|
| /openbmc/u-boot/arch/arm/mach-omap2/ |
| H A D | abb.c | 32 * settling time of ldo in micro-seconds (varies per OMAP family), in abb_setup_timings()
33 * of clock cycles per SYS_CLK period (varies per OMAP family), in abb_setup_timings()
34 * the SYS_CLK frequency in MHz (varies per board) in abb_setup_timings()
|
| /openbmc/linux/Documentation/devicetree/bindings/spi/ |
| H A D | nvidia,tegra210-quad-peripheral-props.yaml | 17 Tap value varies based on platform design trace lengths from Tegra
26 Tap value varies based on platform design trace lengths from Tegra
|
| /openbmc/linux/arch/arm/boot/dts/samsung/ |
| H A D | exynos5420-galaxy-tab-common.dtsi | 382 * LDO15 varies between devices and is
402 * LDO17 varies between devices and is
506 * LDO28 varies between devices and is
514 * LDO29 varies between devices and is
532 * LDO31 varies between devices and is
540 * LDO32 varies between devices and is
|
| /openbmc/linux/Documentation/sound/soc/ |
| H A D | dai.rst | 30 usually varies depending on the sample rate and the master system clock
53 receive the audio data. Bit clock usually varies depending on sample rate
|
| /openbmc/linux/Documentation/devicetree/bindings/net/ |
| H A D | cavium-pip.txt | 41 Value range is 1-31, and mapping to the actual delay varies depending on HW.
44 Value range is 1-31, and mapping to the actual delay varies depending on HW.
|
| /openbmc/linux/tools/perf/bench/ |
| H A D | futex.h | 34 * @val: typically expected value of uaddr, but varies by op
38 * @val3: varies by op
|
| /openbmc/linux/drivers/opp/ |
| H A D | Kconfig | 8 of OPP varies over silicon within the same family of devices.
|
| /openbmc/linux/Documentation/input/devices/ |
| H A D | iforce-protocol.rst | 63 LEN= Varies from device to device
80 LEN= Varies
218 Query command. Length varies according to the query type.
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-class-leds-gt683r | 18 Breathing: LEDs brightness varies at human breathing rate
|
| /openbmc/u-boot/arch/arm/include/asm/arch-tegra/ |
| H A D | xusb-padctl.h | 10 * The type of PHY varies between SoC generations. Typically there are XUSB,
|
| /openbmc/linux/Documentation/devicetree/bindings/phy/ |
| H A D | nvidia,tegra194-xusb-padctl.yaml | 400 valid port numbers varies with the SoC generation.
433 valid port numbers varies with the SoC generation.
466 valid port numbers varies with the SoC generation.
499 valid port numbers varies with the SoC generation.
|
| H A D | nvidia,tegra186-xusb-padctl.yaml | 363 valid port numbers varies with the SoC generation.
384 valid port numbers varies with the SoC generation.
405 valid port numbers varies with the SoC generation.
|
| H A D | nvidia,tegra210-xusb-padctl.yaml | 532 valid port numbers varies with the SoC generation.
553 valid port numbers varies with the SoC generation.
574 valid port numbers varies with the SoC generation.
595 valid port numbers varies with the SoC generation.
|
| /openbmc/u-boot/arch/arm/include/asm/arch-mx6/ |
| H A D | mx6-ddr.h | 364 /* Device Information: Varies per DDR3 part number and speed grade */
379 /* Device Information: Varies per LPDDR2 part number and speed grade */
394 /* System Information: Varies per board design, layout, and term choices */
|
| /openbmc/openbmc/poky/meta/recipes-devtools/rpm/files/ |
| H A D | 0001-build-pack.c-do-not-insert-payloadflags-into-.rpm-me.patch | 7 (deterministic), and 56 is the amount of threads (varies from one
|
| /openbmc/linux/Documentation/devicetree/bindings/watchdog/ |
| H A D | cdns,wdt-r1p2.yaml | 15 a programmable reset period. The timeout period varies from 1 ms
|
| /openbmc/linux/Documentation/devicetree/bindings/mtd/partitions/ |
| H A D | qcom,smem-part.yaml | 15 varies between partition table revisions. V3 supports maximum 16 partitions
|
| /openbmc/openbmc/poky/meta/recipes-support/lz4/lz4/ |
| H A D | reproducibility.patch | 3 The static library contents varies depending of the order of the object files on disk meaning
|
| /openbmc/linux/lib/pldmfw/ |
| H A D | pldmfw_private.h | 100 /* This is not a struct type because the size of each record varies */
131 /* This is not a struct type because the component size varies */
|
| /openbmc/linux/Documentation/rust/ |
| H A D | arch-support.rst | 8 support for building the kernel with LLVM/Clang varies (please see
|
| /openbmc/linux/Documentation/userspace-api/media/dvb/ |
| H A D | fe-read-status.rst | 43 varies according with the architecture. This needs to be fixed in the
|
| /openbmc/openbmc/poky/meta/recipes-devtools/ruby/ruby/ |
| H A D | 0004-lib-mkmf.rb-sort-list-of-object-files-in-generated-M.patch | 8 When the list of object files varies between builds, they are linked
|
| /openbmc/linux/drivers/w1/slaves/ |
| H A D | w1_ds2438.c | 479 static BIN_ATTR_RO(temperature, 0/* real length varies */);
480 static BIN_ATTR_RO(vad, 0/* real length varies */);
481 static BIN_ATTR_RO(vdd, 0/* real length varies */);
|