Home
last modified time | relevance | path

Searched +full:rx +full:- +full:float +full:- +full:inactive (Results 1 – 6 of 6) sorted by relevance

/openbmc/linux/Documentation/devicetree/bindings/input/
H A Diqs269a.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jeff LaBundy <jeff@labundy.com>
13 The Azoteq IQS269A is an 8-channel capacitive touch controller that features
14 additional Hall-effect and inductive sensing capabilities.
28 "#address-cells":
31 "#size-cells":
34 azoteq,hall-enable:
37 Enables Hall-effect sensing on channels 6 and 7. In this case, keycodes
[all …]
H A Dazoteq,iqs7222.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jeff LaBundy <jeff@labundy.com>
21 - azoteq,iqs7222a
22 - azoteq,iqs7222b
23 - azoteq,iqs7222c
24 - azoteq,iqs7222d
29 irq-gpios:
32 Specifies the GPIO connected to the device's active-low RDY output.
[all …]
/openbmc/u-boot/include/
H A Dusbdevice.h1 /* SPDX-License-Identifier: GPL-2.0+ */
129 * float y;
142 #define member_offset(type,memb) (_cv_(&(((type*)0)->memb))-(char*)0)
143 #define p2surround(type,memb,ptr) ((type*)(void*)(_cv_(ptr)-member_offset(type,memb)))
292 * Device Requests (c.f Table 9-2)
372 * Device State (c.f USB Spec 2.0 Figure 9-1)
410 * These are defined in the USB Spec (c.f USB Spec 2.0 Figure 9-1).
418 DEVICE_UNKNOWN, /* bi - unknown event */
419 DEVICE_INIT, /* bi - initialize */
420 DEVICE_CREATE, /* bi - */
[all …]
/openbmc/linux/drivers/tty/serial/
H A Dimx.c1 // SPDX-License-Identifier: GPL-2.0+
30 #include <linux/dma-mapping.h>
33 #include <linux/dma/imx-dma.h>
125 #define UFCR_RFDIV_REG(x) (((x) < 7 ? 6 - (x) : 6) << 7)
154 #define UTS_LOOP (1<<12) /* Loop tx and rx */
161 /* We've been assigned a range on the "Low-density serial ports" major */
174 #define DRIVER_NAME "IMX-uart"
265 { .compatible = "fsl,imx6q-uart", .data = &imx_uart_devdata[IMX6Q_UART], },
266 { .compatible = "fsl,imx53-uart", .data = &imx_uart_devdata[IMX53_UART], },
267 { .compatible = "fsl,imx1-uart", .data = &imx_uart_devdata[IMX1_UART], },
[all …]
/openbmc/linux/drivers/input/misc/
H A Diqs269a.c1 // SPDX-License-Identifier: GPL-2.0+
8 * inductive keys as well as Hall-effect switches, and one for each of the two
193 .name = "event-prox",
199 .name = "event-prox-alt",
206 .name = "event-touch",
212 .name = "event-touch-alt",
219 .name = "event-deep",
225 .name = "event-deep-alt",
301 struct iqs269_ch_reg *ch_reg = iqs269->sys_reg.ch_reg; in iqs269_ati_mode_set()
305 return -EINVAL; in iqs269_ati_mode_set()
[all …]
H A Diqs7222.c1 // SPDX-License-Identifier: GPL-2.0-or-later
116 [IQS7222_REG_GRP_CYCLE] = "cycle-%d",
117 [IQS7222_REG_GRP_CHAN] = "channel-%d",
118 [IQS7222_REG_GRP_SLDR] = "slider-%d",
120 [IQS7222_REG_GRP_GPIO] = "gpio-%d",
150 .name = "event-prox",
155 .name = "event-touch",
162 { .name = "event-press", },
164 .name = "event-tap",
171 .name = "event-swipe-pos",
[all …]