Searched full:regulate (Results 1 – 18 of 18) sorted by relevance
| /openbmc/linux/drivers/mmc/core/ |
| H A D | regulator.c | 96 * @mmc: the host to regulate
165 * @mmc: the host to regulate
240 * @mmc: the host to regulate
280 * @mmc: the host to regulate
304 * @mmc: the host to regulate
|
| /openbmc/linux/drivers/platform/x86/intel/int1092/ |
| H A D | Kconfig | 7 M.2 modem to regulate the RF power based on SAR data obtained from the
|
| /openbmc/linux/Documentation/devicetree/bindings/leds/ |
| H A D | leds-sgm3140.yaml | 13 The SGM3140 is a current-regulated charge pump which can regulate two current
|
| /openbmc/linux/Documentation/devicetree/bindings/regulator/ |
| H A D | ltc3676.txt | 20 Regulators sw1, sw2, sw3, sw4 can regulate the feedback reference from:
|
| H A D | ltc3589.txt | 20 Regulators sw1, sw2, sw3, and ldo2 can regulate the feedback reference from
|
| /openbmc/linux/Documentation/sound/cards/ |
| H A D | serial-u16550.rst | 92 Additionally, the CTS signal is used to regulate the data flow. The number of
|
| /openbmc/linux/drivers/net/wireless/intersil/orinoco/ |
| H A D | orinoco_pci.c | 76 * jiffies to regulate time instead of a straight mdelay(). Usually we
|
| H A D | hermes.h | 137 /*--- Regulate Commands ------------------------------*/
|
| /openbmc/qemu/hw/rtc/ |
| H A D | allwinner-rtc.c | 65 REG_VDD_RTC, /* VDD RTC Regulate Register */
|
| /openbmc/bmcweb/redfish-core/schema/dmtf/json-schema/ |
| H A D | Control.v1_5_2.json | 910 …"Power": "This value shall indicate a control used to regulate or limit maximum power consumption,…
913 …"Temperature": "This value shall indicate a control used to regulate temperature, in degree Celsiu…
|
| /openbmc/dbus-sensors/include/linux/ |
| H A D | peci-ioctl.h | 149 * management system to regulate the temperature on the die. The data is
|
| /openbmc/bmcweb/redfish-core/schema/dmtf/csdl/ |
| H A D | Control_v1.xml | 290 …ta.LongDescription" String="This value shall indicate a control used to regulate temperature, in d…
294 …ta.LongDescription" String="This value shall indicate a control used to regulate or limit maximum …
|
| /openbmc/linux/sound/soc/codecs/ |
| H A D | arizona-jack.c | 246 dev_err(arizona->dev, "Failed to regulate MICVDD: %d\n", ret); in arizona_start_mic()
825 /* Don't need to regulate for button detection */ in arizona_micdet_reading()
|
| /openbmc/linux/drivers/comedi/drivers/ |
| H A D | jr3_pci.h | 41 * is used to regulate the voltage over various cable lengths.
|
| /openbmc/linux/Documentation/core-api/ |
| H A D | workqueue.rst | 64 * Automatically regulate worker pool and level of concurrency so that
|
| /openbmc/linux/drivers/hwmon/ |
| H A D | g762.c | 922 * closed-loop mode. Speed is given as a RPM value; then the chip will regulate
|
| /openbmc/linux/drivers/net/fddi/skfp/ |
| H A D | fplustm.c | 288 * set the TSYNC register of the FORMAC to regulate synchronous transmission
|
| /openbmc/linux/drivers/staging/wlan-ng/ |
| H A D | hfa384x.h | 132 /*--- Regulate Commands --------------------------*/
|