Searched +full:phyrst +full:- +full:a +full:- +full:enable (Results 1 – 6 of 6) sorted by relevance
1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)3 ---4 $id: http://devicetree.org/schemas/phy/phy-cadence-torrent.yaml#5 $schema: http://devicetree.org/meta-schemas/core.yaml#16 - Swapnil Jakhade <sjakhade@cadence.com>17 - Yuti Amonkar <yamonkar@cadence.com>22 - cdns,torrent-phy23 - ti,j721e-serdes-10g25 '#address-cells':28 '#size-cells':[all …]
1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause3 ---5 $schema: http://devicetree.org/meta-schemas/core.yaml#7 title: Cadence USBSS-DRD controller10 - Pawel Laszczak <pawell@cadence.com>18 - description: OTG controller registers19 - description: XHCI Host controller registers20 - description: DEVICE controller registers22 reg-names:24 - const: otg[all …]
2 natsemi.c: A U-Boot driver for the NatSemi DP8381x series.3 Author: Mark A. Rakes (mark_rakes@vivato.net)14 Adapted from a Linux driver which was written by Donald Becker21 Written/copyright 1999-2001 by Donald Becker.27 a complete program and may only be used when the entire operating48 * Initial U-Boot Release. Tested with Netgear FA311 board61 #define EEPROM_SIZE 0xb /*12 16-bit chunks, or 24 bytes*/71 Unlike software-only systems, device drivers interact with complex hardware.91 /* These are from the spec, around page 78... on a separate table. */128 PhyRst = 0x00000400, enumerator[all …]
2 ns8382x.c: A U-Boot driver for the NatSemi DP8382[01].3 ported by: Mark A. Rakes (mark_rakes@vivato.net)13 Adapted from a Linux driver which was written by Donald Becker18 2. A Linux driver by Donald Becker, ns820.c:19 Written/copyright 1999-2002 by Donald Becker.25 a complete program and may only be used when the entire operating44 * Initial U-Boot Release.48 * a programmed EEPROM device (if present) in order to work107 PhyRst = 0x00000400, enumerator229 /* 1K-base T control register */[all …]
1 // SPDX-License-Identifier: GPL-2.05 * Copyright (C) 2018-2020 Cadence.6 * Copyright (C) 2017-2018 NXP23 #include "gadget-export.h"30 ret = phy_power_on(cdns->usb2_phy); in set_phy_power_on()34 ret = phy_power_on(cdns->usb3_phy); in set_phy_power_on()36 phy_power_off(cdns->usb2_phy); in set_phy_power_on()43 phy_power_off(cdns->usb3_phy); in set_phy_power_off()44 phy_power_off(cdns->usb2_phy); in set_phy_power_off()48 * cdns3_plat_probe - probe for cdns3 core device[all …]
1 // SPDX-License-Identifier: GPL-2.05 * Copyright (C) 2020-2021 Texas Instruments Incorporated - https://www.ti.com/9 serdes_refclk: serdes-refclk {10 #clock-cells = <0>;11 compatible = "fixed-clock";17 compatible = "mmio-sram";19 #address-cells = <1>;20 #size-cells = <1>;23 atf-sram@0 {28 scm_conf: scm-conf@100000 {[all …]