| /openbmc/u-boot/board/eets/pdu001/ |
| H A D | README | 31 The system boots from either eMMC or SD card cage. It will first try to boot
32 from the SD card cage. If this fails (missing or unbootable SD card) it will
|
| H A D | board.h | 26 * as MMC1 (microSD card-cage) since these are our boot devices.
|
| /openbmc/linux/arch/arm64/boot/dts/mediatek/ |
| H A D | mt7986a-bananapi-bpi-r3.dts | 66 /* i2c of the left SFP cage (wan) */
76 /* i2c of the right SFP cage (lan) */
124 /* left SFP cage (wan) */
135 /* right SFP cage (lan) */
|
| /openbmc/u-boot/board/freescale/t208xqds/ |
| H A D | t208xqds.c | 144 /* SD1(A:D) => XFI cage in brd_mux_lane_to_slot()
151 /* SD1(A:D) => XFI cage in brd_mux_lane_to_slot()
159 /* SD1(A:B) => XFI cage in brd_mux_lane_to_slot()
|
| H A D | eth_t208xqds.c | 792 /* As XFI is in cage intead of a slot, so in board_eth_init()
|
| /openbmc/u-boot/board/freescale/ls1046ardb/ |
| H A D | README | 18 - Lane1: XFI Cage
|
| /openbmc/linux/arch/arm/boot/dts/marvell/ |
| H A D | armada-385-turris-omnia.dts | 186 * eth2 is connected via a multiplexor to both the SFP cage and to
187 * ethernet-phy@1. The multiplexor switches the signal to SFP cage when
|
| /openbmc/linux/Documentation/devicetree/bindings/net/ |
| H A D | ethernet-controller.yaml | 147 Specifies a reference to a node representing a SFP cage.
|
| H A D | ethernet-phy.yaml | 192 Specifies a reference to a node representing a SFP cage.
|
| /openbmc/linux/drivers/net/phy/ |
| H A D | Kconfig | 64 tristate "SFP cage support"
|
| H A D | phy_device.c | 1358 * @bus: sfp bus representing cage being attached
1375 * @bus: sfp bus representing cage being attached
1390 * phy_sfp_probe - probe for a SFP cage attached to this PHY device
|
| /openbmc/linux/Documentation/networking/ |
| H A D | sfp-phylink.rst | 282 For information describing the SFP cage in DT, please see the binding
|
| /openbmc/openbmc/meta-openembedded/meta-oe/recipes-graphics/xscreensaver/files/ |
| H A D | 0001-Tweak-app-defaults.patch | 102 -@GL_KLUDGE@ GL: cage -root \n\
|
| /openbmc/linux/drivers/net/ethernet/intel/ice/ |
| H A D | ice_common.c | 412 * Node type cage can be used to determine if cage is present. If AQC
413 * returns error (ENOENT), then no cage present. If no cage present, then
442 * Returns true if media cage is present, else false. If no cage, then
447 /* Node type cage can be used to determine if cage is present. If AQC in ice_is_media_cage_present()
448 * returns error (ENOENT), then no cage present. If no cage present then in ice_is_media_cage_present()
|
| /openbmc/linux/drivers/net/ethernet/intel/igb/ |
| H A D | e1000_82575.c | 499 /* Turn I2C interface ON and power on sfp cage */ in igb_set_sfp_media_type_82575()
903 /* restore previous sfp cage power state */ in igb_get_phy_id_82575()
1596 /* allow time for SFP cage time to power up phy */ in igb_setup_copper_link_82575()
1671 /* power on the sfp cage if present and turn on I2C */ in igb_setup_serdes_link_82575()
|
| /openbmc/u-boot/tools/patman/ |
| H A D | README | 236 - Guinea pig moved into its cage
|
| /openbmc/linux/drivers/bus/ |
| H A D | moxtet.c | 33 { "sfp", -1, 0, "MOX D (SFP cage)" },
|
| /openbmc/linux/drivers/hwmon/ |
| H A D | intel-m10-bmc-hwmon.c | 603 * When the QSFP is unplugged from cage, driver will get 0xdeadbeef in do_sensor_read()
|
| /openbmc/linux/drivers/gpio/ |
| H A D | Kconfig | 1759 bus. For example the Mox module with SFP cage needs this driver
|
| /openbmc/linux/drivers/scsi/ |
| H A D | Kconfig | 183 manage devices. If you have a disk cage, the chances are that
|
| /openbmc/linux/drivers/net/ethernet/intel/ixgbe/ |
| H A D | ixgbe_x550.c | 1692 * internal PHY directly to an SFP cage, without autonegotiation.
|
| H A D | ixgbe_common.c | 3287 * the SFP+ cage is full. in ixgbe_check_mac_link_generic()
|
| /openbmc/linux/drivers/net/ethernet/sfc/ |
| H A D | mcdi_pcol.h | 24894 /* An array of cage types on the board */
|