| /openbmc/linux/Documentation/devicetree/bindings/sound/ |
| H A D | cs4265.txt | 10 the state of the AD0 pin. If AD0 is high, the i2c address is 0x4f.
20 codec_ad0_high: cs4265@4f { /* AD0 Pin is high */
26 codec_ad0_low: cs4265@4e { /* AD0 Pin is low */
|
| H A D | cs35l34.txt | 34 according to the AD0 pin or directly via this configuration.
35 0x0 (Default) = Selected by AD0 input (if AD0 = LOW, use left channel),
37 0x1 = Selected by the inversion of the AD0 input (if AD0 = LOW, use right
|
| H A D | cirrus,cs4234.yaml | 34 binary given by [0 0 1 0 AD2 AD1 AD0 0].
|
| H A D | cs35l32.txt | 8 of the AD0 pin. Level 0 is 0x40 while Level 1 is 0x41.
|
| /openbmc/linux/include/linux/platform_data/ |
| H A D | ad7266.h | 26 * (SGL/DIFF pin set to low, AD0 pin set to low)
28 * (SGL/DIFF pin set to low, AD0 pin set to high)
|
| /openbmc/linux/arch/powerpc/platforms/512x/ |
| H A D | mpc512x_shared.c | 48 struct diu_ad ad0; /* 32-bit aligned! */ member
237 memcpy(&diu_shared_fb.ad0, vaddr, sizeof(struct diu_ad)); in mpc512x_init_diu()
239 dst = (unsigned long)&diu_shared_fb.ad0; in mpc512x_init_diu()
266 out_be32(&diu_reg->desc[0], virt_to_phys(&diu_shared_fb.ad0)); in mpc512x_init_diu()
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx7-colibri-aster.dtsi | 6 /* Colibri AD0 to AD3 */
|
| H A D | imx7-colibri-iris.dtsi | 6 /* Colibri AD0 to AD3 */
|
| H A D | imx7-colibri-iris-v2.dtsi | 18 /* Colibri AD0 to AD3 */
|
| H A D | imx7-colibri-eval-v3.dtsi | 15 /* Colibri AD0 to AD3 */
|
| /openbmc/linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | marvell,armada-98dx3236-pinctrl.txt | 35 mpp21 21 gpo, dev(ad0)
|
| H A D | marvell,armada-375-pinctrl.txt | 22 mpp6 6 gpio, dev(ad0), led(p1), audio(lrclk)
|
| H A D | marvell,armada-370-pinctrl.txt | 60 mpp39 39 gpo, dev(ad0), audio(spdifo)
|
| H A D | marvell,armada-38x-pinctrl.txt | 40 mpp22 22 gpio, spi0(mosi), dev(ad0)
|
| H A D | marvell,armada-39x-pinctrl.txt | 41 mpp22 22 gpio, spi0(mosi), dev(ad0)
|
| /openbmc/linux/sound/pci/oxygen/ |
| H A D | xonar_cs43xx.c | 57 #define I2C_DEVICE_CS4398 0x9e /* 10011, AD1=1, AD0=1, /W=0 */
58 #define I2C_DEVICE_CS4362A 0x30 /* 001100, AD0=0, /W=0 */
|
| /openbmc/u-boot/board/silica/pengwyn/ |
| H A D | mux.c | 67 {OFFSET(gpmc_ad0), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD0 */
|
| /openbmc/u-boot/board/isee/igep003x/ |
| H A D | mux.c | 40 {OFFSET(gpmc_ad0), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD0 */
|
| /openbmc/u-boot/arch/arm/mach-omap2/am33xx/ |
| H A D | chilisom.c | 37 {OFFSET(gpmc_ad0), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD0 */
|
| /openbmc/u-boot/board/phytec/pcm051/ |
| H A D | mux.c | 87 {OFFSET(gpmc_ad0), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD0 */
|
| /openbmc/u-boot/board/compulab/cm_t335/ |
| H A D | mux.c | 73 {OFFSET(gpmc_ad0), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD0 */
|
| /openbmc/u-boot/board/vscom/baltos/ |
| H A D | mux.c | 80 {OFFSET(gpmc_ad0), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD0 */
|
| /openbmc/u-boot/board/ti/am43xx/ |
| H A D | mux.c | 78 {OFFSET(gpmc_ad0), (MODE(0) | PULLUDDIS | RXACTIVE)}, /* AD0 */
|
| /openbmc/linux/drivers/net/ethernet/sunplus/ |
| H A D | spl2sw_define.h | 63 /* Wt mac ad0 */
|
| /openbmc/u-boot/board/siemens/pxm2/ |
| H A D | mux.c | 31 {OFFSET(gpmc_ad0), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD0 */
|