1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * (C) Copyright 2002 4 * Daniel Engström, Omicron Ceti AB, daniel@omicron.se. 5 */ 6 7 /* i8254.h Intel 8254 PIT registers */ 8 9 #ifndef _ASMI386_I8254_H_ 10 #define _ASMI386_I8954_H_ 11 12 #define PIT_T0 0x00 /* PIT channel 0 count/status */ 13 #define PIT_T1 0x01 /* PIT channel 1 count/status */ 14 #define PIT_T2 0x02 /* PIT channel 2 count/status */ 15 #define PIT_COMMAND 0x03 /* PIT mode control, latch and read back */ 16 17 /* PIT Command Register Bit Definitions */ 18 19 #define PIT_CMD_CTR0 0x00 /* Select PIT counter 0 */ 20 #define PIT_CMD_CTR1 0x40 /* Select PIT counter 1 */ 21 #define PIT_CMD_CTR2 0x80 /* Select PIT counter 2 */ 22 23 #define PIT_CMD_LATCH 0x00 /* Counter Latch Command */ 24 #define PIT_CMD_LOW 0x10 /* Access counter bits 7-0 */ 25 #define PIT_CMD_HIGH 0x20 /* Access counter bits 15-8 */ 26 #define PIT_CMD_BOTH 0x30 /* Access counter bits 15-0 in two accesses */ 27 28 #define PIT_CMD_MODE0 0x00 /* Select mode 0 */ 29 #define PIT_CMD_MODE1 0x02 /* Select mode 1 */ 30 #define PIT_CMD_MODE2 0x04 /* Select mode 2 */ 31 #define PIT_CMD_MODE3 0x06 /* Select mode 3 */ 32 #define PIT_CMD_MODE4 0x08 /* Select mode 4 */ 33 #define PIT_CMD_MODE5 0x0a /* Select mode 5 */ 34 35 /* The clock frequency of the i8253/i8254 PIT */ 36 #define PIT_TICK_RATE 1193182 37 38 /** 39 * i8254_enable_beep() - Start a beep using the PCAT timer 40 * 41 * This starts beeping using the legacy i8254 timer. The beep may be silenced 42 * after a delay with i8254_disable_beep(). 43 * 44 * @frequency_hz: Frequency of beep in Hz 45 * @return 0 if OK, -EINVAL if frequency_hz is 0 46 */ 47 int i8254_enable_beep(uint frequency_hz); 48 49 /** 50 * i8254_disable_beep() - Disable the bepper 51 * 52 * This stops any existing beep 53 */ 54 void i8254_disable_beep(void); 55 56 #endif /* _ASMI386_I8954_H_ */ 57