Lines Matching refs:t
154 /doc Documentation (don't expect too much)
182 you don't know what you're doing; they have names beginning with
270 - must return normally from this function (don't call board_init_r()
918 The driver doen't show link status messages.
955 control registers. This behavior won't affect the
1071 or directly in usbd_vendor_info.h. If you don't define
1228 It isn't 16x9, and I am not sure what it is.
1436 aren't in use before handing them out (usually using an ARP
1480 This fixes a problem with certain DHCP servers that don't
1492 for an address that doesn't require explicit configuration.
1717 define this, if you don't use i2c muxes on your hardware.
2136 If tftpsrcp isn't defined, the normal pseudo-random port
2140 the TFTP UDP destination port value. If tftpdstp isn't
2269 -101 common/cmd_bootm.c Can't get configuration for kernel subimage
2271 -103 common/cmd_bootm.c Can't get kernel subimage node offset
2280 -107 common/cmd_bootm.c Can't get kernel subimage data/size
2283 -109 common/cmd_bootm.c Can't get kernel subimage type
2284 -110 common/cmd_bootm.c Can't get kernel subimage comp
2285 -111 common/cmd_bootm.c Can't get kernel subimage os
2286 -112 common/cmd_bootm.c Can't get kernel subimage load address
2293 -122 common/image.c Can't get configuration for ramdisk subimage
2295 -124 common/image.c Can't get ramdisk subimage node offset
2301 -127 common/image.c Can't get ramdisk subimage data/size
2303 129 common/image.c Can't get ramdisk load address
2672 You only need to set this if address zero isn't writeable
2677 is substracted from total RAM and won't be reported to OS.
2686 (end) of RAM and won't get "touched" at all by U-Boot. By
2688 the now "corrected" memory size and won't touch it either.
2695 CHIP 11 errata where the last 256 bytes in SDRAM shouldn't
2852 If this option is defined, the common CFI flash doesn't
2931 If defined, don't allow the -f switch to env set override variable
2973 "baudrate" setting for the console - if we have a bad CRC, we don't
3141 Don't do any setup work, presumably because someone or
3142 something has already done it, and we don't need to do it
3215 Note that this is a global option, we can't
3568 environment. As long as you don't save the environment you are
3773 *Note* - these variables don't have to be defined for all boards, some
4011 be run with the same "initrd". This makes testing easier (you don't
4025 (no, we don't intend to provide a full virtual machine interface to
4553 Native builds *don't* work due to incompatibilities between native
4578 This means that we don't have writable Data or BSS segments, and BSS
4607 board designers haven't used it for something that would
4611 CONFIG_SYS_INIT_RAM_ADDR should be somewhere that won't interfere
4694 Note: on Nios II, we give "-G0" option to gcc and don't use gp
4942 * When you add support for a new board, don't forget to add a
4945 * If your patch adds new configuration options, don't forget to