Lines Matching full:default
152 /configs Board default configuration files
195 For all supported boards there are ready-to-use default
203 Note: If you're looking for the default configuration file for a board
570 default environment.
769 specify the timeout in seconds. default 2 seconds.
867 Default is 32bit.
1151 Default is 4 MiB if undefined.
1165 Define these for a default partition on a NAND device
1169 Define these for a default partition on a NOR device
1345 Enabled by default to support gzip compressed images.
1377 Define a default value for the IP address to use for
1378 the default Ethernet interface, in case this is not
1385 Defines a default value for the IP address of a TFTP
1397 Defines a default value for the IP address of the
1398 default router where packets to other networks are
1405 Defines a default value for the subnet mask (or
1444 cache. The default is to keep IDs for up to four outstanding
1635 If those defines are not set, default value is 100000
1879 data. If this define is omitted the default behaviour
1902 default: (CONFIG_SYS_HZ/100) /* 10 ms */
1952 FPGA configuration sequence. The default time is 500
1958 Virtex II FPGA configuration. The default is 5 ms.
1962 Time to wait after FPGA configuration. The default is
1989 default env _and_ CONFIG_OVERWRITE_ETHADDR_ONCE, a default
2007 this default value by defining an environment
2047 default value of 5 is used.
2096 - Default Environment:
2101 the default environment compiled into the boot image.
2117 Note: overly (ab)use of the default environment is
2247 -60 common/env_common.c Environment has a bad CRC, using default
2320 overwriting the architecture dependent default
2353 The default value should be OK for SLC NAND flashes, NOR flashes and
2359 default: 4096
2383 default: 20
2401 default: 0
2405 default: 0
2582 the SPL payload. By default, this is defined as
2604 the TPL payload. By default, this is defined as
2647 - CONFIG_SYS_HELP_CMD_WIDTH: Defined when you want to override the default
2882 internally to store the environment settings. The default
2902 s - String (default)
2910 a - Any (default)
2913 c - Change-default
2917 environment variable in the default or embedded environment.
2971 with the compiled-in default environment - *silently*!!! [This is
2977 the default environment is used; a new CRC is computed as soon as you
3018 Default (power-on reset) physical address of CCSR on Freescale
3054 the default drive number (default value 0)
3059 (default value 1)
3065 the FDC chipset. (default value 0)
3069 default value.
3180 a default value will be used.
3432 By default the build is performed locally and the objects are saved
3515 diskboot- boot from IDE devicebootd - boot default, i.e., run 'bootcmd'
3570 environment is erased by accident, a default environment is provided.
3600 as the default value if it is defined, and bootm_size is
3687 loadaddr - Default load address for commands like "bootp",
3737 we use the TFTP server's default block size
3742 be retransmitted. The default is 5000 = 5 seconds.
3750 transfer is aborted. The default is 10, and 0 means
3761 be either the default (28000), or a value based on
3848 ".callbacks" environment variable in the default or embedded environment.
3920 in SROM), this is used as default address if there is NO correspon-
4612 with your processor/board/system design. The default value