Merge tag 'for-master-20190201' of git://git.denx.de/u-boot-rockchip

u-boot-rockchip changes for 2019.04-rc1:
* support for Chromebook Bob
* full pinctrl driver using DTS properties
* document

Merge tag 'for-master-20190201' of git://git.denx.de/u-boot-rockchip

u-boot-rockchip changes for 2019.04-rc1:
* support for Chromebook Bob
* full pinctrl driver using DTS properties
* documentation improvements
* I2S support for some Rockchip SoCs

show more ...

pinctrl: rockchip: Add common rockchip pinctrl driver

Use this driver to fit all Rockchip SOCs and to support
the desired pinctrl configuration via DTS.

Signed-off-by: David Wu <david.wu@rock-chips

pinctrl: rockchip: Add common rockchip pinctrl driver

Use this driver to fit all Rockchip SOCs and to support
the desired pinctrl configuration via DTS.

Signed-off-by: David Wu <david.wu@rock-chips.com>
Acked-by: Heiko Stuebner <heiko@sntech.de>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
Reviewed-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>

show more ...

Merge tag 'mips-updates-for-2019.11' of git://git.denx.de/u-boot-mips

- mips: fix some DTC warnings
- bmips: bcm6348: add DMA driver
- bmips: bcm5348: add ethernet driver
- bmips: bcm6368: add ether

Merge tag 'mips-updates-for-2019.11' of git://git.denx.de/u-boot-mips

- mips: fix some DTC warnings
- bmips: bcm6348: add DMA driver
- bmips: bcm5348: add ethernet driver
- bmips: bcm6368: add ethernet driver
- mips: mt76xx: fix DMA problems, disable CONFIG_OF_EMBED
- mips: mscc: add support for Microsemi Ocelot and Luton SoCs
- mips: mscc: add support for Ocelot and Luton evaluation boards
- mips: jz47xx: add basic support for Ingenic JZ4780 SoC
- mips: jz47xx: add support for Imgtec Creator CI20 board

show more ...

pinctrl: mscc: Add gpio and pinctrl driver for MSCC MIPS SoCs (VcoreIII based)

This driver supports the pin and gpio controller found in the Ocelot and
Luton SoCs.

The driver was inspired from the

pinctrl: mscc: Add gpio and pinctrl driver for MSCC MIPS SoCs (VcoreIII based)

This driver supports the pin and gpio controller found in the Ocelot and
Luton SoCs.

The driver was inspired from the pinctrl driver in Linux, but was
simplified and was modified to allow supporting an other SoCs (Luton).

For Ocelot and Luton the controller is the same, only the pins to program
differ.

Signed-off-by: Gregory CLEMENT <gregory.clement@bootlin.com>
Reviewed-by: Daniel Schwierzeck <daniel.schwierzeck@gmail.com>
[changed to only descend into mscc/ dependent on CONFIG_PINCTRL_MSCC]
Signed-off-by: Daniel Schwierzeck <daniel.schwierzeck@gmail.com>

show more ...

Merge branch '2018-11-28-master-imports'

- Add MediaTek support

pinctrl: MediaTek: add pinctrl driver for MT7629 SoC

This patch adds pinctrl support for MT7629 SoC. The IO core found on
the SoC has the registers for pinctrl, pinconf and gpio mixed up in
the same

pinctrl: MediaTek: add pinctrl driver for MT7629 SoC

This patch adds pinctrl support for MT7629 SoC. The IO core found on
the SoC has the registers for pinctrl, pinconf and gpio mixed up in
the same register range. Hence the driver also implements the gpio
functionality through UCLASS_GPIO.

This also creates a common file as there might be other chips that use
the same binding and driver, then being a little more abstract could
help in the long run.

Signed-off-by: Ryder Lee <ryder.lee@mediatek.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

SPDX: Convert all of our single license tags to Linux Kernel style

When U-Boot started using SPDX tags we were among the early adopters and
there weren't a lot of other examples to borrow from. So

SPDX: Convert all of our single license tags to Linux Kernel style

When U-Boot started using SPDX tags we were among the early adopters and
there weren't a lot of other examples to borrow from. So we picked the
area of the file that usually had a full license text and replaced it
with an appropriate SPDX-License-Identifier: entry. Since then, the
Linux Kernel has adopted SPDX tags and they place it as the very first
line in a file (except where shebangs are used, then it's second line)
and with slightly different comment styles than us.

In part due to community overlap, in part due to better tag visibility
and in part for other minor reasons, switch over to that style.

This commit changes all instances where we have a single declared
license in the tag as both the before and after are identical in tag
contents. There's also a few places where I found we did not have a tag
and have introduced one.

Signed-off-by: Tom Rini <trini@konsulko.com>

show more ...

bcm283x: Add pinctrl driver

The bcm283x family of SoCs have a GPIO controller that also acts as
pinctrl controller.

This patch introduces a new pinctrl driver that can actually properly mux
devices

bcm283x: Add pinctrl driver

The bcm283x family of SoCs have a GPIO controller that also acts as
pinctrl controller.

This patch introduces a new pinctrl driver that can actually properly mux
devices into their device tree defined pin states and is now the primary
owner of the gpio device. The previous GPIO driver gets moved into a
subdevice of the pinctrl driver, bound to the same OF node.

That way whenever a device asks for pinctrl support, it gets it
automatically from the pinctrl driver and GPIO support is still available
in the normal command line phase.

Signed-off-by: Alexander Graf <agraf@suse.de>

show more ...

Merge branch 'rmobile' of git://git.denx.de/u-boot-sh

pinctrl: rmobile: Add Renesas RCar pincontrol driver

Add PFC pincontrol driver for the Renesas RCar Gen3 R8A7795 and R8A7796
SoCs. This driver uses the PFC pin tables from Linux, thus letting us
sha

pinctrl: rmobile: Add Renesas RCar pincontrol driver

Add PFC pincontrol driver for the Renesas RCar Gen3 R8A7795 and R8A7796
SoCs. This driver uses the PFC pin tables from Linux, thus letting us
share the occassional fixes to those tables. This driver also has a DT
support, so the pinmux is configured from DT instead of the ad-hoc setup
in board file.

This driver is meant to replace the pinmux part of SH_GPIO_PFC driver.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>

show more ...

Merge git://www.denx.de/git/u-boot-marvell

Mostly including the Armada 37xx pinctrl / gpio driver.

pinctrl: mvebu: Enable support for the Armada 37xx pinctrl driver

To enable support for the Armada 37xx pinctrl driver, we need to
change the Kconfig symbol for the Armada 7k/8k pinctrl driver and i

pinctrl: mvebu: Enable support for the Armada 37xx pinctrl driver

To enable support for the Armada 37xx pinctrl driver, we need to
change the Kconfig symbol for the Armada 7k/8k pinctrl driver and its
dependencies to distinguish between both platforms and drivers.

Signed-off-by: Stefan Roese <sr@denx.de>
Cc: Konstantin Porotchkin <kostap@marvell.com>
Cc: Nadav Haklai <nadavh@marvell.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot

Signed-off-by: Stefano Babic <sbabic@denx.de>

aspeed: AST2500 Pinctrl Driver

This driver uses Generic Pinctrl framework and is compatible with
the Linux driver for ast2500: it uses the same device tree
configuration.

Not all pins are supported

aspeed: AST2500 Pinctrl Driver

This driver uses Generic Pinctrl framework and is compatible with
the Linux driver for ast2500: it uses the same device tree
configuration.

Not all pins are supported by the driver at the moment, so it actually
compatible with ast2400. In general, however, there are differences that
in the future would be easier to maintain separately.

Signed-off-by: Maxim Sloyko <maxims@google.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

pinctrl: Kconfig: sort pinctrl config options to prevent future clutter

This originally started out as
"pinctrl: Kconfig: reorder to keep Rockchip options together"
and tried to keep the Rockch

pinctrl: Kconfig: sort pinctrl config options to prevent future clutter

This originally started out as
"pinctrl: Kconfig: reorder to keep Rockchip options together"
and tried to keep the Rockchip-related config options together.

However, we now rewrite all chip-specific driver selections to start
with CONFIG_PINCTRL_ (with the inadvertent changes to related
Makefiles) and sort those alphabetically. And as this already means
touching most of the file, we also reformat the help text to not exceed
80 characters (but make full use of those 80 characters).

Signed-off-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
Acked-by: Simon Glass <sjg@chromium.org>

show more ...

Merge git://git.denx.de/u-boot-dm

Here with some DM changes as well as the long-standing AT91 DM/DT
conversion patches which I have picked up via dm.

pinctrl: at91: add pinctrl driver

AT91 PIO controller is a combined gpio-controller, pin-mux and
pin-config module. The peripheral's pins are assigned through
per-pin based muxing logic.

Each SoC w

pinctrl: at91: add pinctrl driver

AT91 PIO controller is a combined gpio-controller, pin-mux and
pin-config module. The peripheral's pins are assigned through
per-pin based muxing logic.

Each SoC will have to describe the its limitation and pin
configuration via device tree. This will allow to do not need
to touch the C code when adding new SoC if the IP version is
supported.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

Merge git://git.denx.de/u-boot-dm

Add single register pin controller driver

This patch adds a pin controller driver supporting devices
using a single configuration register per pin.
Signed-off-by: Felix Brack <fb@ltec.ch>

PINCTRL: stm32f7: add pin control driver

This driver uses the same pin control binding as that of linux, binding
document of this patch is copied from linux. One addition done is for
GPIO input and

PINCTRL: stm32f7: add pin control driver

This driver uses the same pin control binding as that of linux, binding
document of this patch is copied from linux. One addition done is for
GPIO input and output mode configuration which was missing.

Signed-off-by: Vikas Manocha <vikas.manocha@st.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

STiH410: Add STi pinctrl driver

Add STMicroelectronics STiH410 pinctrl driver

Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Reviewed-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Simon G

STiH410: Add STi pinctrl driver

Add STMicroelectronics STiH410 pinctrl driver

Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Reviewed-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot

Merge git://www.denx.de/git/u-boot-marvell

arm64: mvebu: pinctrl: Add pin control driver for A8K family

Add a DM port of Marvell pin control driver.
The A8K SoC family contains several silicone dies interconnected
in a single package. Every

arm64: mvebu: pinctrl: Add pin control driver for A8K family

Add a DM port of Marvell pin control driver.
The A8K SoC family contains several silicone dies interconnected
in a single package. Every die is normally equipped with its own
pin controller unit.
There are 2 pin controllers in A70x0 SoC and 3 in A80x0 SoC.

Signed-off-by: Konstantin Porotchkin <kostap@marvell.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
Cc: Simon Glass <sjg@chromium.org>
Cc: Stefan Roese <sr@denx.de>
Cc: Nadav Haklai <nadavh@marvell.com>
Cc: Neta Zur Hershkovits <neta@marvell.com>
Cc: Omri Itach <omrii@marvell.com>
Cc: Igal Liberman <igall@marvell.com>
Cc: Haim Boot <hayim@marvell.com>
Cc: Hanna Hawa <hannah@marvell.com>
Signed-off-by: Stefan Roese <sr@denx.de>

show more ...

pinctrl: add driver for meson-gxbb pin controller

Add a pin controller driver for Meson GXBB adapted from Linux kernel.

Signed-off-by: Beniamino Galvani <b.galvani@gmail.com>
Reviewed-by: Simon Gla

pinctrl: add driver for meson-gxbb pin controller

Add a pin controller driver for Meson GXBB adapted from Linux kernel.

Signed-off-by: Beniamino Galvani <b.galvani@gmail.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...