|
Revision tags: v00.04.15, v00.04.14, v00.04.13, v00.04.12, v00.04.11, v00.04.10, v00.04.09, v00.04.08, v00.04.07, v00.04.06, v00.04.05, v00.04.04, v00.04.03, v00.04.02, v00.04.01, v00.04.00, v2021.04, v00.03.03, v2021.01, v2020.10, v2020.07, v00.02.13, v2020.04, v2020.01, v2019.10, v00.02.05, v00.02.04, v00.02.03, v00.02.02, v00.02.01, v2019.07, v00.02.00, v2019.04, v2018.07 |
|
| #
ca70cbab |
| 14-May-2018 |
Tom Rini <trini@konsulko.com> |
Merge git://git.denx.de/u-boot-marvell
|
| #
82a248df |
| 24-Apr-2018 |
Marek Behún <marek.behun@nic.cz> |
driver: clk: Add support for clocks on Armada 37xx
The drivers are based on Linux driver by Gregory Clement.
The TBG clocks support only the .get_rate method.
- since setting rate is not supporte
driver: clk: Add support for clocks on Armada 37xx
The drivers are based on Linux driver by Gregory Clement.
The TBG clocks support only the .get_rate method.
- since setting rate is not supported, the driver computes the rates
when probing and so subsequent calls to the .get_rate method do not
read the corresponding registers again
The peripheral clocks support methods .get_rate, .enable and .disable.
- the .set_parent method theoretically could be supported on some clocks
(the parent would have to be one of the TBG clocks)
- the .set_rate method would have to try all the divider values to find
the best approximation of a given rate, and it doesn't seem like
this should be needed in U-Boot, therefore not implemented
Signed-off-by: Marek Behun <marek.behun@nic.cz>
Reviewed-by: Stefan Roese <sr@denx.de>
Signed-off-by: Stefan Roese <sr@denx.de>
show more ...
|