History log of /openbmc/u-boot/board/freescale/mx6sllevk/Kconfig (Results 1 – 2 of 2)
Revision (<<< Hide revision tags) (Show revision tags >>>) Date Author Comments
Revision tags: v00.04.15, v00.04.14, v00.04.13, v00.04.12, v00.04.11, v00.04.10, v00.04.09, v00.04.08, v00.04.07, v00.04.06, v00.04.05, v00.04.04, v00.04.03, v00.04.02, v00.04.01, v00.04.00, v2021.04, v00.03.03, v2021.01, v2020.10, v2020.07, v00.02.13, v2020.04, v2020.01, v2019.10, v00.02.05, v00.02.04, v00.02.03, v00.02.02, v00.02.01, v2019.07, v00.02.00, v2019.04, v2018.07, v2018.03, v2018.01, v2017.11
# 8ea05705 18-Dec-2016 Tom Rini <trini@konsulko.com>

Merge branch 'master' of git://www.denx.de/git/u-boot-imx

Migrate CONFIG_ARCH_USE_MEMSET/MEMCPY with this merge.

Signed-off-by: Tom Rini <trini@konsulko.com>


# 47f73504 11-Dec-2016 Peng Fan <peng.fan@nxp.com>

arm: imx: add i.MX6SLL EVK board support

Add i.MX6SLL EVK board support.
1. Add imx6sll-evk device tree.
2. Enable SDHC/I2C/UART.
3. Enable REGULATOR/PMIC/I2C/GPIO/SDHC/PINCTRL driver.

Boot Log:
U-

arm: imx: add i.MX6SLL EVK board support

Add i.MX6SLL EVK board support.
1. Add imx6sll-evk device tree.
2. Enable SDHC/I2C/UART.
3. Enable REGULATOR/PMIC/I2C/GPIO/SDHC/PINCTRL driver.

Boot Log:
U-Boot 2016.11-00127-gc635871-dirty (Nov 24 2016 - 13:28:19 +0800)

CPU: Freescale i.MX6SLL rev1.0 at 792MHz
CPU: Commercial temperature grade (0C to 95C)Reset cause: POR
Model: Freescale i.MX6SLL EVK Board
Board: MX6SLL EVK
DRAM: 2 GiB
i2c bus 0 at 35258368, no gpio pinctrl state.
PMIC: PFUZE100! DEV_ID=0x10 REV_ID=0x21
MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
In: serial
Out: serial
Err: serial
Net: CPU Net Initialization Failed
No ethernet found.
Hit any key to stop autoboot: 0

Signed-off-by: Peng Fan <peng.fan@nxp.com>
Cc: Stefano Babic <sbabic@denx.de>

show more ...