| #
1d12a7c8 |
| 26-Jan-2018 |
Tom Rini <trini@konsulko.com> |
Merge git://git.denx.de/u-boot-spi
|
| #
086ebcd4 |
| 17-Jan-2018 |
Tom Rini <trini@konsulko.com> |
Merge git://git.denx.de/u-boot-fsl-qoriq
|
| #
fdb6c323 |
| 15-Jan-2018 |
Tom Rini <trini@konsulko.com> |
Merge git://git.denx.de/u-boot-net
|
| #
8e9801c2 |
| 15-Jan-2018 |
Tom Rini <trini@konsulko.com> |
Merge git://git.denx.de/u-boot-imx
|
| #
db00e921 |
| 03-Jan-2018 |
Fabio Estevam <fabio.estevam@nxp.com> |
mx6memcal: Fix the UART ports for mx6sabresd/auto boards
mx6sabresd board uses the following pins for console:
PAD_CSI0_DAT10__UART1_TX_DATA
PAD_CSI0_DAT11__UART1_RX_DATA
mx6memcal: Fix the UART ports for mx6sabresd/auto boards
mx6sabresd board uses the following pins for console:
PAD_CSI0_DAT10__UART1_TX_DATA
PAD_CSI0_DAT11__UART1_RX_DATA
,so put it in the same config option as wandboard.
mx6sabreauto board uses the following pins for console:
PAD_KEY_COL0__UART4_TX_DATA
PAD_KEY_ROW0__UART4_RX_DATA
So do not mention sabreauto board as part of the UART1_SD3_DAT6_7 option.
The config option for sabreauto can be added later when needed.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
show more ...
|
| #
2f4c9de3 |
| 08-Jan-2018 |
Tom Rini <trini@konsulko.com> |
Merge git://git.denx.de/u-boot-imx
|
| #
baefb63a |
| 11-Dec-2017 |
Eric Nelson <eric@nelint.com> |
mx6: Add board mx6memcal for use in validating DDR
This is a virtual "board" that uses configuration files and
Kconfig to define the memory layout used by a real board during
the boa
mx6: Add board mx6memcal for use in validating DDR
This is a virtual "board" that uses configuration files and
Kconfig to define the memory layout used by a real board during
the board bring-up process.
It generates an SPL image that can be loaded using imx_usb or
SB_LOADER.exe.
When run, it will generate a set of calibration constants for
use in either or both a DCD configuration file for boards that
use u-boot.imx or struct mx6_mmdc_calibration for boards that
boot via SPL.
In essence, it is a configurable, open-source variant of the
Freescale ddr-stress tool.
https://community.nxp.com/docs/DOC-105652
File mx6memcal_defconfig configures the board for use with
mx6sabresd or mx6qsabreauto.
Signed-off-by: Eric Nelson <eric@nelint.com>
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
show more ...
|