Merge git://git.denx.de/u-boot-sunxi

SPDX: Convert all of our single license tags to Linux Kernel style

When U-Boot started using SPDX tags we were among the early adopters and
there weren't a lot of other examples to borro

SPDX: Convert all of our single license tags to Linux Kernel style

When U-Boot started using SPDX tags we were among the early adopters and
there weren't a lot of other examples to borrow from. So we picked the
area of the file that usually had a full license text and replaced it
with an appropriate SPDX-License-Identifier: entry. Since then, the
Linux Kernel has adopted SPDX tags and they place it as the very first
line in a file (except where shebangs are used, then it's second line)
and with slightly different comment styles than us.

In part due to community overlap, in part due to better tag visibility
and in part for other minor reasons, switch over to that style.

This commit changes all instances where we have a single declared
license in the tag as both the before and after are identical in tag
contents. There's also a few places where I found we did not have a tag
and have introduced one.

Signed-off-by: Tom Rini <trini@konsulko.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-atmel

arm: at91/spl: mpddrc: use IP version to check configuration

To remove the unnecessary #ifdef-endif, use the mpddrc IP version
to check whether or not the interleaved decoding type is su

arm: at91/spl: mpddrc: use IP version to check configuration

To remove the unnecessary #ifdef-endif, use the mpddrc IP version
to check whether or not the interleaved decoding type is supported.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

arm: at91/spl: mpddrc: add mpddrc DDR3-SDRAM initialization

The DDR3-SDRAM initialization sequence is implemented in
accordance with the DDR3-SRAM/DDR3L-SDRAM initialization section

arm: at91/spl: mpddrc: add mpddrc DDR3-SDRAM initialization

The DDR3-SDRAM initialization sequence is implemented in
accordance with the DDR3-SRAM/DDR3L-SDRAM initialization section
described in the SAMA5D2 datasheet.

Add registers and definitions of mpddrc controller, which is used
to support DDR3 devices.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

arm: at91/spl: mpddrc: add struct atmel_mpddrc_config

Add struct atmel_mpddrc_config to accommodate the mpddrc register
configurations, not using the mpddrc register map structure,
s

arm: at91/spl: mpddrc: add struct atmel_mpddrc_config

Add struct atmel_mpddrc_config to accommodate the mpddrc register
configurations, not using the mpddrc register map structure,
struct atmel_mpddrc, in order to increase readability and reduce
run-time memory use.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-video

Merge branch 'master' of git://git.denx.de/u-boot-mips

Merge git://git.denx.de/u-boot-socfpga

Conflicts:
configs/socfpga_arria5_defconfig
configs/socfpga_cyclone5_defconfig
configs/socfpga_socrates_defconfig

Merge git://git.denx.de/u-boot-socfpga

Conflicts:
configs/socfpga_arria5_defconfig
configs/socfpga_cyclone5_defconfig
configs/socfpga_socrates_defconfig

Merged these by hand and re-ran savedefconfig on them.

Signed-off-by: Tom Rini <trini@konsulko.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-net

arm: at91: mpddr: allow multiple DDR controllers

The mpddr.c depends on ATMEL_BASE_MPDDRC for the base address to configure the controller.
This cannot be used when there is more than on

arm: at91: mpddr: allow multiple DDR controllers

The mpddr.c depends on ATMEL_BASE_MPDDRC for the base address to configure the controller.
This cannot be used when there is more than one controller (i.e. AT91SAM9G45, AT91SAM9M10).

Signed-off-by: Erik van Luijk <evanluijk@interact.nl>
[remove 'new blank line at EOF']
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

Merge branch 'master' of git://www.denx.de/git/u-boot-imx

Merge branch 'u-boot/master'

Merge branch 'master' of git://git.denx.de/u-boot-tegra

Conflicts:
board/armltd/vexpress64/vexpress64.c

Signed-off-by: Tom Rini <trini@konsulko.com>

Merge branch 'master' of git://git.denx.de/u-boot-atmel

ARM: atmel: at91sam9n12ek: enable spl support

Enable SPL support for at91sam9n12ek boards, now it supports
boot up from NAND flash, serial flash.

Signed-off-by: Bo Shen <voice.s

ARM: atmel: at91sam9n12ek: enable spl support

Enable SPL support for at91sam9n12ek boards, now it supports
boot up from NAND flash, serial flash.

Signed-off-by: Bo Shen <voice.shen@atmel.com>

show more ...

ARM: atmel: at91sam9x5ek: enable spl support

Enable SPL support for at91sam9x5ek board. Now, it supports
boot up from NAND flash and SPI flash.

Signed-off-by: Bo Shen <voice.she

ARM: atmel: at91sam9x5ek: enable spl support

Enable SPL support for at91sam9x5ek board. Now, it supports
boot up from NAND flash and SPI flash.

Signed-off-by: Bo Shen <voice.shen@atmel.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot

Merge remote-tracking branch 'u-boot/master' into 'u-boot-arm/master'

Merge git://git.denx.de/u-boot-sunxi

ARM: at91: collect SoC sources into mach-at91

This commit moves source files as follows:

arch/arm/cpu/arm920t/at91/* -> arch/arm/mach-at91/arm920t/*
arch/arm/cpu/arm926ejs

ARM: at91: collect SoC sources into mach-at91

This commit moves source files as follows:

arch/arm/cpu/arm920t/at91/* -> arch/arm/mach-at91/arm920t/*
arch/arm/cpu/arm926ejs/at91/* -> arch/arm/mach-at91/arm926ejs/*
arch/arm/cpu/armv7/at91/* -> arch/arm/mach-at91/armv7/*
arch/arm/cpu/at91-common/* -> arch/arm/mach-at91/*

Signed-off-by: Masahiro Yamada <yamada.m@jp.panasonic.com>
Acked-by: Andreas Bießmann <andreas.devel@googlemail.co>

show more ...