| #
54777961 |
| 20-Jun-2024 |
Pavithra Barithaya <pavithrabarithaya07@gmail.com> |
use fs.copyfile instead of deprecated copy
copy arg in configure_file API is deprecated since meson
version 0.64.0. As we moved to meson version 1.1.1 we can
leverage the filesystem module copyfile(
use fs.copyfile instead of deprecated copy
copy arg in configure_file API is deprecated since meson
version 0.64.0. As we moved to meson version 1.1.1 we can
leverage the filesystem module copyfile() to achieve the
same result.
Tested by: Built the repo without any warning.
Change-Id: Ib4f44b535f8912ba53dcb5911a43569f2edbb8ef
Signed-off-by: Pavithra Barithaya <pavithrabarithaya07@gmail.com>
show more ...
|
| #
ba2241c6 |
| 26-Oct-2021 |
Thang Tran <thuutran@amperecomputing.com> |
Support checking host status via GPIO pins
Currently, openBmc supports checking host status via ipmi and PLDM
method. However, not all of platforms support IPMI and PLDM. Some
platforms, like Ampere
Support checking host status via GPIO pins
Currently, openBmc supports checking host status via ipmi and PLDM
method. However, not all of platforms support IPMI and PLDM. Some
platforms, like Ampere Mt.Jade checks input GPIO to detect Host
firmware boot status. This commit supports Dbus method to check host
status via GPIO pins, it checks the value of "host0-ready/-n" pin to
detect HOST is ready or not.
Tested:
1. Update GPIO pin to detect host0 ready to "host0-ready"
in the device tree.
2. Enable host-gpios option and add executable and service
files to openBmc software then flash to the board.
3. In the BMC console, check host-gpio-condition via command
"busctl tree xyz.openbmc_project.State.HostCondition.Gpio"
Result as below:
`-/xyz
`-/xyz/openbmc_project
`-/xyz/openbmc_project/Gpios
`-/xyz/openbmc_project/Gpios/host0
4. Turn on/off the HOST0 then check the host status via
command
"busctl get-property \
xyz.openbmc_project.State.HostCondition.Gpio \
/xyz/openbmc_project/Gpios/host0 \
xyz.openbmc_project.Condition.HostFirmware \
CurrentFirmwareCondition"
Result as below:
"xyz.openbmc_project.Condition.HostFirmware.\
FirmwareCondition.<Running/Off>"
Signed-off-by: Thang Tran <thuutran@amperecomputing.com>
Change-Id: I20e38e76c5b70119f0c86e5b497d47453d7c5a6c
show more ...
|