KVM: x86: Use emulator callbacks instead of duplicating "host flags"

Instead of re-defining the "host flags" bits, just expose dedicated
helpers for each of the two remaining flags that are consumed

KVM: x86: Use emulator callbacks instead of duplicating "host flags"

Instead of re-defining the "host flags" bits, just expose dedicated
helpers for each of the two remaining flags that are consumed by the
emulator. The emulator never consumes both "is guest" and "is SMM" in
close proximity, so there is no motivation to avoid additional indirect
branches.

Also while at it, garbage collect the recently removed host flags.

No functional change is intended.

Signed-off-by: Maxim Levitsky <mlevitsk@redhat.com>
Tested-by: Santosh Shukla <Santosh.Shukla@amd.com>
Link: https://lore.kernel.org/r/20221129193717.513824-6-mlevitsk@redhat.com
[sean: fix CONFIG_KVM_SMM=n builds, tweak names of wrappers]
Signed-off-by: Sean Christopherson <seanjc@google.com>

show more ...

KVM: x86: Unify pr_fmt to use module name for all KVM modules

Define pr_fmt using KBUILD_MODNAME for all KVM x86 code so that printks
use consistent formatting across common x86, Intel, and AMD code

KVM: x86: Unify pr_fmt to use module name for all KVM modules

Define pr_fmt using KBUILD_MODNAME for all KVM x86 code so that printks
use consistent formatting across common x86, Intel, and AMD code. In
addition to providing consistent print formatting, using KBUILD_MODNAME,
e.g. kvm_amd and kvm_intel, allows referencing SVM and VMX (and SEV and
SGX and ...) as technologies without generating weird messages, and
without causing naming conflicts with other kernel code, e.g. "SEV: ",
"tdx: ", "sgx: " etc.. are all used by the kernel for non-KVM subsystems.

Opportunistically move away from printk() for prints that need to be
modified anyways, e.g. to drop a manual "kvm: " prefix.

Opportunistically convert a few SGX WARNs that are similarly modified to
WARN_ONCE; in the very unlikely event that the WARNs fire, odds are good
that they would fire repeatedly and spam the kernel log without providing
unique information in each print.

Note, defining pr_fmt yields undesirable results for code that uses KVM's
printk wrappers, e.g. vcpu_unimpl(). But, that's a pre-existing problem
as SVM/kvm_amd already defines a pr_fmt, and thankfully use of KVM's
wrappers is relatively limited in KVM x86 code.

Signed-off-by: Sean Christopherson <seanjc@google.com>
Reviewed-by: Paul Durrant <paul@xen.org>
Message-Id: <20221130230934.1014142-35-seanjc@google.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: smm: preserve interrupt shadow in SMRAM

When #SMI is asserted, the CPU can be in interrupt shadow due to sti or
mov ss.

It is not mandatory in Intel/AMD prm to have the #SMI blocked duri

KVM: x86: smm: preserve interrupt shadow in SMRAM

When #SMI is asserted, the CPU can be in interrupt shadow due to sti or
mov ss.

It is not mandatory in Intel/AMD prm to have the #SMI blocked during the
shadow, and on top of that, since neither SVM nor VMX has true support
for SMI window, waiting for one instruction would mean single stepping
the guest.

Instead, allow #SMI in this case, but both reset the interrupt window and
stash its value in SMRAM to restore it on exit from SMM.

This fixes rare failures seen mostly on windows guests on VMX, when #SMI
falls on the sti instruction which mainfest in VM entry failure due
to EFLAGS.IF not being set, but STI interrupt window still being set
in the VMCS.

Signed-off-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20221025124741.228045-24-mlevitsk@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: smm: use smram struct for 64 bit smram load/restore

Use kvm_smram_state_64 struct to save/restore the 64 bit SMM state
(used when X86_FEATURE_LM is present in the guest CPUID,
regardless o

KVM: x86: smm: use smram struct for 64 bit smram load/restore

Use kvm_smram_state_64 struct to save/restore the 64 bit SMM state
(used when X86_FEATURE_LM is present in the guest CPUID,
regardless of 32-bitness of the guest).

Signed-off-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20221025124741.228045-20-mlevitsk@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: smm: use smram struct for 32 bit smram load/restore

Use kvm_smram_state_32 struct to save/restore 32 bit SMM state
(used when X86_FEATURE_LM is not present in the guest CPUID).

Signed-off

KVM: x86: smm: use smram struct for 32 bit smram load/restore

Use kvm_smram_state_32 struct to save/restore 32 bit SMM state
(used when X86_FEATURE_LM is not present in the guest CPUID).

Signed-off-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20221025124741.228045-19-mlevitsk@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: smm: use smram structs in the common code

Use kvm_smram union instad of raw arrays in the common smm code.

Signed-off-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20221025124741.

KVM: x86: smm: use smram structs in the common code

Use kvm_smram union instad of raw arrays in the common smm code.

Signed-off-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20221025124741.228045-18-mlevitsk@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: smm: add structs for KVM's smram layout

Add structs that will be used to define and read/write the KVM's
SMRAM layout, instead of reading/writing to raw offsets.

Also document the differe

KVM: x86: smm: add structs for KVM's smram layout

Add structs that will be used to define and read/write the KVM's
SMRAM layout, instead of reading/writing to raw offsets.

Also document the differences between KVM's SMRAM layout and SMRAM
layout that is used by real Intel/AMD cpus.

Signed-off-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20221025124741.228045-17-mlevitsk@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: smm: check for failures on smm entry

In the rare case of the failure on SMM entry, the KVM should at
least terminate the VM instead of going south.

Suggested-by: Sean Christopherson <sean

KVM: x86: smm: check for failures on smm entry

In the rare case of the failure on SMM entry, the KVM should at
least terminate the VM instead of going south.

Suggested-by: Sean Christopherson <seanjc@google.com>
Signed-off-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20221025124741.228045-16-mlevitsk@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: do not define SMM-related constants if SMM disabled

The hidden processor flags HF_SMM_MASK and HF_SMM_INSIDE_NMI_MASK
are not needed if CONFIG_KVM_SMM is turned off. Remove the
definition

KVM: x86: do not define SMM-related constants if SMM disabled

The hidden processor flags HF_SMM_MASK and HF_SMM_INSIDE_NMI_MASK
are not needed if CONFIG_KVM_SMM is turned off. Remove the
definitions altogether and the code that uses them.

Suggested-by: Sean Christopherson <seanjc@google.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: do not go through ctxt->ops when emulating rsm

Now that RSM is implemented in a single emulator callback, there is no
point in going through other callbacks for the sake of modifying
proce

KVM: x86: do not go through ctxt->ops when emulating rsm

Now that RSM is implemented in a single emulator callback, there is no
point in going through other callbacks for the sake of modifying
processor state. Just invoke KVM's own internal functions directly,
and remove the callbacks that were only used by em_rsm; the only
substantial difference is in the handling of the segment registers
and descriptor cache, which have to be parsed into a struct kvm_segment
instead of a struct desc_struct.

This also fixes a bug where emulator_set_segment was shifting the
limit left by 12 if the G bit is set, but the limit had not been
shifted right upon entry to SMM.

The emulator context is still used to restore EIP and the general
purpose registers.

Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Reviewed-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20220929172016.319443-5-pbonzini@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: move SMM exit to a new file

Some users of KVM implement the UEFI variable store through a paravirtual
device that does not require the "SMM lockbox" component of edk2, and
would like to co

KVM: x86: move SMM exit to a new file

Some users of KVM implement the UEFI variable store through a paravirtual
device that does not require the "SMM lockbox" component of edk2, and
would like to compile out system management mode. In preparation for
that, move the SMM exit code out of emulate.c and into a new file.

The code is still written as a series of invocations of the emulator
callbacks, but the two exiting_smm and leave_smm callbacks are merged
into one, and all the code from em_rsm is now part of the callback.
This removes all knowledge of the format of the SMM save state area
from the emulator. Further patches will clean up the code and
invoke KVM's own functions to access control registers, descriptor
caches, etc.

Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Reviewed-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20220929172016.319443-4-pbonzini@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: move SMM entry to a new file

Some users of KVM implement the UEFI variable store through a paravirtual
device that does not require the "SMM lockbox" component of edk2, and
would like to c

KVM: x86: move SMM entry to a new file

Some users of KVM implement the UEFI variable store through a paravirtual
device that does not require the "SMM lockbox" component of edk2, and
would like to compile out system management mode. In preparation for
that, move the SMM entry code out of x86.c and into a new file.

Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Reviewed-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20220929172016.319443-3-pbonzini@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...

KVM: x86: start moving SMM-related functions to new files

Create a new header and source with code related to system management
mode emulation. Entry and exit will move there too; for now,
opportun

KVM: x86: start moving SMM-related functions to new files

Create a new header and source with code related to system management
mode emulation. Entry and exit will move there too; for now,
opportunistically rename put_smstate to PUT_SMSTATE while moving
it to smm.h, and adjust the SMM state saving code.

Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Reviewed-by: Maxim Levitsky <mlevitsk@redhat.com>
Message-Id: <20220929172016.319443-2-pbonzini@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

show more ...