xref: /openbmc/u-boot/include/status_led.h (revision a3b36c84)
1 /*
2  * (C) Copyright 2000-2004
3  * Wolfgang Denk, DENX Software Engineering, wd@denx.de.
4  *
5  * SPDX-License-Identifier:	GPL-2.0+
6  */
7 
8 /*
9  * The purpose of this code is to signal the operational status of a
10  * target which usually boots over the network; while running in
11  * PCBoot, a status LED is blinking. As soon as a valid BOOTP reply
12  * message has been received, the LED is turned off. The Linux
13  * kernel, once it is running, will start blinking the LED again,
14  * with another frequency.
15  */
16 
17 #ifndef _STATUS_LED_H_
18 #define	_STATUS_LED_H_
19 
20 #ifdef CONFIG_LED_STATUS
21 
22 #define LED_STATUS_PERIOD	(CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ)
23 #ifdef CONFIG_LED_STATUS1
24 #define LED_STATUS_PERIOD1	(CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ1)
25 #endif /* CONFIG_LED_STATUS1 */
26 #ifdef CONFIG_LED_STATUS2
27 #define LED_STATUS_PERIOD2	(CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ2)
28 #endif /* CONFIG_LED_STATUS2 */
29 #ifdef CONFIG_LED_STATUS3
30 #define LED_STATUS_PERIOD3	(CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ3)
31 #endif /* CONFIG_LED_STATUS3 */
32 #ifdef CONFIG_LED_STATUS4
33 #define LED_STATUS_PERIOD4	(CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ4)
34 #endif /* CONFIG_LED_STATUS4 */
35 #ifdef CONFIG_LED_STATUS5
36 #define LED_STATUS_PERIOD5	(CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ5)
37 #endif /* CONFIG_LED_STATUS5 */
38 
39 void status_led_init(void);
40 void status_led_tick (unsigned long timestamp);
41 void status_led_set  (int led, int state);
42 
43 /*****  MVS v1  **********************************************************/
44 #if (defined(CONFIG_MVS) && CONFIG_MVS < 2)
45 # define STATUS_LED_PAR		im_ioport.iop_pdpar
46 # define STATUS_LED_DIR		im_ioport.iop_pddir
47 # undef  STATUS_LED_ODR
48 # define STATUS_LED_DAT		im_ioport.iop_pddat
49 
50 # define STATUS_LED_ACTIVE	1		/* LED on for bit == 1	*/
51 
52 /*****  Someone else defines these  *************************************/
53 #elif defined(STATUS_LED_PAR)
54   /*
55    * ADVICE: Define in your board configuration file rather than
56    * filling this file up with lots of custom board stuff.
57    */
58 
59 #elif defined(CONFIG_LED_STATUS_BOARD_SPECIFIC)
60 /* led_id_t is unsigned long mask */
61 typedef unsigned long led_id_t;
62 
63 extern void __led_toggle (led_id_t mask);
64 extern void __led_init (led_id_t mask, int state);
65 extern void __led_set (led_id_t mask, int state);
66 void __led_blink(led_id_t mask, int freq);
67 #else
68 # error Status LED configuration missing
69 #endif
70 /************************************************************************/
71 
72 #ifndef CONFIG_LED_STATUS_BOARD_SPECIFIC
73 # include <asm/status_led.h>
74 #endif
75 
76 #endif	/* CONFIG_LED_STATUS	*/
77 
78 /*
79  * Coloured LEDs API
80  */
81 #ifndef	__ASSEMBLY__
82 void coloured_LED_init(void);
83 void red_led_on(void);
84 void red_led_off(void);
85 void green_led_on(void);
86 void green_led_off(void);
87 void yellow_led_on(void);
88 void yellow_led_off(void);
89 void blue_led_on(void);
90 void blue_led_off(void);
91 #else
92 	.extern LED_init
93 	.extern red_led_on
94 	.extern red_led_off
95 	.extern yellow_led_on
96 	.extern yellow_led_off
97 	.extern green_led_on
98 	.extern green_led_off
99 	.extern blue_led_on
100 	.extern blue_led_off
101 #endif
102 
103 #endif	/* _STATUS_LED_H_	*/
104