1 /* 2 * Copyright (C) 2015 Marek Vasut <marex@denx.de> 3 * 4 * SPDX-License-Identifier: GPL-2.0+ 5 */ 6 #ifndef __CONFIG_SAMTEC_VINING_FPGA_H__ 7 #define __CONFIG_SAMTEC_VINING_FPGA_H__ 8 9 #include <asm/arch/base_addr_ac5.h> 10 11 /* U-Boot Commands */ 12 #define CONFIG_FAT_WRITE 13 #define CONFIG_HW_WATCHDOG 14 15 /* Memory configurations */ 16 #define PHYS_SDRAM_1_SIZE 0x40000000 /* 1GiB on VINING_FPGA */ 17 18 /* Booting Linux */ 19 #define CONFIG_BOOTFILE "openwrt-socfpga-socfpga_cyclone5_vining_fpga-fit-uImage.itb" 20 #define CONFIG_BOOTARGS "console=ttyS0," __stringify(CONFIG_BAUDRATE) 21 #define CONFIG_BOOTCOMMAND "run selboot" 22 #define CONFIG_LOADADDR 0x01000000 23 #define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR 24 25 /* I2C EEPROM */ 26 #ifdef CONFIG_CMD_EEPROM 27 #define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 28 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 29 #define CONFIG_SYS_I2C_EEPROM_BUS 0 30 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3 31 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 70 32 #endif 33 34 /* 35 * Status LEDs: 36 * 0 ... Top Green 37 * 1 ... Top Red 38 * 2 ... Bottom Green 39 * 3 ... Bottom Red 40 */ 41 42 /* Ethernet on SoC (EMAC) */ 43 #if defined(CONFIG_CMD_NET) 44 #define CONFIG_BOOTP_SEND_HOSTNAME 45 /* PHY */ 46 #define CONFIG_PHY_MICREL 47 #define CONFIG_PHY_MICREL_KSZ9021 48 #endif 49 50 /* Extra Environment */ 51 #define CONFIG_HOSTNAME socfpga_vining_fpga 52 53 /* 54 * Active LOW GPIO buttons: 55 * A: GPIO 77 ... the button between USB B and ethernet 56 * B: GPIO 78 ... the button between USB A ports 57 * 58 * The logic: 59 * if button B is not pressed, boot normal Linux system immediatelly 60 * if button B is pressed, wait $bootdelay and boot recovery system 61 */ 62 #define CONFIG_PREBOOT \ 63 "setenv hostname vining-${unit_serial} ; " \ 64 "setenv PS1 \"${unit_ident} (${unit_serial}) => \" ; " \ 65 "if gpio input 78 ; then " \ 66 "setenv bootdelay 10 ; " \ 67 "setenv boottype rcvr ; " \ 68 "else " \ 69 "setenv bootdelay 5 ; " \ 70 "setenv boottype norm ; " \ 71 "fi" 72 73 #define CONFIG_EXTRA_ENV_SETTINGS \ 74 "verify=n\0" \ 75 "consdev=ttyS0\0" \ 76 "baudrate=115200\0" \ 77 "bootscript=boot.scr\0" \ 78 "ubimtdnr=5\0" \ 79 "ubimtd=rootfs\0" \ 80 "ubipart=ubi0:rootfs\0" \ 81 "ubisfcs=1\0" /* Default is flash at CS#1 */ \ 82 "netdev=eth0\0" \ 83 "hostname=vining_fpga\0" \ 84 "kernel_addr_r=0x10000000\0" \ 85 "mtdparts_0=ff705000.spi.0:" \ 86 "1m(u-boot)," \ 87 "64k(env1)," \ 88 "64k(env2)," \ 89 "256k(samtec1)," \ 90 "256k(samtec2)," \ 91 "-(rcvrfs)\0" /* Recovery */ \ 92 "mtdparts_1=ff705000.spi.1:" \ 93 "32m(rootfs)," \ 94 "-(userfs)\0" \ 95 "update_filename=u-boot-with-spl-dtb.sfp\0" \ 96 "update_qspi_offset=0x0\0" \ 97 "update_qspi=" /* Update the QSPI firmware */ \ 98 "if sf probe ; then " \ 99 "if tftp ${update_filename} ; then " \ 100 "sf update ${loadaddr} ${update_qspi_offset} ${filesize} ; " \ 101 "fi ; " \ 102 "fi\0" \ 103 "fpga_filename=output_file.rbf\0" \ 104 "load_fpga=" /* Load FPGA bitstream */ \ 105 "if tftp ${fpga_filename} ; then " \ 106 "fpga load 0 $loadaddr $filesize ; " \ 107 "bridge enable ; " \ 108 "fi\0" \ 109 "addcons=" \ 110 "setenv bootargs ${bootargs} " \ 111 "console=${consdev},${baudrate}\0" \ 112 "addip=" \ 113 "setenv bootargs ${bootargs} " \ 114 "ip=${ipaddr}:${serverip}:${gatewayip}:" \ 115 "${netmask}:${hostname}:${netdev}:off\0" \ 116 "addmisc=" \ 117 "setenv bootargs ${bootargs} ${miscargs}\0" \ 118 "addmtd=" \ 119 "setenv mtdparts \"${mtdparts_0};${mtdparts_1}\" ; " \ 120 "setenv bootargs ${bootargs} mtdparts=${mtdparts}\0" \ 121 "addargs=run addcons addmtd addmisc\0" \ 122 "ubiload=" \ 123 "ubi part ${ubimtd} ; ubifsmount ${ubipart} ; " \ 124 "ubifsload ${kernel_addr_r} /boot/${bootfile}\0" \ 125 "netload=" \ 126 "tftp ${kernel_addr_r} ${hostname}/${bootfile}\0" \ 127 "miscargs=nohlt panic=1\0" \ 128 "ubiargs=" \ 129 "setenv bootargs ubi.mtd=${ubimtdnr} " \ 130 "root=${ubipart} rootfstype=ubifs\0" \ 131 "nfsargs=" \ 132 "setenv bootargs root=/dev/nfs rw " \ 133 "nfsroot=${serverip}:${rootpath},v3,tcp\0" \ 134 "ubi_sfsel=" \ 135 "if test \"${boottype}\" = \"rcvr\" ; then " \ 136 "setenv ubisfcs 0 ; " \ 137 "setenv ubimtd rcvrfs ; " \ 138 "setenv ubimtdnr 5 ; " \ 139 "setenv mtdparts mtdparts=${mtdparts_0} ; " \ 140 "setenv mtdids nor0=ff705000.spi.0 ; " \ 141 "setenv ubipart ubi0:rootfs ; " \ 142 "else " \ 143 "setenv ubisfcs 1 ; " \ 144 "setenv ubimtd rootfs ; " \ 145 "setenv ubimtdnr 6 ; " \ 146 "setenv mtdparts mtdparts=${mtdparts_1} ; " \ 147 "setenv mtdids nor0=ff705000.spi.1 ; " \ 148 "setenv ubipart ubi0:rootfs ; " \ 149 "fi ; " \ 150 "sf probe 0:${ubisfcs}\0" \ 151 "ubi_ubi=" \ 152 "run ubi_sfsel ubiload ubiargs addargs ; " \ 153 "bootm ${kernel_addr_r}\0" \ 154 "ubi_nfs=" \ 155 "run ubiload nfsargs addip addargs ; " \ 156 "bootm ${kernel_addr_r}\0" \ 157 "net_ubi=" \ 158 "run netload ubiargs addargs ; " \ 159 "bootm ${kernel_addr_r}\0" \ 160 "net_nfs=" \ 161 "run netload nfsargs addip addargs ; " \ 162 "bootm ${kernel_addr_r}\0" \ 163 "selboot=" /* Select from where to boot. */ \ 164 "if test \"${bootmode}\" = \"qspi\" ; then " \ 165 "led all off ; " \ 166 "if test \"${boottype}\" = \"rcvr\" ; then " \ 167 "echo \"Booting recovery system\" ; " \ 168 "led 3 on ; " /* Bottom RED */ \ 169 "fi ; " \ 170 "led 1 on ; " /* Top RED */ \ 171 "run ubi_ubi ; " \ 172 "else echo \"Unsupported boot mode: \"${bootmode} ; " \ 173 "fi\0" \ 174 175 #define CONFIG_CMD_UBIFS 176 #define CONFIG_RBTREE 177 #define CONFIG_LZO 178 #define MTDPARTS_DEFAULT \ 179 "mtdparts=ff705000.spi.0:" \ 180 "1m(u-boot)," \ 181 "64k(env1)," \ 182 "64k(env2)," \ 183 "256k(samtec1)," \ 184 "256k(samtec2)," \ 185 "-(rcvrfs);" /* Recovery */ \ 186 187 #define CONFIG_ENV_IS_IN_SPI_FLASH 188 #define CONFIG_SYS_REDUNDAND_ENVIRONMENT 189 #define CONFIG_ENV_SIZE_REDUND CONFIG_ENV_SIZE 190 #define CONFIG_ENV_SECT_SIZE (64 * 1024) 191 #define CONFIG_ENV_OFFSET 0x100000 192 #define CONFIG_ENV_OFFSET_REDUND \ 193 (CONFIG_ENV_OFFSET + CONFIG_ENV_SECT_SIZE) 194 195 #define CONFIG_MISC_INIT_R 196 197 /* Support changing the prompt string */ 198 #define CONFIG_CMDLINE_PS_SUPPORT 199 200 /* The rest of the configuration is shared */ 201 #include <configs/socfpga_common.h> 202 203 #endif /* __CONFIG_SAMTEC_VINING_FPGA_H__ */ 204