1 /* SPDX-License-Identifier: GPL-2.0
2  *
3  * Copyright (C) 2017-2018 Intel Corporation <www.intel.com>
4  *
5  */
6 
7 #ifndef __CONFIG_SOCFGPA_STRATIX10_H__
8 #define __CONFIG_SOCFGPA_STRATIX10_H__
9 
10 #include <asm/arch/base_addr_s10.h>
11 #include <asm/arch/handoff_s10.h>
12 
13 /*
14  * U-Boot general configurations
15  */
16 #define CONFIG_SYS_MONITOR_BASE		CONFIG_SYS_TEXT_BASE
17 #define CONFIG_LOADADDR			0x2000000
18 #define CONFIG_SYS_LOAD_ADDR		CONFIG_LOADADDR
19 #define CONFIG_REMAKE_ELF
20 /* sysmgr.boot_scratch_cold4 & 5 (64bit) will be used for PSCI_CPU_ON call */
21 #define CPU_RELEASE_ADDR		0xFFD12210
22 #define CONFIG_SYS_CACHELINE_SIZE	64
23 #define CONFIG_SYS_MEM_RESERVE_SECURE	0	/* using OCRAM, not DDR */
24 
25 /*
26  * U-Boot console configurations
27  */
28 #define CONFIG_SYS_MAXARGS		64
29 #define CONFIG_SYS_CBSIZE		2048
30 #define CONFIG_SYS_PBSIZE		(CONFIG_SYS_CBSIZE + \
31 					sizeof(CONFIG_SYS_PROMPT) + 16)
32 #define CONFIG_SYS_BARGSIZE		CONFIG_SYS_CBSIZE
33 
34 /* Extend size of kernel image for uncompression */
35 #define CONFIG_SYS_BOOTM_LEN		(32 * 1024 * 1024)
36 
37 /*
38  * U-Boot run time memory configurations
39  */
40 #define CONFIG_SYS_INIT_RAM_ADDR	0xFFE00000
41 #define CONFIG_SYS_INIT_RAM_SIZE	0x40000
42 #define CONFIG_SYS_INIT_SP_ADDR		(CONFIG_SYS_INIT_RAM_ADDR  \
43 					+ CONFIG_SYS_INIT_RAM_SIZE \
44 					- S10_HANDOFF_SIZE)
45 #define CONFIG_SYS_INIT_SP_OFFSET	(CONFIG_SYS_INIT_SP_ADDR)
46 #define CONFIG_SYS_MALLOC_LEN		(5 * 1024 * 1024)
47 
48 /*
49  * U-Boot environment configurations
50  */
51 #define CONFIG_ENV_SIZE			0x1000
52 #define CONFIG_SYS_MMC_ENV_DEV		0	/* device 0 */
53 #define CONFIG_ENV_OFFSET		512	/* just after the MBR */
54 
55 /*
56  * QSPI support
57  */
58  #ifdef CONFIG_CADENCE_QSPI
59 /* Enable it if you want to use dual-stacked mode */
60 #undef CONFIG_SF_DUAL_FLASH
61 /*#define CONFIG_QSPI_RBF_ADDR		0x720000*/
62 
63 /* Flash device info */
64 #define CONFIG_SF_DEFAULT_SPEED		(50000000)
65 #define CONFIG_SF_DEFAULT_MODE		(SPI_MODE_3 | SPI_RX_QUAD)
66 #define CONFIG_SF_DEFAULT_BUS		0
67 #define CONFIG_SF_DEFAULT_CS		0
68 
69 /*#define CONFIG_ENV_IS_IN_SPI_FLASH*/
70 #ifdef CONFIG_ENV_IS_IN_SPI_FLASH
71 #undef CONFIG_ENV_OFFSET
72 #undef CONFIG_ENV_SIZE
73 #define CONFIG_ENV_OFFSET		0x710000
74 #define CONFIG_ENV_SIZE			(4 * 1024)
75 #define CONFIG_ENV_SECT_SIZE		(4 * 1024)
76 #endif /* CONFIG_ENV_IS_IN_SPI_FLASH */
77 
78 #ifndef CONFIG_SPL_BUILD
79 #define CONFIG_MTD_DEVICE
80 #define CONFIG_MTD_PARTITIONS
81 #define MTDIDS_DEFAULT			"nor0=ff705000.spi.0"
82 #endif /* CONFIG_SPL_BUILD */
83 
84 #ifndef __ASSEMBLY__
85 unsigned int cm_get_qspi_controller_clk_hz(void);
86 #define CONFIG_CQSPI_REF_CLK		cm_get_qspi_controller_clk_hz()
87 #endif
88 
89 #endif /* CONFIG_CADENCE_QSPI */
90 
91 /*
92  * Boot arguments passed to the boot command. The value of
93  * CONFIG_BOOTARGS goes into the environment value "bootargs".
94  * Do note the value will override also the chosen node in FDT blob.
95  */
96 #define CONFIG_BOOTARGS "earlycon"
97 #define CONFIG_BOOTCOMMAND "run fatscript; run mmcload;run linux_qspi_enable;" \
98 			   "run mmcboot"
99 
100 #define CONFIG_EXTRA_ENV_SETTINGS \
101 	"loadaddr=" __stringify(CONFIG_SYS_LOAD_ADDR) "\0" \
102 	"bootfile=Image\0" \
103 	"fdt_addr=8000000\0" \
104 	"fdtimage=socfpga_stratix10_socdk.dtb\0" \
105 	"mmcroot=/dev/mmcblk0p2\0" \
106 	"mmcboot=setenv bootargs " CONFIG_BOOTARGS \
107 		" root=${mmcroot} rw rootwait;" \
108 		"booti ${loadaddr} - ${fdt_addr}\0" \
109 	"mmcload=mmc rescan;" \
110 		"load mmc 0:1 ${loadaddr} ${bootfile};" \
111 		"load mmc 0:1 ${fdt_addr} ${fdtimage}\0" \
112 	"linux_qspi_enable=if sf probe; then " \
113 		"echo Enabling QSPI at Linux DTB...;" \
114 		"fdt addr ${fdt_addr}; fdt resize;" \
115 		"fdt set /soc/spi@ff8d2000 status okay;" \
116 		"fdt set /soc/clkmgr/clocks/qspi_clk clock-frequency " \
117 		" ${qspi_clock}; fi; \0" \
118 	"scriptaddr=0x02100000\0" \
119 	"scriptfile=u-boot.scr\0" \
120 	"fatscript=if fatload mmc 0:1 ${scriptaddr} ${scriptfile};" \
121 		   "then source ${scriptaddr}; fi\0"
122 
123 /*
124  * Generic Interrupt Controller Definitions
125  */
126 #define CONFIG_GICV2
127 
128 /*
129  * External memory configurations
130  */
131 #define PHYS_SDRAM_1			0x0
132 #define PHYS_SDRAM_1_SIZE		(1 * 1024 * 1024 * 1024)
133 #define CONFIG_SYS_SDRAM_BASE		0
134 #define CONFIG_NR_DRAM_BANKS		1
135 #define CONFIG_SYS_MEMTEST_START	0
136 #define CONFIG_SYS_MEMTEST_END		PHYS_SDRAM_1_SIZE - 0x200000
137 
138 /*
139  * SDRAM controller
140  */
141 #define CONFIG_ALTERA_SDRAM
142 
143 /*
144  * Serial / UART configurations
145  */
146 #define CONFIG_SYS_NS16550_CLK		100000000
147 #define CONFIG_SYS_NS16550_MEM32
148 
149 /*
150  * Timer & watchdog configurations
151  */
152 #define COUNTER_FREQUENCY		400000000
153 
154 /*
155  * SDMMC configurations
156  */
157 #ifdef CONFIG_CMD_MMC
158 #define CONFIG_BOUNCE_BUFFER
159 #define CONFIG_SYS_MMC_MAX_BLK_COUNT	256
160 #endif
161 /*
162  * Flash configurations
163  */
164 #define CONFIG_SYS_MAX_FLASH_BANKS	1
165 
166 /* Ethernet on SoC (EMAC) */
167 #if defined(CONFIG_CMD_NET)
168 #define CONFIG_DW_ALTDESCRIPTOR
169 #define CONFIG_MII
170 #endif /* CONFIG_CMD_NET */
171 
172 /*
173  * L4 Watchdog
174  */
175 #ifdef CONFIG_SPL_BUILD
176 #define CONFIG_HW_WATCHDOG
177 #define CONFIG_DESIGNWARE_WATCHDOG
178 #define CONFIG_DW_WDT_BASE		SOCFPGA_L4WD0_ADDRESS
179 #ifndef __ASSEMBLY__
180 unsigned int cm_get_l4_sys_free_clk_hz(void);
181 #define CONFIG_DW_WDT_CLOCK_KHZ		(cm_get_l4_sys_free_clk_hz() / 1000)
182 #endif
183 #define CONFIG_WATCHDOG_TIMEOUT_MSECS	3000
184 #endif
185 
186 /*
187  * SPL memory layout
188  *
189  * On chip RAM
190  * 0xFFE0_0000 ...... Start of OCRAM
191  * SPL code, rwdata
192  * empty space
193  * 0xFFEx_xxxx ...... Top of stack (grows down)
194  * 0xFFEy_yyyy ...... Global Data
195  * 0xFFEz_zzzz ...... Malloc prior relocation (size CONFIG_SYS_MALLOC_F_LEN)
196  * 0xFFE3_F000 ...... Hardware handdoff blob (size 4KB)
197  * 0xFFE3_FFFF ...... End of OCRAM
198  *
199  * SDRAM
200  * 0x0000_0000 ...... Start of SDRAM_1
201  * unused / empty space for image loading
202  * Size 64MB   ...... MALLOC (size CONFIG_SYS_SPL_MALLOC_SIZE)
203  * Size 1MB    ...... BSS (size CONFIG_SPL_BSS_MAX_SIZE)
204  * 0x8000_0000 ...... End of SDRAM_1 (assume 2GB)
205  *
206  */
207 #define CONFIG_SPL_TEXT_BASE		CONFIG_SYS_INIT_RAM_ADDR
208 #define CONFIG_SPL_MAX_SIZE		CONFIG_SYS_INIT_RAM_SIZE
209 #define CONFIG_SPL_STACK		CONFIG_SYS_INIT_SP_ADDR
210 #define CONFIG_SPL_BSS_MAX_SIZE		0x100000	/* 1 MB */
211 #define CONFIG_SPL_BSS_START_ADDR	(PHYS_SDRAM_1 + PHYS_SDRAM_1_SIZE \
212 					- CONFIG_SPL_BSS_MAX_SIZE)
213 #define CONFIG_SYS_SPL_MALLOC_SIZE	(CONFIG_SYS_MALLOC_LEN)
214 #define CONFIG_SYS_SPL_MALLOC_START	(CONFIG_SPL_BSS_START_ADDR \
215 					- CONFIG_SYS_SPL_MALLOC_SIZE)
216 #define CONFIG_SYS_SPI_U_BOOT_OFFS      0x3C00000
217 
218 /* SPL SDMMC boot support */
219 #define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION	1
220 #define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME		"u-boot-dtb.img"
221 
222 #endif	/* __CONFIG_H */
223