xref: /openbmc/u-boot/include/configs/sc_sps_1.h (revision ed09a554)
1 /*
2  * SchulerControl GmbH, SC_SPS_1 module config
3  *
4  * Copyright (C) 2012 Marek Vasut <marex@denx.de>
5  * on behalf of DENX Software Engineering GmbH
6  *
7  * SPDX-License-Identifier:	GPL-2.0+
8  */
9 #ifndef __CONFIGS_SC_SPS_1_H__
10 #define __CONFIGS_SC_SPS_1_H__
11 
12 /* System configuration */
13 #define CONFIG_MX28				/* i.MX28 SoC */
14 #define MACH_TYPE_SC_SPS_1	4172
15 #define CONFIG_MACH_TYPE	MACH_TYPE_SC_SPS_1
16 
17 /* U-Boot Commands */
18 #define CONFIG_SYS_NO_FLASH
19 #include <config_cmd_default.h>
20 #define CONFIG_DISPLAY_CPUINFO
21 #define CONFIG_DOS_PARTITION
22 
23 #define CONFIG_CMD_CACHE
24 #define CONFIG_CMD_DHCP
25 #define CONFIG_CMD_EXT2
26 #define CONFIG_CMD_FAT
27 #define CONFIG_CMD_GPIO
28 #define CONFIG_CMD_MII
29 #define CONFIG_CMD_MMC
30 #define CONFIG_CMD_NET
31 #define CONFIG_CMD_NFS
32 #define CONFIG_CMD_PING
33 #define CONFIG_CMD_SETEXPR
34 #define CONFIG_CMD_USB
35 
36 /* Memory configuration */
37 #define CONFIG_NR_DRAM_BANKS		1		/* 1 bank of DRAM */
38 #define PHYS_SDRAM_1			0x40000000	/* Base address */
39 #define PHYS_SDRAM_1_SIZE		0x40000000	/* Max 1 GB RAM */
40 #define CONFIG_SYS_SDRAM_BASE		PHYS_SDRAM_1
41 
42 /* Environment */
43 #define CONFIG_ENV_SIZE			(16 * 1024)
44 #define CONFIG_ENV_IS_IN_MMC
45 
46 /* Environment is in MMC */
47 #if defined(CONFIG_CMD_MMC) && defined(CONFIG_ENV_IS_IN_MMC)
48 #define CONFIG_ENV_OFFSET		(256 * 1024)
49 #define CONFIG_SYS_MMC_ENV_DEV		0
50 #else
51 #define CONFIG_ENV_IS_NOWHERE
52 #endif
53 
54 /* FEC Ethernet on SoC */
55 #ifdef CONFIG_CMD_NET
56 #define CONFIG_FEC_MXC
57 #define CONFIG_PHYLIB
58 #define CONFIG_PHY_SMSC
59 #endif
60 
61 /* USB */
62 #ifdef CONFIG_CMD_USB
63 #define CONFIG_EHCI_MXS_PORT0
64 #define CONFIG_USB_MAX_CONTROLLER_COUNT	1
65 #define CONFIG_USB_STORAGE
66 #endif
67 
68 /* Booting Linux */
69 #define CONFIG_BOOTDELAY	3
70 #define CONFIG_BOOTFILE		"uImage"
71 #define CONFIG_BOOTARGS		"console=ttyAMA0,115200"
72 #define CONFIG_BOOTCOMMAND	"bootm"
73 #define CONFIG_LOADADDR		0x42000000
74 #define CONFIG_SYS_LOAD_ADDR	CONFIG_LOADADDR
75 
76 /* Extra Environment */
77 #define CONFIG_EXTRA_ENV_SETTINGS					\
78 	"update_sd_firmware_filename=u-boot.sd\0"			\
79 	"update_sd_firmware="		/* Update the SD firmware partition */ \
80 		"if mmc rescan ; then "					\
81 		"if tftp ${update_sd_firmware_filename} ; then "	\
82 		"setexpr fw_sz ${filesize} / 0x200 ; "	/* SD block size */ \
83 		"setexpr fw_sz ${fw_sz} + 1 ; "				\
84 		"mmc write ${loadaddr} 0x800 ${fw_sz} ; "		\
85 		"fi ; "							\
86 		"fi\0"
87 
88 /* The rest of the configuration is shared */
89 #include <configs/mxs.h>
90 
91 #endif /* __CONFIGS_SC_SPS_1_H__ */
92