xref: /openbmc/u-boot/include/configs/sc_sps_1.h (revision be059e88)
1 /*
2  * SchulerControl GmbH, SC_SPS_1 module config
3  *
4  * Copyright (C) 2012 Marek Vasut <marex@denx.de>
5  * on behalf of DENX Software Engineering GmbH
6  *
7  * SPDX-License-Identifier:	GPL-2.0+
8  */
9 #ifndef __CONFIGS_SC_SPS_1_H__
10 #define __CONFIGS_SC_SPS_1_H__
11 
12 /* System configuration */
13 #define CONFIG_MX28				/* i.MX28 SoC */
14 #define CONFIG_MACH_TYPE	MACH_TYPE_SC_SPS_1
15 
16 /* U-Boot Commands */
17 #define CONFIG_SYS_NO_FLASH
18 
19 /* Memory configuration */
20 #define CONFIG_NR_DRAM_BANKS		1		/* 1 bank of DRAM */
21 #define PHYS_SDRAM_1			0x40000000	/* Base address */
22 #define PHYS_SDRAM_1_SIZE		0x40000000	/* Max 1 GB RAM */
23 #define CONFIG_SYS_SDRAM_BASE		PHYS_SDRAM_1
24 
25 /* Environment */
26 #define CONFIG_ENV_SIZE			(16 * 1024)
27 #define CONFIG_ENV_IS_IN_MMC
28 
29 /* Environment is in MMC */
30 #if defined(CONFIG_CMD_MMC) && defined(CONFIG_ENV_IS_IN_MMC)
31 #define CONFIG_ENV_OFFSET		(256 * 1024)
32 #define CONFIG_SYS_MMC_ENV_DEV		0
33 #else
34 #define CONFIG_ENV_IS_NOWHERE
35 #endif
36 
37 /* FEC Ethernet on SoC */
38 #ifdef CONFIG_CMD_NET
39 #define CONFIG_FEC_MXC
40 #define CONFIG_PHYLIB
41 #define CONFIG_PHY_SMSC
42 #endif
43 
44 /* USB */
45 #ifdef CONFIG_CMD_USB
46 #define CONFIG_EHCI_MXS_PORT0
47 #define CONFIG_USB_MAX_CONTROLLER_COUNT	1
48 #endif
49 
50 /* Booting Linux */
51 #define CONFIG_BOOTFILE		"uImage"
52 #define CONFIG_BOOTARGS		"console=ttyAMA0,115200"
53 #define CONFIG_BOOTCOMMAND	"bootm"
54 #define CONFIG_LOADADDR		0x42000000
55 #define CONFIG_SYS_LOAD_ADDR	CONFIG_LOADADDR
56 
57 /* Extra Environment */
58 #define CONFIG_EXTRA_ENV_SETTINGS					\
59 	"update_sd_firmware_filename=u-boot.sd\0"			\
60 	"update_sd_firmware="		/* Update the SD firmware partition */ \
61 		"if mmc rescan ; then "					\
62 		"if tftp ${update_sd_firmware_filename} ; then "	\
63 		"setexpr fw_sz ${filesize} / 0x200 ; "	/* SD block size */ \
64 		"setexpr fw_sz ${fw_sz} + 1 ; "				\
65 		"mmc write ${loadaddr} 0x800 ${fw_sz} ; "		\
66 		"fi ; "							\
67 		"fi\0"
68 
69 /* The rest of the configuration is shared */
70 #include <configs/mxs.h>
71 
72 #endif /* __CONFIGS_SC_SPS_1_H__ */
73