1 /* 2 * SchulerControl GmbH, SC_SPS_1 module config 3 * 4 * Copyright (C) 2012 Marek Vasut <marex@denx.de> 5 * on behalf of DENX Software Engineering GmbH 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 #ifndef __CONFIGS_SC_SPS_1_H__ 10 #define __CONFIGS_SC_SPS_1_H__ 11 12 /* System configuration */ 13 #define CONFIG_MX28 /* i.MX28 SoC */ 14 #define CONFIG_MACH_TYPE MACH_TYPE_SC_SPS_1 15 16 /* U-Boot Commands */ 17 18 /* Memory configuration */ 19 #define CONFIG_NR_DRAM_BANKS 1 /* 1 bank of DRAM */ 20 #define PHYS_SDRAM_1 0x40000000 /* Base address */ 21 #define PHYS_SDRAM_1_SIZE 0x40000000 /* Max 1 GB RAM */ 22 #define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1 23 24 /* Environment */ 25 #define CONFIG_ENV_SIZE (16 * 1024) 26 27 /* Environment is in MMC */ 28 #if defined(CONFIG_CMD_MMC) && defined(CONFIG_ENV_IS_IN_MMC) 29 #define CONFIG_ENV_OFFSET (256 * 1024) 30 #define CONFIG_SYS_MMC_ENV_DEV 0 31 #endif 32 33 /* FEC Ethernet on SoC */ 34 #ifdef CONFIG_CMD_NET 35 #define CONFIG_FEC_MXC 36 #define CONFIG_PHY_SMSC 37 #endif 38 39 /* USB */ 40 #ifdef CONFIG_CMD_USB 41 #define CONFIG_EHCI_MXS_PORT0 42 #define CONFIG_USB_MAX_CONTROLLER_COUNT 1 43 #endif 44 45 /* Booting Linux */ 46 #define CONFIG_BOOTFILE "uImage" 47 #define CONFIG_BOOTARGS "console=ttyAMA0,115200" 48 #define CONFIG_BOOTCOMMAND "bootm" 49 #define CONFIG_LOADADDR 0x42000000 50 #define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR 51 52 /* Extra Environment */ 53 #define CONFIG_EXTRA_ENV_SETTINGS \ 54 "update_sd_firmware_filename=u-boot.sd\0" \ 55 "update_sd_firmware=" /* Update the SD firmware partition */ \ 56 "if mmc rescan ; then " \ 57 "if tftp ${update_sd_firmware_filename} ; then " \ 58 "setexpr fw_sz ${filesize} / 0x200 ; " /* SD block size */ \ 59 "setexpr fw_sz ${fw_sz} + 1 ; " \ 60 "mmc write ${loadaddr} 0x800 ${fw_sz} ; " \ 61 "fi ; " \ 62 "fi\0" 63 64 /* The rest of the configuration is shared */ 65 #include <configs/mxs.h> 66 67 #endif /* __CONFIGS_SC_SPS_1_H__ */ 68