xref: /openbmc/u-boot/include/configs/sc_sps_1.h (revision 730d2544)
1 /*
2  * SchulerControl GmbH, SC_SPS_1 module config
3  *
4  * Copyright (C) 2012 Marek Vasut <marex@denx.de>
5  * on behalf of DENX Software Engineering GmbH
6  *
7  * SPDX-License-Identifier:	GPL-2.0+
8  */
9 #ifndef __CONFIGS_SC_SPS_1_H__
10 #define __CONFIGS_SC_SPS_1_H__
11 
12 /* System configuration */
13 #define CONFIG_MX28				/* i.MX28 SoC */
14 #define MACH_TYPE_SC_SPS_1	4172
15 #define CONFIG_MACH_TYPE	MACH_TYPE_SC_SPS_1
16 
17 /* U-Boot Commands */
18 #define CONFIG_SYS_NO_FLASH
19 #define CONFIG_DOS_PARTITION
20 
21 /* Memory configuration */
22 #define CONFIG_NR_DRAM_BANKS		1		/* 1 bank of DRAM */
23 #define PHYS_SDRAM_1			0x40000000	/* Base address */
24 #define PHYS_SDRAM_1_SIZE		0x40000000	/* Max 1 GB RAM */
25 #define CONFIG_SYS_SDRAM_BASE		PHYS_SDRAM_1
26 
27 /* Environment */
28 #define CONFIG_ENV_SIZE			(16 * 1024)
29 #define CONFIG_ENV_IS_IN_MMC
30 
31 /* Environment is in MMC */
32 #if defined(CONFIG_CMD_MMC) && defined(CONFIG_ENV_IS_IN_MMC)
33 #define CONFIG_ENV_OFFSET		(256 * 1024)
34 #define CONFIG_SYS_MMC_ENV_DEV		0
35 #else
36 #define CONFIG_ENV_IS_NOWHERE
37 #endif
38 
39 /* FEC Ethernet on SoC */
40 #ifdef CONFIG_CMD_NET
41 #define CONFIG_FEC_MXC
42 #define CONFIG_PHYLIB
43 #define CONFIG_PHY_SMSC
44 #endif
45 
46 /* USB */
47 #ifdef CONFIG_CMD_USB
48 #define CONFIG_EHCI_MXS_PORT0
49 #define CONFIG_USB_MAX_CONTROLLER_COUNT	1
50 #endif
51 
52 /* Booting Linux */
53 #define CONFIG_BOOTFILE		"uImage"
54 #define CONFIG_BOOTARGS		"console=ttyAMA0,115200"
55 #define CONFIG_BOOTCOMMAND	"bootm"
56 #define CONFIG_LOADADDR		0x42000000
57 #define CONFIG_SYS_LOAD_ADDR	CONFIG_LOADADDR
58 
59 /* Extra Environment */
60 #define CONFIG_EXTRA_ENV_SETTINGS					\
61 	"update_sd_firmware_filename=u-boot.sd\0"			\
62 	"update_sd_firmware="		/* Update the SD firmware partition */ \
63 		"if mmc rescan ; then "					\
64 		"if tftp ${update_sd_firmware_filename} ; then "	\
65 		"setexpr fw_sz ${filesize} / 0x200 ; "	/* SD block size */ \
66 		"setexpr fw_sz ${fw_sz} + 1 ; "				\
67 		"mmc write ${loadaddr} 0x800 ${fw_sz} ; "		\
68 		"fi ; "							\
69 		"fi\0"
70 
71 /* The rest of the configuration is shared */
72 #include <configs/mxs.h>
73 
74 #endif /* __CONFIGS_SC_SPS_1_H__ */
75