1 /* 2 * SchulerControl GmbH, SC_SPS_1 module config 3 * 4 * Copyright (C) 2012 Marek Vasut <marex@denx.de> 5 * on behalf of DENX Software Engineering GmbH 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 #ifndef __CONFIGS_SC_SPS_1_H__ 10 #define __CONFIGS_SC_SPS_1_H__ 11 12 /* System configuration */ 13 #define CONFIG_MX28 /* i.MX28 SoC */ 14 #define MACH_TYPE_SC_SPS_1 4172 15 #define CONFIG_MACH_TYPE MACH_TYPE_SC_SPS_1 16 17 /* U-Boot Commands */ 18 #define CONFIG_SYS_NO_FLASH 19 #define CONFIG_DISPLAY_CPUINFO 20 #define CONFIG_DOS_PARTITION 21 22 #define CONFIG_CMD_CACHE 23 #define CONFIG_CMD_DHCP 24 #define CONFIG_CMD_EXT2 25 #define CONFIG_CMD_FAT 26 #define CONFIG_CMD_GPIO 27 #define CONFIG_CMD_MII 28 #define CONFIG_CMD_MMC 29 #define CONFIG_CMD_PING 30 #define CONFIG_CMD_USB 31 32 /* Memory configuration */ 33 #define CONFIG_NR_DRAM_BANKS 1 /* 1 bank of DRAM */ 34 #define PHYS_SDRAM_1 0x40000000 /* Base address */ 35 #define PHYS_SDRAM_1_SIZE 0x40000000 /* Max 1 GB RAM */ 36 #define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1 37 38 /* Environment */ 39 #define CONFIG_ENV_SIZE (16 * 1024) 40 #define CONFIG_ENV_IS_IN_MMC 41 42 /* Environment is in MMC */ 43 #if defined(CONFIG_CMD_MMC) && defined(CONFIG_ENV_IS_IN_MMC) 44 #define CONFIG_ENV_OFFSET (256 * 1024) 45 #define CONFIG_SYS_MMC_ENV_DEV 0 46 #else 47 #define CONFIG_ENV_IS_NOWHERE 48 #endif 49 50 /* FEC Ethernet on SoC */ 51 #ifdef CONFIG_CMD_NET 52 #define CONFIG_FEC_MXC 53 #define CONFIG_PHYLIB 54 #define CONFIG_PHY_SMSC 55 #endif 56 57 /* USB */ 58 #ifdef CONFIG_CMD_USB 59 #define CONFIG_EHCI_MXS_PORT0 60 #define CONFIG_USB_MAX_CONTROLLER_COUNT 1 61 #define CONFIG_USB_STORAGE 62 #endif 63 64 /* Booting Linux */ 65 #define CONFIG_BOOTDELAY 3 66 #define CONFIG_BOOTFILE "uImage" 67 #define CONFIG_BOOTARGS "console=ttyAMA0,115200" 68 #define CONFIG_BOOTCOMMAND "bootm" 69 #define CONFIG_LOADADDR 0x42000000 70 #define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR 71 72 /* Extra Environment */ 73 #define CONFIG_EXTRA_ENV_SETTINGS \ 74 "update_sd_firmware_filename=u-boot.sd\0" \ 75 "update_sd_firmware=" /* Update the SD firmware partition */ \ 76 "if mmc rescan ; then " \ 77 "if tftp ${update_sd_firmware_filename} ; then " \ 78 "setexpr fw_sz ${filesize} / 0x200 ; " /* SD block size */ \ 79 "setexpr fw_sz ${fw_sz} + 1 ; " \ 80 "mmc write ${loadaddr} 0x800 ${fw_sz} ; " \ 81 "fi ; " \ 82 "fi\0" 83 84 /* The rest of the configuration is shared */ 85 #include <configs/mxs.h> 86 87 #endif /* __CONFIGS_SC_SPS_1_H__ */ 88