1 /* 2 * include/configs/salvator-x.h 3 * This file is Salvator-X board configuration. 4 * 5 * Copyright (C) 2015 Renesas Electronics Corporation 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 10 #ifndef __SALVATOR_X_H 11 #define __SALVATOR_X_H 12 13 #undef DEBUG 14 15 #define CONFIG_RCAR_BOARD_STRING "Salvator-X" 16 17 #include "rcar-gen3-common.h" 18 19 /* SCIF */ 20 #define CONFIG_SCIF_CONSOLE 21 #define CONFIG_CONS_SCIF2 22 #define CONFIG_CONS_INDEX 2 23 #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ 24 25 /* [A] Hyper Flash */ 26 /* use to RPC(SPI Multi I/O Bus Controller) */ 27 #define CONFIG_SYS_NO_FLASH 28 #define CONFIG_ENV_IS_NOWHERE 29 30 /* Board Clock */ 31 /* XTAL_CLK : 33.33MHz */ 32 #define RCAR_XTAL_CLK 33333333u 33 #define CONFIG_SYS_CLK_FREQ RCAR_XTAL_CLK 34 /* ch0to2 CPclk, ch3to11 S3D2_PEREclk, ch12to14 S3D2_RTclk */ 35 /* CPclk 16.66MHz, S3D2 133.33MHz */ 36 #define CONFIG_CP_CLK_FREQ (CONFIG_SYS_CLK_FREQ / 2) 37 #define CONFIG_PLL1_CLK_FREQ (CONFIG_SYS_CLK_FREQ * 192 / 2) 38 #define CONFIG_S3D2_CLK_FREQ (266666666u/2) 39 40 /* Generic Timer Definitions (use in assembler source) */ 41 #define COUNTER_FREQUENCY 0xFE502A /* 16.66MHz from CPclk */ 42 43 /* Generic Interrupt Controller Definitions */ 44 #define CONFIG_GICV2 45 #define GICD_BASE 0xF1010000 46 #define GICC_BASE 0xF1020000 47 48 /* Module stop status bits */ 49 /* MFIS, SCIF1 */ 50 #define CONFIG_SMSTP2_ENA 0x00002040 51 /* INTC-AP, IRQC */ 52 #define CONFIG_SMSTP4_ENA 0x00000180 53 54 #endif /* __SALVATOR_X_H */ 55