1 /* 2 * (C) Copyright 2013 Siemens Schweiz AG 3 * (C) Heiko Schocher, DENX Software Engineering, hs@denx.de. 4 * 5 * Based on: 6 * U-Boot file:/include/configs/am335x_evm.h 7 * 8 * Copyright (C) 2011 Texas Instruments Incorporated - http://www.ti.com/ 9 * 10 * SPDX-License-Identifier: GPL-2.0+ 11 */ 12 13 #ifndef __CONFIG_RASTABAN_H 14 #define __CONFIG_RASTABAN_H 15 16 #include "siemens-am33x-common.h" 17 18 #define DDR_PLL_FREQ 303 19 #undef CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC 20 21 /* FWD Button = 27 22 * SRV Button = 87 */ 23 #define BOARD_DFU_BUTTON_GPIO 27 24 #define GPIO_LAN9303_NRST 88 /* GPIO2_24 = gpio88 */ 25 /* In dfu mode keep led1 on */ 26 #define CONFIG_ENV_SETTINGS_BUTTONS_AND_LEDS \ 27 "button_dfu0=27\0" \ 28 "button_dfu1=87\0" \ 29 "led0=3,0,1\0" \ 30 "led1=4,0,0\0" \ 31 "led2=5,0,1\0" \ 32 "led3=62,0,1\0" \ 33 "led4=60,0,1\0" \ 34 "led5=63,0,1\0" 35 36 /* Physical Memory Map */ 37 #define CONFIG_MAX_RAM_BANK_SIZE (1024 << 20) /* 1GB */ 38 39 /* I2C Configuration */ 40 #define CONFIG_SYS_I2C_SPEED 100000 41 42 #define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 43 #define EEPROM_ADDR_DDR3 0x90 44 #define EEPROM_ADDR_CHIP 0x120 45 46 #undef CONFIG_MII 47 #define CONFIG_PHY_SMSC 48 49 #define CONFIG_FACTORYSET 50 51 /* Define own nand partitions */ 52 #define CONFIG_ENV_OFFSET_REDUND 0x2E0000 53 #define CONFIG_ENV_SIZE_REDUND 0x2000 54 #define CONFIG_ENV_RANGE (4 * CONFIG_SYS_ENV_SECT_SIZE) 55 56 #define MTDPARTS_DEFAULT MTDPARTS_DEFAULT_V3 57 58 #ifndef CONFIG_SPL_BUILD 59 60 /* Default env settings */ 61 #define CONFIG_EXTRA_ENV_SETTINGS \ 62 "hostname=rastaban\0" \ 63 "ubi_off=2048\0"\ 64 "nand_img_size=0x400000\0" \ 65 "optargs=\0" \ 66 "preboot=draco_led 0\0" \ 67 CONFIG_ENV_SETTINGS_BUTTONS_AND_LEDS \ 68 CONFIG_ENV_SETTINGS_V2 \ 69 CONFIG_ENV_SETTINGS_NAND_V2 70 71 #ifndef CONFIG_RESTORE_FLASH 72 /* set to negative value for no autoboot */ 73 74 #define CONFIG_BOOTCOMMAND \ 75 "if dfubutton; then " \ 76 "run dfu_start; " \ 77 "reset; " \ 78 "fi;" \ 79 "run nand_boot;" \ 80 "run nand_boot_backup;" \ 81 "reset;" 82 83 #else 84 85 #define CONFIG_BOOTCOMMAND \ 86 "setenv autoload no; " \ 87 "dhcp; " \ 88 "if tftp 80000000 debrick.scr; then " \ 89 "source 80000000; " \ 90 "fi" 91 #endif 92 #endif /* CONFIG_SPL_BUILD */ 93 #endif /* ! __CONFIG_RASTABAN_H */ 94