1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * Configuation settings for the Renesas Solutions r0p7734 board 4 * 5 * Copyright (C) 2010, 2011 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com> 6 */ 7 8 #ifndef __R0P7734_H 9 #define __R0P7734_H 10 11 #define CONFIG_CPU_SH7734 1 12 #define CONFIG_400MHZ_MODE 1 13 14 #define CONFIG_DISPLAY_BOARDINFO 15 #undef CONFIG_SHOW_BOOT_PROGRESS 16 17 /* Ether */ 18 #define CONFIG_SH_ETHER_USE_PORT (0) 19 #define CONFIG_SH_ETHER_PHY_ADDR (0x0) 20 #define CONFIG_PHY_SMSC 1 21 #define CONFIG_BITBANGMII 22 #define CONFIG_BITBANGMII_MULTI 23 #define CONFIG_SH_ETHER_SH7734_MII (0x00) /* MII */ 24 #define CONFIG_SH_ETHER_PHY_MODE PHY_INTERFACE_MODE_MII 25 26 /* undef to save memory */ 27 /* List of legal baudrate settings for this board */ 28 #define CONFIG_SYS_BAUDRATE_TABLE { 115200 } 29 30 /* SCIF */ 31 #define CONFIG_SCIF 1 32 #define CONFIG_CONS_SCIF3 1 33 34 /* Suppress display of console information at boot */ 35 36 /* SDRAM */ 37 #define CONFIG_SYS_SDRAM_BASE (0x88000000) 38 #define CONFIG_SYS_SDRAM_SIZE (128 * 1024 * 1024) 39 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024) 40 41 #define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE) 42 #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + 100 * 1024 * 1024) 43 /* Enable alternate, more extensive, memory test */ 44 /* Scratch address used by the alternate memory test */ 45 #undef CONFIG_SYS_MEMTEST_SCRATCH 46 47 /* Enable temporary baudrate change while serial download */ 48 #undef CONFIG_SYS_LOADS_BAUD_CHANGE 49 50 /* FLASH */ 51 #define CONFIG_FLASH_CFI_DRIVER 1 52 #define CONFIG_SYS_FLASH_CFI 53 #undef CONFIG_SYS_FLASH_QUIET_TEST 54 #define CONFIG_SYS_FLASH_EMPTY_INFO 55 #define CONFIG_SYS_FLASH_BASE (0xA0000000) 56 #define CONFIG_SYS_MAX_FLASH_SECT 512 57 58 /* if you use all NOR Flash , you change dip-switch. Please see Manual. */ 59 #define CONFIG_SYS_MAX_FLASH_BANKS 1 60 #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE } 61 62 /* Timeout for Flash erase operations (in ms) */ 63 #define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000) 64 /* Timeout for Flash write operations (in ms) */ 65 #define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000) 66 /* Timeout for Flash set sector lock bit operations (in ms) */ 67 #define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000) 68 /* Timeout for Flash clear lock bit operations (in ms) */ 69 #define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000) 70 71 /* 72 * Use hardware flash sectors protection instead 73 * of U-Boot software protection 74 */ 75 #undef CONFIG_SYS_FLASH_PROTECTION 76 #undef CONFIG_SYS_DIRECT_FLASH_TFTP 77 78 /* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */ 79 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE) 80 /* Monitor size */ 81 #define CONFIG_SYS_MONITOR_LEN (256 * 1024) 82 /* Size of DRAM reserved for malloc() use */ 83 #define CONFIG_SYS_MALLOC_LEN (256 * 1024) 84 #define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024) 85 86 /* ENV setting */ 87 #define CONFIG_ENV_OVERWRITE 1 88 #define CONFIG_ENV_SECT_SIZE (128 * 1024) 89 #define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE) 90 #define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN) 91 /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */ 92 #define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE) 93 #define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE) 94 95 /* Board Clock */ 96 #if defined(CONFIG_400MHZ_MODE) 97 #define CONFIG_SYS_CLK_FREQ 50000000 98 #else 99 #define CONFIG_SYS_CLK_FREQ 44444444 100 #endif 101 #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ 102 103 #endif /* __R0P7734_H */ 104