1 /* 2 * Copyright 2016 Freescale Semiconductor 3 * 4 * SPDX-License-Identifier: GPL-2.0+ 5 */ 6 7 #ifndef __LS1046ARDB_H__ 8 #define __LS1046ARDB_H__ 9 10 #include "ls1046a_common.h" 11 12 #ifdef CONFIG_SD_BOOT 13 #define CONFIG_SYS_TEXT_BASE 0x82000000 14 #else 15 #define CONFIG_SYS_TEXT_BASE 0x40100000 16 #endif 17 18 #define CONFIG_SYS_CLK_FREQ 100000000 19 #define CONFIG_DDR_CLK_FREQ 100000000 20 21 #define CONFIG_LAYERSCAPE_NS_ACCESS 22 #define CONFIG_MISC_INIT_R 23 24 #define CONFIG_DIMM_SLOTS_PER_CTLR 1 25 /* Physical Memory Map */ 26 #define CONFIG_CHIP_SELECTS_PER_CTRL 4 27 #define CONFIG_NR_DRAM_BANKS 2 28 29 #define CONFIG_DDR_SPD 30 #define SPD_EEPROM_ADDRESS 0x51 31 #define CONFIG_SYS_SPD_BUS_NUM 0 32 33 #define CONFIG_DDR_ECC 34 #define CONFIG_ECC_INIT_VIA_DDRCONTROLLER 35 #define CONFIG_MEM_INIT_VALUE 0xdeadbeef 36 #define CONFIG_FSL_DDR_BIST /* enable built-in memory test */ 37 #ifndef CONFIG_SPL 38 #define CONFIG_FSL_DDR_INTERACTIVE /* Interactive debugging */ 39 #endif 40 41 #ifdef CONFIG_RAMBOOT_PBL 42 #define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1046ardb/ls1046ardb_pbi.cfg 43 #endif 44 45 #ifdef CONFIG_SD_BOOT 46 #ifdef CONFIG_EMMC_BOOT 47 #define CONFIG_SYS_FSL_PBL_RCW \ 48 board/freescale/ls1046ardb/ls1046ardb_rcw_emmc.cfg 49 #else 50 #define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1046ardb/ls1046ardb_rcw_sd.cfg 51 #endif 52 #endif 53 54 #ifndef SPL_NO_IFC 55 /* IFC */ 56 #define CONFIG_FSL_IFC 57 /* 58 * NAND Flash Definitions 59 */ 60 #define CONFIG_NAND_FSL_IFC 61 #endif 62 63 #define CONFIG_SYS_NAND_BASE 0x7e800000 64 #define CONFIG_SYS_NAND_BASE_PHYS CONFIG_SYS_NAND_BASE 65 66 #define CONFIG_SYS_NAND_CSPR_EXT (0x0) 67 #define CONFIG_SYS_NAND_CSPR (CSPR_PHYS_ADDR(CONFIG_SYS_NAND_BASE_PHYS) \ 68 | CSPR_PORT_SIZE_8 \ 69 | CSPR_MSEL_NAND \ 70 | CSPR_V) 71 #define CONFIG_SYS_NAND_AMASK IFC_AMASK(64 * 1024) 72 #define CONFIG_SYS_NAND_CSOR (CSOR_NAND_ECC_ENC_EN /* ECC on encode */ \ 73 | CSOR_NAND_ECC_DEC_EN /* ECC on decode */ \ 74 | CSOR_NAND_ECC_MODE_8 /* 8-bit ECC */ \ 75 | CSOR_NAND_RAL_3 /* RAL = 3 Bytes */ \ 76 | CSOR_NAND_PGS_4K /* Page Size = 4K */ \ 77 | CSOR_NAND_SPRZ_224 /* Spare size = 224 */ \ 78 | CSOR_NAND_PB(64)) /* 64 Pages Per Block */ 79 80 #define CONFIG_SYS_NAND_ONFI_DETECTION 81 82 #define CONFIG_SYS_NAND_FTIM0 (FTIM0_NAND_TCCST(0x7) | \ 83 FTIM0_NAND_TWP(0x18) | \ 84 FTIM0_NAND_TWCHT(0x7) | \ 85 FTIM0_NAND_TWH(0xa)) 86 #define CONFIG_SYS_NAND_FTIM1 (FTIM1_NAND_TADLE(0x32) | \ 87 FTIM1_NAND_TWBE(0x39) | \ 88 FTIM1_NAND_TRR(0xe) | \ 89 FTIM1_NAND_TRP(0x18)) 90 #define CONFIG_SYS_NAND_FTIM2 (FTIM2_NAND_TRAD(0xf) | \ 91 FTIM2_NAND_TREH(0xa) | \ 92 FTIM2_NAND_TWHRE(0x1e)) 93 #define CONFIG_SYS_NAND_FTIM3 0x0 94 95 #define CONFIG_SYS_NAND_BASE_LIST { CONFIG_SYS_NAND_BASE } 96 #define CONFIG_SYS_MAX_NAND_DEVICE 1 97 #define CONFIG_MTD_NAND_VERIFY_WRITE 98 99 #define CONFIG_SYS_NAND_BLOCK_SIZE (128 * 1024) 100 101 /* 102 * CPLD 103 */ 104 #define CONFIG_SYS_CPLD_BASE 0x7fb00000 105 #define CPLD_BASE_PHYS CONFIG_SYS_CPLD_BASE 106 107 #define CONFIG_SYS_CPLD_CSPR_EXT (0x0) 108 #define CONFIG_SYS_CPLD_CSPR (CSPR_PHYS_ADDR(CPLD_BASE_PHYS) | \ 109 CSPR_PORT_SIZE_8 | \ 110 CSPR_MSEL_GPCM | \ 111 CSPR_V) 112 #define CONFIG_SYS_CPLD_AMASK IFC_AMASK(64 * 1024) 113 #define CONFIG_SYS_CPLD_CSOR CSOR_NOR_ADM_SHIFT(16) 114 115 /* CPLD Timing parameters for IFC GPCM */ 116 #define CONFIG_SYS_CPLD_FTIM0 (FTIM0_GPCM_TACSE(0x0e) | \ 117 FTIM0_GPCM_TEADC(0x0e) | \ 118 FTIM0_GPCM_TEAHC(0x0e)) 119 #define CONFIG_SYS_CPLD_FTIM1 (FTIM1_GPCM_TACO(0xff) | \ 120 FTIM1_GPCM_TRAD(0x3f)) 121 #define CONFIG_SYS_CPLD_FTIM2 (FTIM2_GPCM_TCS(0xf) | \ 122 FTIM2_GPCM_TCH(0xf) | \ 123 FTIM2_GPCM_TWP(0x3E)) 124 #define CONFIG_SYS_CPLD_FTIM3 0x0 125 126 /* IFC Timing Params */ 127 #define CONFIG_SYS_CSPR0_EXT CONFIG_SYS_NAND_CSPR_EXT 128 #define CONFIG_SYS_CSPR0 CONFIG_SYS_NAND_CSPR 129 #define CONFIG_SYS_AMASK0 CONFIG_SYS_NAND_AMASK 130 #define CONFIG_SYS_CSOR0 CONFIG_SYS_NAND_CSOR 131 #define CONFIG_SYS_CS0_FTIM0 CONFIG_SYS_NAND_FTIM0 132 #define CONFIG_SYS_CS0_FTIM1 CONFIG_SYS_NAND_FTIM1 133 #define CONFIG_SYS_CS0_FTIM2 CONFIG_SYS_NAND_FTIM2 134 #define CONFIG_SYS_CS0_FTIM3 CONFIG_SYS_NAND_FTIM3 135 136 #define CONFIG_SYS_CSPR2_EXT CONFIG_SYS_CPLD_CSPR_EXT 137 #define CONFIG_SYS_CSPR2 CONFIG_SYS_CPLD_CSPR 138 #define CONFIG_SYS_AMASK2 CONFIG_SYS_CPLD_AMASK 139 #define CONFIG_SYS_CSOR2 CONFIG_SYS_CPLD_CSOR 140 #define CONFIG_SYS_CS2_FTIM0 CONFIG_SYS_CPLD_FTIM0 141 #define CONFIG_SYS_CS2_FTIM1 CONFIG_SYS_CPLD_FTIM1 142 #define CONFIG_SYS_CS2_FTIM2 CONFIG_SYS_CPLD_FTIM2 143 #define CONFIG_SYS_CS2_FTIM3 CONFIG_SYS_CPLD_FTIM3 144 145 /* EEPROM */ 146 #define CONFIG_ID_EEPROM 147 #define CONFIG_SYS_I2C_EEPROM_NXID 148 #define CONFIG_SYS_EEPROM_BUS_NUM 0 149 #define CONFIG_SYS_I2C_EEPROM_ADDR 0x53 150 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 151 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3 152 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5 153 #define I2C_RETIMER_ADDR 0x18 154 155 /* PMIC */ 156 #define CONFIG_POWER 157 #ifdef CONFIG_POWER 158 #define CONFIG_POWER_I2C 159 #endif 160 161 /* 162 * Environment 163 */ 164 #ifndef SPL_NO_ENV 165 #define CONFIG_ENV_OVERWRITE 166 #endif 167 168 #if defined(CONFIG_SD_BOOT) 169 #define CONFIG_SYS_MMC_ENV_DEV 0 170 #define CONFIG_ENV_OFFSET (3 * 1024 * 1024) 171 #define CONFIG_ENV_SIZE 0x2000 172 #else 173 #define CONFIG_ENV_SIZE 0x2000 /* 8KB */ 174 #define CONFIG_ENV_OFFSET 0x300000 /* 3MB */ 175 #define CONFIG_ENV_SECT_SIZE 0x40000 /* 256KB */ 176 #endif 177 178 #define AQR105_IRQ_MASK 0x80000000 179 /* FMan */ 180 #ifndef SPL_NO_FMAN 181 182 #ifdef CONFIG_NET 183 #define CONFIG_PHY_REALTEK 184 #endif 185 186 #ifdef CONFIG_SYS_DPAA_FMAN 187 #define CONFIG_FMAN_ENET 188 #define CONFIG_PHY_AQUANTIA 189 #define CONFIG_PHYLIB_10G 190 #define RGMII_PHY1_ADDR 0x1 191 #define RGMII_PHY2_ADDR 0x2 192 193 #define SGMII_PHY1_ADDR 0x3 194 #define SGMII_PHY2_ADDR 0x4 195 196 #define FM1_10GEC1_PHY_ADDR 0x0 197 198 #define CONFIG_ETHPRIME "FM1@DTSEC3" 199 #endif 200 201 #endif 202 203 /* QSPI device */ 204 #ifndef SPL_NO_QSPI 205 #ifdef CONFIG_FSL_QSPI 206 #define CONFIG_SPI_FLASH_SPANSION 207 #define FSL_QSPI_FLASH_SIZE (1 << 26) 208 #define FSL_QSPI_FLASH_NUM 2 209 #endif 210 #endif 211 212 /* USB */ 213 #ifndef SPL_NO_USB 214 #define CONFIG_HAS_FSL_XHCI_USB 215 #ifdef CONFIG_HAS_FSL_XHCI_USB 216 #define CONFIG_USB_XHCI_FSL 217 #define CONFIG_USB_MAX_CONTROLLER_COUNT 3 218 #endif 219 #endif 220 221 /* SATA */ 222 #ifndef SPL_NO_SATA 223 #define CONFIG_LIBATA 224 #define CONFIG_SCSI_AHCI 225 #define CONFIG_SCSI_AHCI_PLAT 226 227 #define CONFIG_SYS_SATA AHCI_BASE_ADDR 228 229 #define CONFIG_SYS_SCSI_MAX_SCSI_ID 1 230 #define CONFIG_SYS_SCSI_MAX_LUN 1 231 #define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \ 232 CONFIG_SYS_SCSI_MAX_LUN) 233 #endif 234 235 #ifndef SPL_NO_MISC 236 #undef CONFIG_BOOTCOMMAND 237 #define CONFIG_BOOTCOMMAND "run distro_bootcmd; env exists secureboot" \ 238 "&& esbc_halt; run qspi_bootcmd;" 239 #define MTDPARTS_DEFAULT "mtdparts=1550000.quadspi:1m(rcw)," \ 240 "15m(u-boot),48m(kernel.itb);" \ 241 "7e800000.flash:16m(nand_uboot)," \ 242 "48m(nand_kernel),448m(nand_free)" 243 #endif 244 245 #include <asm/fsl_secure_boot.h> 246 247 #endif /* __LS1046ARDB_H__ */ 248