xref: /openbmc/u-boot/include/configs/ls1046ardb.h (revision 87a62bce)
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Copyright 2016 Freescale Semiconductor
4  */
5 
6 #ifndef __LS1046ARDB_H__
7 #define __LS1046ARDB_H__
8 
9 #include "ls1046a_common.h"
10 
11 #define CONFIG_SYS_CLK_FREQ		100000000
12 #define CONFIG_DDR_CLK_FREQ		100000000
13 
14 #define CONFIG_LAYERSCAPE_NS_ACCESS
15 #define CONFIG_MISC_INIT_R
16 
17 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
18 /* Physical Memory Map */
19 #define CONFIG_CHIP_SELECTS_PER_CTRL	4
20 #define CONFIG_NR_DRAM_BANKS		2
21 
22 #define CONFIG_DDR_SPD
23 #define SPD_EEPROM_ADDRESS		0x51
24 #define CONFIG_SYS_SPD_BUS_NUM		0
25 
26 #define CONFIG_DDR_ECC
27 #define CONFIG_ECC_INIT_VIA_DDRCONTROLLER
28 #define CONFIG_MEM_INIT_VALUE           0xdeadbeef
29 #define CONFIG_FSL_DDR_BIST	/* enable built-in memory test */
30 #ifndef CONFIG_SPL
31 #define CONFIG_FSL_DDR_INTERACTIVE	/* Interactive debugging */
32 #endif
33 
34 #ifdef CONFIG_RAMBOOT_PBL
35 #define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1046ardb/ls1046ardb_pbi.cfg
36 #endif
37 
38 #ifdef CONFIG_SD_BOOT
39 #ifdef CONFIG_EMMC_BOOT
40 #define CONFIG_SYS_FSL_PBL_RCW \
41 	board/freescale/ls1046ardb/ls1046ardb_rcw_emmc.cfg
42 #else
43 #define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1046ardb/ls1046ardb_rcw_sd.cfg
44 #endif
45 #endif
46 
47 #ifndef SPL_NO_IFC
48 /* IFC */
49 #define CONFIG_FSL_IFC
50 /*
51  * NAND Flash Definitions
52  */
53 #define CONFIG_NAND_FSL_IFC
54 #endif
55 
56 #define CONFIG_SYS_NAND_BASE		0x7e800000
57 #define CONFIG_SYS_NAND_BASE_PHYS	CONFIG_SYS_NAND_BASE
58 
59 #define CONFIG_SYS_NAND_CSPR_EXT	(0x0)
60 #define CONFIG_SYS_NAND_CSPR	(CSPR_PHYS_ADDR(CONFIG_SYS_NAND_BASE_PHYS) \
61 				| CSPR_PORT_SIZE_8	\
62 				| CSPR_MSEL_NAND	\
63 				| CSPR_V)
64 #define CONFIG_SYS_NAND_AMASK	IFC_AMASK(64 * 1024)
65 #define CONFIG_SYS_NAND_CSOR	(CSOR_NAND_ECC_ENC_EN	/* ECC on encode */ \
66 				| CSOR_NAND_ECC_DEC_EN	/* ECC on decode */ \
67 				| CSOR_NAND_ECC_MODE_8	/* 8-bit ECC */ \
68 				| CSOR_NAND_RAL_3	/* RAL = 3 Bytes */ \
69 				| CSOR_NAND_PGS_4K	/* Page Size = 4K */ \
70 				| CSOR_NAND_SPRZ_224	/* Spare size = 224 */ \
71 				| CSOR_NAND_PB(64))	/* 64 Pages Per Block */
72 
73 #define CONFIG_SYS_NAND_ONFI_DETECTION
74 
75 #define CONFIG_SYS_NAND_FTIM0		(FTIM0_NAND_TCCST(0x7) | \
76 					FTIM0_NAND_TWP(0x18)   | \
77 					FTIM0_NAND_TWCHT(0x7) | \
78 					FTIM0_NAND_TWH(0xa))
79 #define CONFIG_SYS_NAND_FTIM1		(FTIM1_NAND_TADLE(0x32) | \
80 					FTIM1_NAND_TWBE(0x39)  | \
81 					FTIM1_NAND_TRR(0xe)   | \
82 					FTIM1_NAND_TRP(0x18))
83 #define CONFIG_SYS_NAND_FTIM2		(FTIM2_NAND_TRAD(0xf) | \
84 					FTIM2_NAND_TREH(0xa) | \
85 					FTIM2_NAND_TWHRE(0x1e))
86 #define CONFIG_SYS_NAND_FTIM3		0x0
87 
88 #define CONFIG_SYS_NAND_BASE_LIST	{ CONFIG_SYS_NAND_BASE }
89 #define CONFIG_SYS_MAX_NAND_DEVICE	1
90 #define CONFIG_MTD_NAND_VERIFY_WRITE
91 
92 #define CONFIG_SYS_NAND_BLOCK_SIZE	(128 * 1024)
93 
94 /*
95  * CPLD
96  */
97 #define CONFIG_SYS_CPLD_BASE		0x7fb00000
98 #define CPLD_BASE_PHYS			CONFIG_SYS_CPLD_BASE
99 
100 #define CONFIG_SYS_CPLD_CSPR_EXT	(0x0)
101 #define CONFIG_SYS_CPLD_CSPR		(CSPR_PHYS_ADDR(CPLD_BASE_PHYS) | \
102 					CSPR_PORT_SIZE_8 | \
103 					CSPR_MSEL_GPCM | \
104 					CSPR_V)
105 #define CONFIG_SYS_CPLD_AMASK		IFC_AMASK(64 * 1024)
106 #define CONFIG_SYS_CPLD_CSOR		CSOR_NOR_ADM_SHIFT(16)
107 
108 /* CPLD Timing parameters for IFC GPCM */
109 #define CONFIG_SYS_CPLD_FTIM0		(FTIM0_GPCM_TACSE(0x0e) | \
110 					FTIM0_GPCM_TEADC(0x0e) | \
111 					FTIM0_GPCM_TEAHC(0x0e))
112 #define CONFIG_SYS_CPLD_FTIM1		(FTIM1_GPCM_TACO(0xff) | \
113 					FTIM1_GPCM_TRAD(0x3f))
114 #define CONFIG_SYS_CPLD_FTIM2		(FTIM2_GPCM_TCS(0xf) | \
115 					FTIM2_GPCM_TCH(0xf) | \
116 					FTIM2_GPCM_TWP(0x3E))
117 #define CONFIG_SYS_CPLD_FTIM3		0x0
118 
119 /* IFC Timing Params */
120 #define CONFIG_SYS_CSPR0_EXT		CONFIG_SYS_NAND_CSPR_EXT
121 #define CONFIG_SYS_CSPR0		CONFIG_SYS_NAND_CSPR
122 #define CONFIG_SYS_AMASK0		CONFIG_SYS_NAND_AMASK
123 #define CONFIG_SYS_CSOR0		CONFIG_SYS_NAND_CSOR
124 #define CONFIG_SYS_CS0_FTIM0		CONFIG_SYS_NAND_FTIM0
125 #define CONFIG_SYS_CS0_FTIM1		CONFIG_SYS_NAND_FTIM1
126 #define CONFIG_SYS_CS0_FTIM2		CONFIG_SYS_NAND_FTIM2
127 #define CONFIG_SYS_CS0_FTIM3		CONFIG_SYS_NAND_FTIM3
128 
129 #define CONFIG_SYS_CSPR2_EXT		CONFIG_SYS_CPLD_CSPR_EXT
130 #define CONFIG_SYS_CSPR2		CONFIG_SYS_CPLD_CSPR
131 #define CONFIG_SYS_AMASK2		CONFIG_SYS_CPLD_AMASK
132 #define CONFIG_SYS_CSOR2		CONFIG_SYS_CPLD_CSOR
133 #define CONFIG_SYS_CS2_FTIM0		CONFIG_SYS_CPLD_FTIM0
134 #define CONFIG_SYS_CS2_FTIM1		CONFIG_SYS_CPLD_FTIM1
135 #define CONFIG_SYS_CS2_FTIM2		CONFIG_SYS_CPLD_FTIM2
136 #define CONFIG_SYS_CS2_FTIM3		CONFIG_SYS_CPLD_FTIM3
137 
138 /* EEPROM */
139 #define CONFIG_ID_EEPROM
140 #define CONFIG_SYS_I2C_EEPROM_NXID
141 #define CONFIG_SYS_EEPROM_BUS_NUM		0
142 #define CONFIG_SYS_I2C_EEPROM_ADDR		0x53
143 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN		1
144 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS	3
145 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS	5
146 #define I2C_RETIMER_ADDR			0x18
147 
148 /* PMIC */
149 #define CONFIG_POWER
150 #ifdef CONFIG_POWER
151 #define CONFIG_POWER_I2C
152 #endif
153 
154 /*
155  * Environment
156  */
157 #ifndef SPL_NO_ENV
158 #define CONFIG_ENV_OVERWRITE
159 #endif
160 
161 #if defined(CONFIG_SD_BOOT)
162 #define CONFIG_SYS_MMC_ENV_DEV		0
163 #define CONFIG_ENV_OFFSET		(3 * 1024 * 1024)
164 #define CONFIG_ENV_SIZE			0x2000
165 #else
166 #define CONFIG_ENV_SIZE			0x2000		/* 8KB */
167 #define CONFIG_ENV_OFFSET		0x300000	/* 3MB */
168 #define CONFIG_ENV_SECT_SIZE		0x40000		/* 256KB */
169 #endif
170 
171 #define AQR105_IRQ_MASK			0x80000000
172 /* FMan */
173 #ifndef SPL_NO_FMAN
174 
175 #ifdef CONFIG_NET
176 #define CONFIG_PHY_REALTEK
177 #endif
178 
179 #ifdef CONFIG_SYS_DPAA_FMAN
180 #define CONFIG_FMAN_ENET
181 #define CONFIG_PHY_AQUANTIA
182 #define CONFIG_PHYLIB_10G
183 #define RGMII_PHY1_ADDR			0x1
184 #define RGMII_PHY2_ADDR			0x2
185 
186 #define SGMII_PHY1_ADDR			0x3
187 #define SGMII_PHY2_ADDR			0x4
188 
189 #define FM1_10GEC1_PHY_ADDR		0x0
190 
191 #define FDT_SEQ_MACADDR_FROM_ENV
192 
193 #define CONFIG_ETHPRIME			"FM1@DTSEC3"
194 #endif
195 
196 #endif
197 
198 /* QSPI device */
199 #ifndef SPL_NO_QSPI
200 #ifdef CONFIG_FSL_QSPI
201 #define CONFIG_SPI_FLASH_SPANSION
202 #define FSL_QSPI_FLASH_SIZE		(1 << 26)
203 #define FSL_QSPI_FLASH_NUM		2
204 #endif
205 #endif
206 
207 #ifndef SPL_NO_MISC
208 #undef CONFIG_BOOTCOMMAND
209 #if defined(CONFIG_QSPI_BOOT)
210 #define CONFIG_BOOTCOMMAND "run distro_bootcmd; run qspi_bootcmd; "	\
211 			   "env exists secureboot && esbc_halt;;"
212 #elif defined(CONFIG_SD_BOOT)
213 #define CONFIG_BOOTCOMMAND "run distro_bootcmd;run sd_bootcmd; "	\
214 			   "env exists secureboot && esbc_halt;"
215 #endif
216 #endif
217 
218 #include <asm/fsl_secure_boot.h>
219 
220 #endif /* __LS1046ARDB_H__ */
221