xref: /openbmc/u-boot/include/configs/ls1046ardb.h (revision 85231c08)
1 /*
2  * Copyright 2016 Freescale Semiconductor
3  *
4  * SPDX-License-Identifier:	GPL-2.0+
5  */
6 
7 #ifndef __LS1046ARDB_H__
8 #define __LS1046ARDB_H__
9 
10 #include "ls1046a_common.h"
11 
12 #define CONFIG_SYS_CLK_FREQ		100000000
13 #define CONFIG_DDR_CLK_FREQ		100000000
14 
15 #define CONFIG_LAYERSCAPE_NS_ACCESS
16 #define CONFIG_MISC_INIT_R
17 
18 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
19 /* Physical Memory Map */
20 #define CONFIG_CHIP_SELECTS_PER_CTRL	4
21 #define CONFIG_NR_DRAM_BANKS		2
22 
23 #define CONFIG_DDR_SPD
24 #define SPD_EEPROM_ADDRESS		0x51
25 #define CONFIG_SYS_SPD_BUS_NUM		0
26 
27 #define CONFIG_DDR_ECC
28 #define CONFIG_ECC_INIT_VIA_DDRCONTROLLER
29 #define CONFIG_MEM_INIT_VALUE           0xdeadbeef
30 #define CONFIG_FSL_DDR_BIST	/* enable built-in memory test */
31 #ifndef CONFIG_SPL
32 #define CONFIG_FSL_DDR_INTERACTIVE	/* Interactive debugging */
33 #endif
34 
35 #ifdef CONFIG_RAMBOOT_PBL
36 #define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1046ardb/ls1046ardb_pbi.cfg
37 #endif
38 
39 #ifdef CONFIG_SD_BOOT
40 #ifdef CONFIG_EMMC_BOOT
41 #define CONFIG_SYS_FSL_PBL_RCW \
42 	board/freescale/ls1046ardb/ls1046ardb_rcw_emmc.cfg
43 #else
44 #define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1046ardb/ls1046ardb_rcw_sd.cfg
45 #endif
46 #endif
47 
48 #ifndef SPL_NO_IFC
49 /* IFC */
50 #define CONFIG_FSL_IFC
51 /*
52  * NAND Flash Definitions
53  */
54 #define CONFIG_NAND_FSL_IFC
55 #endif
56 
57 #define CONFIG_SYS_NAND_BASE		0x7e800000
58 #define CONFIG_SYS_NAND_BASE_PHYS	CONFIG_SYS_NAND_BASE
59 
60 #define CONFIG_SYS_NAND_CSPR_EXT	(0x0)
61 #define CONFIG_SYS_NAND_CSPR	(CSPR_PHYS_ADDR(CONFIG_SYS_NAND_BASE_PHYS) \
62 				| CSPR_PORT_SIZE_8	\
63 				| CSPR_MSEL_NAND	\
64 				| CSPR_V)
65 #define CONFIG_SYS_NAND_AMASK	IFC_AMASK(64 * 1024)
66 #define CONFIG_SYS_NAND_CSOR	(CSOR_NAND_ECC_ENC_EN	/* ECC on encode */ \
67 				| CSOR_NAND_ECC_DEC_EN	/* ECC on decode */ \
68 				| CSOR_NAND_ECC_MODE_8	/* 8-bit ECC */ \
69 				| CSOR_NAND_RAL_3	/* RAL = 3 Bytes */ \
70 				| CSOR_NAND_PGS_4K	/* Page Size = 4K */ \
71 				| CSOR_NAND_SPRZ_224	/* Spare size = 224 */ \
72 				| CSOR_NAND_PB(64))	/* 64 Pages Per Block */
73 
74 #define CONFIG_SYS_NAND_ONFI_DETECTION
75 
76 #define CONFIG_SYS_NAND_FTIM0		(FTIM0_NAND_TCCST(0x7) | \
77 					FTIM0_NAND_TWP(0x18)   | \
78 					FTIM0_NAND_TWCHT(0x7) | \
79 					FTIM0_NAND_TWH(0xa))
80 #define CONFIG_SYS_NAND_FTIM1		(FTIM1_NAND_TADLE(0x32) | \
81 					FTIM1_NAND_TWBE(0x39)  | \
82 					FTIM1_NAND_TRR(0xe)   | \
83 					FTIM1_NAND_TRP(0x18))
84 #define CONFIG_SYS_NAND_FTIM2		(FTIM2_NAND_TRAD(0xf) | \
85 					FTIM2_NAND_TREH(0xa) | \
86 					FTIM2_NAND_TWHRE(0x1e))
87 #define CONFIG_SYS_NAND_FTIM3		0x0
88 
89 #define CONFIG_SYS_NAND_BASE_LIST	{ CONFIG_SYS_NAND_BASE }
90 #define CONFIG_SYS_MAX_NAND_DEVICE	1
91 #define CONFIG_MTD_NAND_VERIFY_WRITE
92 
93 #define CONFIG_SYS_NAND_BLOCK_SIZE	(128 * 1024)
94 
95 /*
96  * CPLD
97  */
98 #define CONFIG_SYS_CPLD_BASE		0x7fb00000
99 #define CPLD_BASE_PHYS			CONFIG_SYS_CPLD_BASE
100 
101 #define CONFIG_SYS_CPLD_CSPR_EXT	(0x0)
102 #define CONFIG_SYS_CPLD_CSPR		(CSPR_PHYS_ADDR(CPLD_BASE_PHYS) | \
103 					CSPR_PORT_SIZE_8 | \
104 					CSPR_MSEL_GPCM | \
105 					CSPR_V)
106 #define CONFIG_SYS_CPLD_AMASK		IFC_AMASK(64 * 1024)
107 #define CONFIG_SYS_CPLD_CSOR		CSOR_NOR_ADM_SHIFT(16)
108 
109 /* CPLD Timing parameters for IFC GPCM */
110 #define CONFIG_SYS_CPLD_FTIM0		(FTIM0_GPCM_TACSE(0x0e) | \
111 					FTIM0_GPCM_TEADC(0x0e) | \
112 					FTIM0_GPCM_TEAHC(0x0e))
113 #define CONFIG_SYS_CPLD_FTIM1		(FTIM1_GPCM_TACO(0xff) | \
114 					FTIM1_GPCM_TRAD(0x3f))
115 #define CONFIG_SYS_CPLD_FTIM2		(FTIM2_GPCM_TCS(0xf) | \
116 					FTIM2_GPCM_TCH(0xf) | \
117 					FTIM2_GPCM_TWP(0x3E))
118 #define CONFIG_SYS_CPLD_FTIM3		0x0
119 
120 /* IFC Timing Params */
121 #define CONFIG_SYS_CSPR0_EXT		CONFIG_SYS_NAND_CSPR_EXT
122 #define CONFIG_SYS_CSPR0		CONFIG_SYS_NAND_CSPR
123 #define CONFIG_SYS_AMASK0		CONFIG_SYS_NAND_AMASK
124 #define CONFIG_SYS_CSOR0		CONFIG_SYS_NAND_CSOR
125 #define CONFIG_SYS_CS0_FTIM0		CONFIG_SYS_NAND_FTIM0
126 #define CONFIG_SYS_CS0_FTIM1		CONFIG_SYS_NAND_FTIM1
127 #define CONFIG_SYS_CS0_FTIM2		CONFIG_SYS_NAND_FTIM2
128 #define CONFIG_SYS_CS0_FTIM3		CONFIG_SYS_NAND_FTIM3
129 
130 #define CONFIG_SYS_CSPR2_EXT		CONFIG_SYS_CPLD_CSPR_EXT
131 #define CONFIG_SYS_CSPR2		CONFIG_SYS_CPLD_CSPR
132 #define CONFIG_SYS_AMASK2		CONFIG_SYS_CPLD_AMASK
133 #define CONFIG_SYS_CSOR2		CONFIG_SYS_CPLD_CSOR
134 #define CONFIG_SYS_CS2_FTIM0		CONFIG_SYS_CPLD_FTIM0
135 #define CONFIG_SYS_CS2_FTIM1		CONFIG_SYS_CPLD_FTIM1
136 #define CONFIG_SYS_CS2_FTIM2		CONFIG_SYS_CPLD_FTIM2
137 #define CONFIG_SYS_CS2_FTIM3		CONFIG_SYS_CPLD_FTIM3
138 
139 /* EEPROM */
140 #define CONFIG_ID_EEPROM
141 #define CONFIG_SYS_I2C_EEPROM_NXID
142 #define CONFIG_SYS_EEPROM_BUS_NUM		0
143 #define CONFIG_SYS_I2C_EEPROM_ADDR		0x53
144 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN		1
145 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS	3
146 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS	5
147 #define I2C_RETIMER_ADDR			0x18
148 
149 /* PMIC */
150 #define CONFIG_POWER
151 #ifdef CONFIG_POWER
152 #define CONFIG_POWER_I2C
153 #endif
154 
155 /*
156  * Environment
157  */
158 #ifndef SPL_NO_ENV
159 #define CONFIG_ENV_OVERWRITE
160 #endif
161 
162 #if defined(CONFIG_SD_BOOT)
163 #define CONFIG_SYS_MMC_ENV_DEV		0
164 #define CONFIG_ENV_OFFSET		(3 * 1024 * 1024)
165 #define CONFIG_ENV_SIZE			0x2000
166 #else
167 #define CONFIG_ENV_SIZE			0x2000		/* 8KB */
168 #define CONFIG_ENV_OFFSET		0x300000	/* 3MB */
169 #define CONFIG_ENV_SECT_SIZE		0x40000		/* 256KB */
170 #endif
171 
172 #define AQR105_IRQ_MASK			0x80000000
173 /* FMan */
174 #ifndef SPL_NO_FMAN
175 
176 #ifdef CONFIG_NET
177 #define CONFIG_PHY_REALTEK
178 #endif
179 
180 #ifdef CONFIG_SYS_DPAA_FMAN
181 #define CONFIG_FMAN_ENET
182 #define CONFIG_PHY_AQUANTIA
183 #define CONFIG_PHYLIB_10G
184 #define RGMII_PHY1_ADDR			0x1
185 #define RGMII_PHY2_ADDR			0x2
186 
187 #define SGMII_PHY1_ADDR			0x3
188 #define SGMII_PHY2_ADDR			0x4
189 
190 #define FM1_10GEC1_PHY_ADDR		0x0
191 
192 #define FDT_SEQ_MACADDR_FROM_ENV
193 
194 #define CONFIG_ETHPRIME			"FM1@DTSEC3"
195 #endif
196 
197 #endif
198 
199 /* QSPI device */
200 #ifndef SPL_NO_QSPI
201 #ifdef CONFIG_FSL_QSPI
202 #define CONFIG_SPI_FLASH_SPANSION
203 #define FSL_QSPI_FLASH_SIZE		(1 << 26)
204 #define FSL_QSPI_FLASH_NUM		2
205 #endif
206 #endif
207 
208 #ifndef SPL_NO_MISC
209 #undef CONFIG_BOOTCOMMAND
210 #if defined(CONFIG_QSPI_BOOT)
211 #define CONFIG_BOOTCOMMAND "run distro_bootcmd; run qspi_bootcmd; "	\
212 			   "env exists secureboot && esbc_halt;;"
213 #elif defined(CONFIG_SD_BOOT)
214 #define CONFIG_BOOTCOMMAND "run distro_bootcmd;run sd_bootcmd; "	\
215 			   "env exists secureboot && esbc_halt;"
216 #endif
217 #endif
218 
219 #include <asm/fsl_secure_boot.h>
220 
221 #endif /* __LS1046ARDB_H__ */
222