xref: /openbmc/u-boot/include/configs/ls1012aqds.h (revision fd0bc623)
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Copyright 2016 Freescale Semiconductor, Inc.
4  */
5 
6 #ifndef __LS1012AQDS_H__
7 #define __LS1012AQDS_H__
8 
9 #include "ls1012a_common.h"
10 
11 /* DDR */
12 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
13 #define CONFIG_CHIP_SELECTS_PER_CTRL	1
14 #define CONFIG_SYS_SDRAM_SIZE		0x40000000
15 #define CONFIG_CMD_MEMINFO
16 #define CONFIG_SYS_MEMTEST_START	0x80000000
17 #define CONFIG_SYS_MEMTEST_END		0x9fffffff
18 
19 /*
20  * QIXIS Definitions
21  */
22 #define CONFIG_FSL_QIXIS
23 
24 #ifdef CONFIG_FSL_QIXIS
25 #define CONFIG_QIXIS_I2C_ACCESS
26 #define CONFIG_SYS_I2C_FPGA_ADDR	0x66
27 #define QIXIS_LBMAP_BRDCFG_REG		0x04
28 #define QIXIS_LBMAP_SWITCH		6
29 #define QIXIS_LBMAP_MASK		0x08
30 #define QIXIS_LBMAP_SHIFT		0
31 #define QIXIS_LBMAP_DFLTBANK		0x00
32 #define QIXIS_LBMAP_ALTBANK		0x08
33 #define QIXIS_RST_CTL_RESET		0x31
34 #define QIXIS_RCFG_CTL_RECONFIG_IDLE	0x20
35 #define QIXIS_RCFG_CTL_RECONFIG_START	0x21
36 #define QIXIS_RCFG_CTL_WATCHDOG_ENBLE	0x08
37 #endif
38 
39 /*
40  * I2C bus multiplexer
41  */
42 #define I2C_MUX_PCA_ADDR_PRI		0x77
43 #define I2C_MUX_PCA_ADDR_SEC		0x76 /* Secondary multiplexer */
44 #define I2C_RETIMER_ADDR		0x18
45 #define I2C_MUX_CH_DEFAULT		0x8
46 #define I2C_MUX_CH_CH7301		0xC
47 #define I2C_MUX_CH5			0xD
48 #define I2C_MUX_CH7			0xF
49 
50 #define I2C_MUX_CH_VOL_MONITOR 0xa
51 
52 /*
53 * RTC configuration
54 */
55 #define RTC
56 #define CONFIG_RTC_PCF8563 1
57 #define CONFIG_SYS_I2C_RTC_ADDR         0x51  /* Channel 3*/
58 
59 /* EEPROM */
60 #define CONFIG_ID_EEPROM
61 #define CONFIG_SYS_I2C_EEPROM_NXID
62 #define CONFIG_SYS_EEPROM_BUS_NUM    0
63 #define CONFIG_SYS_I2C_EEPROM_ADDR   0x57
64 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN     1
65 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
66 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
67 
68 
69 /* Voltage monitor on channel 2*/
70 #define I2C_VOL_MONITOR_ADDR           0x40
71 #define I2C_VOL_MONITOR_BUS_V_OFFSET   0x2
72 #define I2C_VOL_MONITOR_BUS_V_OVF      0x1
73 #define I2C_VOL_MONITOR_BUS_V_SHIFT    3
74 
75 /* DSPI */
76 #define CONFIG_FSL_DSPI1
77 
78 #define MMAP_DSPI          DSPI1_BASE_ADDR
79 
80 #define CONFIG_SYS_DSPI_CTAR0   1
81 
82 #define CONFIG_SYS_DSPI_CTAR1	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
83 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
84 				DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
85 				DSPI_CTAR_DT(0))
86 #define CONFIG_SPI_FLASH_SST /* cs1 */
87 
88 #define CONFIG_SYS_DSPI_CTAR2	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
89 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
90 				DSPI_CTAR_CSSCK(0) | DSPI_CTAR_ASC(0) | \
91 				DSPI_CTAR_DT(0))
92 #define CONFIG_SPI_FLASH_STMICRO /* cs2 */
93 
94 #define CONFIG_SYS_DSPI_CTAR3	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
95 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
96 				DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
97 				DSPI_CTAR_DT(0))
98 #define CONFIG_SPI_FLASH_EON /* cs3 */
99 
100 /*  MMC  */
101 #ifdef CONFIG_MMC
102 #define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33
103 #endif
104 
105 #define CONFIG_PCIE1		/* PCIE controller 1 */
106 
107 #define CONFIG_PCI_SCAN_SHOW
108 
109 #define CONFIG_CMD_MEMINFO
110 #define CONFIG_SYS_MEMTEST_START	0x80000000
111 #define CONFIG_SYS_MEMTEST_END		0x9fffffff
112 
113 #include <asm/fsl_secure_boot.h>
114 #endif /* __LS1012AQDS_H__ */
115