xref: /openbmc/u-boot/include/configs/ls1012aqds.h (revision 90c08fa0)
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Copyright 2016 Freescale Semiconductor, Inc.
4  */
5 
6 #ifndef __LS1012AQDS_H__
7 #define __LS1012AQDS_H__
8 
9 #include "ls1012a_common.h"
10 
11 /* DDR */
12 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
13 #define CONFIG_CHIP_SELECTS_PER_CTRL	1
14 #define CONFIG_NR_DRAM_BANKS		2
15 #define CONFIG_SYS_SDRAM_SIZE		0x40000000
16 #define CONFIG_CMD_MEMINFO
17 #define CONFIG_SYS_MEMTEST_START	0x80000000
18 #define CONFIG_SYS_MEMTEST_END		0x9fffffff
19 
20 /*
21  * QIXIS Definitions
22  */
23 #define CONFIG_FSL_QIXIS
24 
25 #ifdef CONFIG_FSL_QIXIS
26 #define CONFIG_QIXIS_I2C_ACCESS
27 #define CONFIG_SYS_I2C_FPGA_ADDR	0x66
28 #define QIXIS_LBMAP_BRDCFG_REG		0x04
29 #define QIXIS_LBMAP_SWITCH		6
30 #define QIXIS_LBMAP_MASK		0x08
31 #define QIXIS_LBMAP_SHIFT		0
32 #define QIXIS_LBMAP_DFLTBANK		0x00
33 #define QIXIS_LBMAP_ALTBANK		0x08
34 #define QIXIS_RST_CTL_RESET		0x31
35 #define QIXIS_RCFG_CTL_RECONFIG_IDLE	0x20
36 #define QIXIS_RCFG_CTL_RECONFIG_START	0x21
37 #define QIXIS_RCFG_CTL_WATCHDOG_ENBLE	0x08
38 #endif
39 
40 /*
41  * I2C bus multiplexer
42  */
43 #define I2C_MUX_PCA_ADDR_PRI		0x77
44 #define I2C_MUX_PCA_ADDR_SEC		0x76 /* Secondary multiplexer */
45 #define I2C_RETIMER_ADDR		0x18
46 #define I2C_MUX_CH_DEFAULT		0x8
47 #define I2C_MUX_CH_CH7301		0xC
48 #define I2C_MUX_CH5			0xD
49 #define I2C_MUX_CH7			0xF
50 
51 #define I2C_MUX_CH_VOL_MONITOR 0xa
52 
53 /*
54 * RTC configuration
55 */
56 #define RTC
57 #define CONFIG_RTC_PCF8563 1
58 #define CONFIG_SYS_I2C_RTC_ADDR         0x51  /* Channel 3*/
59 
60 /* EEPROM */
61 #define CONFIG_ID_EEPROM
62 #define CONFIG_SYS_I2C_EEPROM_NXID
63 #define CONFIG_SYS_EEPROM_BUS_NUM    0
64 #define CONFIG_SYS_I2C_EEPROM_ADDR   0x57
65 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN     1
66 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
67 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
68 
69 
70 /* Voltage monitor on channel 2*/
71 #define I2C_VOL_MONITOR_ADDR           0x40
72 #define I2C_VOL_MONITOR_BUS_V_OFFSET   0x2
73 #define I2C_VOL_MONITOR_BUS_V_OVF      0x1
74 #define I2C_VOL_MONITOR_BUS_V_SHIFT    3
75 
76 /* DSPI */
77 #define CONFIG_FSL_DSPI1
78 #define CONFIG_DEFAULT_SPI_BUS 1
79 
80 #define CONFIG_CMD_SPI
81 #define MMAP_DSPI          DSPI1_BASE_ADDR
82 
83 #define CONFIG_SYS_DSPI_CTAR0   1
84 
85 #define CONFIG_SYS_DSPI_CTAR1	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
86 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
87 				DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
88 				DSPI_CTAR_DT(0))
89 #define CONFIG_SPI_FLASH_SST /* cs1 */
90 
91 #define CONFIG_SYS_DSPI_CTAR2	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
92 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
93 				DSPI_CTAR_CSSCK(0) | DSPI_CTAR_ASC(0) | \
94 				DSPI_CTAR_DT(0))
95 #define CONFIG_SPI_FLASH_STMICRO /* cs2 */
96 
97 #define CONFIG_SYS_DSPI_CTAR3	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
98 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
99 				DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
100 				DSPI_CTAR_DT(0))
101 #define CONFIG_SPI_FLASH_EON /* cs3 */
102 
103 #define CONFIG_SF_DEFAULT_SPEED      10000000
104 #define CONFIG_SF_DEFAULT_MODE       SPI_MODE_0
105 #define CONFIG_SF_DEFAULT_BUS        1
106 #define CONFIG_SF_DEFAULT_CS         0
107 
108 /*  MMC  */
109 #ifdef CONFIG_MMC
110 #define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33
111 #endif
112 
113 #define CONFIG_PCIE1		/* PCIE controller 1 */
114 
115 #define CONFIG_PCI_SCAN_SHOW
116 
117 #define CONFIG_CMD_MEMINFO
118 #define CONFIG_SYS_MEMTEST_START	0x80000000
119 #define CONFIG_SYS_MEMTEST_END		0x9fffffff
120 
121 #define CONFIG_MISC_INIT_R
122 
123 #endif /* __LS1012AQDS_H__ */
124