1 /* 2 * Copyright 2016 Freescale Semiconductor, Inc. 3 * 4 * SPDX-License-Identifier: GPL-2.0+ 5 */ 6 7 #ifndef __LS1012AQDS_H__ 8 #define __LS1012AQDS_H__ 9 10 #include "ls1012a_common.h" 11 12 /* DDR */ 13 #define CONFIG_DIMM_SLOTS_PER_CTLR 1 14 #define CONFIG_CHIP_SELECTS_PER_CTRL 1 15 #define CONFIG_NR_DRAM_BANKS 2 16 #define CONFIG_SYS_SDRAM_SIZE 0x40000000 17 #define CONFIG_CMD_MEMINFO 18 #define CONFIG_CMD_MEMTEST 19 #define CONFIG_SYS_MEMTEST_START 0x80000000 20 #define CONFIG_SYS_MEMTEST_END 0x9fffffff 21 22 /* 23 * QIXIS Definitions 24 */ 25 #define CONFIG_FSL_QIXIS 26 27 #ifdef CONFIG_FSL_QIXIS 28 #define CONFIG_QIXIS_I2C_ACCESS 29 #define CONFIG_SYS_I2C_FPGA_ADDR 0x66 30 #define QIXIS_LBMAP_BRDCFG_REG 0x04 31 #define QIXIS_LBMAP_SWITCH 6 32 #define QIXIS_LBMAP_MASK 0x08 33 #define QIXIS_LBMAP_SHIFT 0 34 #define QIXIS_LBMAP_DFLTBANK 0x00 35 #define QIXIS_LBMAP_ALTBANK 0x08 36 #define QIXIS_RST_CTL_RESET 0x31 37 #define QIXIS_RCFG_CTL_RECONFIG_IDLE 0x20 38 #define QIXIS_RCFG_CTL_RECONFIG_START 0x21 39 #define QIXIS_RCFG_CTL_WATCHDOG_ENBLE 0x08 40 #endif 41 42 /* 43 * I2C bus multiplexer 44 */ 45 #define I2C_MUX_PCA_ADDR_PRI 0x77 46 #define I2C_MUX_PCA_ADDR_SEC 0x76 /* Secondary multiplexer */ 47 #define I2C_RETIMER_ADDR 0x18 48 #define I2C_MUX_CH_DEFAULT 0x8 49 #define I2C_MUX_CH_CH7301 0xC 50 #define I2C_MUX_CH5 0xD 51 #define I2C_MUX_CH7 0xF 52 53 #define I2C_MUX_CH_VOL_MONITOR 0xa 54 55 /* 56 * RTC configuration 57 */ 58 #define RTC 59 #define CONFIG_RTC_PCF8563 1 60 #define CONFIG_SYS_I2C_RTC_ADDR 0x51 /* Channel 3*/ 61 62 /* EEPROM */ 63 #define CONFIG_ID_EEPROM 64 #define CONFIG_CMD_EEPROM 65 #define CONFIG_SYS_I2C_EEPROM_NXID 66 #define CONFIG_SYS_EEPROM_BUS_NUM 0 67 #define CONFIG_SYS_I2C_EEPROM_ADDR 0x57 68 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 69 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3 70 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5 71 72 73 /* Voltage monitor on channel 2*/ 74 #define I2C_VOL_MONITOR_ADDR 0x40 75 #define I2C_VOL_MONITOR_BUS_V_OFFSET 0x2 76 #define I2C_VOL_MONITOR_BUS_V_OVF 0x1 77 #define I2C_VOL_MONITOR_BUS_V_SHIFT 3 78 79 /* DSPI */ 80 #define CONFIG_FSL_DSPI1 81 #define CONFIG_DEFAULT_SPI_BUS 1 82 83 #define CONFIG_CMD_SPI 84 #define MMAP_DSPI DSPI1_BASE_ADDR 85 86 #define CONFIG_SYS_DSPI_CTAR0 1 87 88 #define CONFIG_SYS_DSPI_CTAR1 (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\ 89 DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \ 90 DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \ 91 DSPI_CTAR_DT(0)) 92 #define CONFIG_SPI_FLASH_SST /* cs1 */ 93 94 #define CONFIG_SYS_DSPI_CTAR2 (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\ 95 DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \ 96 DSPI_CTAR_CSSCK(0) | DSPI_CTAR_ASC(0) | \ 97 DSPI_CTAR_DT(0)) 98 #define CONFIG_SPI_FLASH_STMICRO /* cs2 */ 99 100 #define CONFIG_SYS_DSPI_CTAR3 (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\ 101 DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \ 102 DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \ 103 DSPI_CTAR_DT(0)) 104 #define CONFIG_SPI_FLASH_EON /* cs3 */ 105 106 #define CONFIG_SF_DEFAULT_SPEED 10000000 107 #define CONFIG_SF_DEFAULT_MODE SPI_MODE_0 108 #define CONFIG_SF_DEFAULT_BUS 1 109 #define CONFIG_SF_DEFAULT_CS 0 110 111 /* 112 * USB 113 */ 114 /* EHCI Support - disbaled by default */ 115 /*#define CONFIG_HAS_FSL_DR_USB*/ 116 117 #ifdef CONFIG_HAS_FSL_DR_USB 118 #define CONFIG_USB_EHCI 119 #define CONFIG_USB_EHCI_FSL 120 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET 121 #endif 122 123 /*XHCI Support - enabled by default*/ 124 #define CONFIG_HAS_FSL_XHCI_USB 125 126 #ifdef CONFIG_HAS_FSL_XHCI_USB 127 #define CONFIG_USB_XHCI_FSL 128 #define CONFIG_USB_MAX_CONTROLLER_COUNT 1 129 #define CONFIG_SYS_USB_XHCI_MAX_ROOT_PORTS 2 130 #endif 131 132 /* MMC */ 133 #ifdef CONFIG_MMC 134 #define CONFIG_FSL_ESDHC 135 #define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33 136 #endif 137 138 /* SATA */ 139 #define CONFIG_LIBATA 140 #define CONFIG_SCSI 141 #define CONFIG_SCSI_AHCI 142 #define CONFIG_SCSI_AHCI_PLAT 143 #define CONFIG_CMD_SCSI 144 145 #define CONFIG_SYS_SATA AHCI_BASE_ADDR 146 147 #define CONFIG_SYS_SCSI_MAX_SCSI_ID 1 148 #define CONFIG_SYS_SCSI_MAX_LUN 1 149 #define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \ 150 CONFIG_SYS_SCSI_MAX_LUN) 151 152 #define CONFIG_PCIE1 /* PCIE controller 1 */ 153 154 #define CONFIG_NET_MULTI 155 #define CONFIG_PCI_SCAN_SHOW 156 #define CONFIG_CMD_PCI 157 158 #define CONFIG_CMD_MEMINFO 159 #define CONFIG_CMD_MEMTEST 160 #define CONFIG_SYS_MEMTEST_START 0x80000000 161 #define CONFIG_SYS_MEMTEST_END 0x9fffffff 162 163 #define CONFIG_MISC_INIT_R 164 165 #endif /* __LS1012AQDS_H__ */ 166