xref: /openbmc/u-boot/include/configs/ls1012aqds.h (revision 19d1f1a2)
1 /*
2  * Copyright 2016 Freescale Semiconductor, Inc.
3  *
4  * SPDX-License-Identifier:	GPL-2.0+
5  */
6 
7 #ifndef __LS1012AQDS_H__
8 #define __LS1012AQDS_H__
9 
10 #include "ls1012a_common.h"
11 
12 /* DDR */
13 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
14 #define CONFIG_CHIP_SELECTS_PER_CTRL	1
15 #define CONFIG_NR_DRAM_BANKS		2
16 #define CONFIG_SYS_SDRAM_SIZE		0x40000000
17 #define CONFIG_CMD_MEMINFO
18 #define CONFIG_CMD_MEMTEST
19 #define CONFIG_SYS_MEMTEST_START	0x80000000
20 #define CONFIG_SYS_MEMTEST_END		0x9fffffff
21 
22 /*
23  * QIXIS Definitions
24  */
25 #define CONFIG_FSL_QIXIS
26 
27 #ifdef CONFIG_FSL_QIXIS
28 #define CONFIG_QIXIS_I2C_ACCESS
29 #define CONFIG_SYS_I2C_FPGA_ADDR	0x66
30 #define QIXIS_LBMAP_BRDCFG_REG		0x04
31 #define QIXIS_LBMAP_SWITCH		6
32 #define QIXIS_LBMAP_MASK		0x08
33 #define QIXIS_LBMAP_SHIFT		0
34 #define QIXIS_LBMAP_DFLTBANK		0x00
35 #define QIXIS_LBMAP_ALTBANK		0x08
36 #define QIXIS_RST_CTL_RESET		0x31
37 #define QIXIS_RCFG_CTL_RECONFIG_IDLE	0x20
38 #define QIXIS_RCFG_CTL_RECONFIG_START	0x21
39 #define QIXIS_RCFG_CTL_WATCHDOG_ENBLE	0x08
40 #endif
41 
42 /*
43  * I2C bus multiplexer
44  */
45 #define I2C_MUX_PCA_ADDR_PRI		0x77
46 #define I2C_MUX_PCA_ADDR_SEC		0x76 /* Secondary multiplexer */
47 #define I2C_RETIMER_ADDR		0x18
48 #define I2C_MUX_CH_DEFAULT		0x8
49 #define I2C_MUX_CH_CH7301		0xC
50 #define I2C_MUX_CH5			0xD
51 #define I2C_MUX_CH7			0xF
52 
53 #define I2C_MUX_CH_VOL_MONITOR 0xa
54 
55 /*
56 * RTC configuration
57 */
58 #define RTC
59 #define CONFIG_RTC_PCF8563 1
60 #define CONFIG_SYS_I2C_RTC_ADDR         0x51  /* Channel 3*/
61 
62 /* EEPROM */
63 #define CONFIG_ID_EEPROM
64 #define CONFIG_SYS_I2C_EEPROM_NXID
65 #define CONFIG_SYS_EEPROM_BUS_NUM    0
66 #define CONFIG_SYS_I2C_EEPROM_ADDR   0x57
67 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN     1
68 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
69 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
70 
71 
72 /* Voltage monitor on channel 2*/
73 #define I2C_VOL_MONITOR_ADDR           0x40
74 #define I2C_VOL_MONITOR_BUS_V_OFFSET   0x2
75 #define I2C_VOL_MONITOR_BUS_V_OVF      0x1
76 #define I2C_VOL_MONITOR_BUS_V_SHIFT    3
77 
78 /* DSPI */
79 #define CONFIG_FSL_DSPI1
80 #define CONFIG_DEFAULT_SPI_BUS 1
81 
82 #define CONFIG_CMD_SPI
83 #define MMAP_DSPI          DSPI1_BASE_ADDR
84 
85 #define CONFIG_SYS_DSPI_CTAR0   1
86 
87 #define CONFIG_SYS_DSPI_CTAR1	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
88 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
89 				DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
90 				DSPI_CTAR_DT(0))
91 #define CONFIG_SPI_FLASH_SST /* cs1 */
92 
93 #define CONFIG_SYS_DSPI_CTAR2	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
94 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
95 				DSPI_CTAR_CSSCK(0) | DSPI_CTAR_ASC(0) | \
96 				DSPI_CTAR_DT(0))
97 #define CONFIG_SPI_FLASH_STMICRO /* cs2 */
98 
99 #define CONFIG_SYS_DSPI_CTAR3	(DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
100 				DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
101 				DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
102 				DSPI_CTAR_DT(0))
103 #define CONFIG_SPI_FLASH_EON /* cs3 */
104 
105 #define CONFIG_SF_DEFAULT_SPEED      10000000
106 #define CONFIG_SF_DEFAULT_MODE       SPI_MODE_0
107 #define CONFIG_SF_DEFAULT_BUS        1
108 #define CONFIG_SF_DEFAULT_CS         0
109 
110 /*
111 * USB
112 */
113 /* EHCI Support - disbaled by default */
114 /*#define CONFIG_HAS_FSL_DR_USB*/
115 
116 #ifdef CONFIG_HAS_FSL_DR_USB
117 #define CONFIG_USB_EHCI_FSL
118 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
119 #endif
120 
121 /*XHCI Support - enabled by default*/
122 #define CONFIG_HAS_FSL_XHCI_USB
123 
124 #ifdef CONFIG_HAS_FSL_XHCI_USB
125 #define CONFIG_USB_XHCI_FSL
126 #define CONFIG_USB_MAX_CONTROLLER_COUNT         1
127 #endif
128 
129 /*  MMC  */
130 #ifdef CONFIG_MMC
131 #define CONFIG_FSL_ESDHC
132 #define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33
133 #endif
134 
135 /* SATA */
136 #define CONFIG_LIBATA
137 #define CONFIG_SCSI_AHCI
138 #define CONFIG_SCSI_AHCI_PLAT
139 #define CONFIG_CMD_SCSI
140 
141 #define CONFIG_SYS_SATA				AHCI_BASE_ADDR
142 
143 #define CONFIG_SYS_SCSI_MAX_SCSI_ID		1
144 #define CONFIG_SYS_SCSI_MAX_LUN			1
145 #define CONFIG_SYS_SCSI_MAX_DEVICE		(CONFIG_SYS_SCSI_MAX_SCSI_ID * \
146 						CONFIG_SYS_SCSI_MAX_LUN)
147 
148 #define CONFIG_PCIE1		/* PCIE controller 1 */
149 
150 #define CONFIG_NET_MULTI
151 #define CONFIG_PCI_SCAN_SHOW
152 #define CONFIG_CMD_PCI
153 
154 #define CONFIG_CMD_MEMINFO
155 #define CONFIG_CMD_MEMTEST
156 #define CONFIG_SYS_MEMTEST_START	0x80000000
157 #define CONFIG_SYS_MEMTEST_END		0x9fffffff
158 
159 #define CONFIG_MISC_INIT_R
160 
161 #endif /* __LS1012AQDS_H__ */
162