1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * Copyright 2016 Freescale Semiconductor 4 */ 5 6 #ifndef __LS1012A_COMMON_H 7 #define __LS1012A_COMMON_H 8 9 #define CONFIG_GICV2 10 11 #include <asm/arch/config.h> 12 #include <asm/arch/stream_id_lsch2.h> 13 14 #define CONFIG_SYS_CLK_FREQ 125000000 15 16 #define CONFIG_SKIP_LOWLEVEL_INIT 17 18 #ifdef CONFIG_TFABOOT 19 #define CONFIG_SYS_INIT_SP_ADDR CONFIG_SYS_TEXT_BASE 20 #else 21 #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0) 22 #endif 23 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000) 24 25 #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000 26 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0 27 #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE 28 #define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL 29 30 /* Generic Timer Definitions */ 31 #define COUNTER_FREQUENCY 25000000 /* 25MHz */ 32 33 /* CSU */ 34 #define CONFIG_LAYERSCAPE_NS_ACCESS 35 36 /* Size of malloc() pool */ 37 #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024) 38 39 /*SPI device */ 40 #if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_TFABOOT) 41 #define CONFIG_SYS_QE_FW_IN_SPIFLASH 42 #define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000 43 #define CONFIG_ENV_SPI_BUS 0 44 #define CONFIG_ENV_SPI_CS 0 45 #define CONFIG_ENV_SPI_MAX_HZ 1000000 46 #define CONFIG_ENV_SPI_MODE 0x03 47 #define CONFIG_SPI_FLASH_SPANSION 48 #define CONFIG_FSL_SPI_INTERFACE 49 #define CONFIG_SF_DATAFLASH 50 51 #define CONFIG_FSL_QSPI 52 #define QSPI0_AMBA_BASE 0x40000000 53 #define CONFIG_SPI_FLASH_SPANSION 54 55 #define FSL_QSPI_FLASH_SIZE SZ_64M 56 #define FSL_QSPI_FLASH_NUM 2 57 58 /* 59 * Environment 60 */ 61 #define CONFIG_ENV_OVERWRITE 62 63 #define CONFIG_ENV_SIZE 0x40000 /* 256KB */ 64 #ifdef CONFIG_TFABOOT 65 #define CONFIG_ENV_OFFSET 0x500000 /* 5MB */ 66 #else 67 #define CONFIG_ENV_OFFSET 0x300000 /* 3MB */ 68 #endif 69 #define CONFIG_ENV_SECT_SIZE 0x40000 70 #endif 71 72 /* SATA */ 73 #define CONFIG_SCSI_AHCI_PLAT 74 75 #define CONFIG_SYS_SATA AHCI_BASE_ADDR 76 77 #define CONFIG_SYS_SCSI_MAX_SCSI_ID 1 78 #define CONFIG_SYS_SCSI_MAX_LUN 1 79 #define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \ 80 CONFIG_SYS_SCSI_MAX_LUN) 81 82 /* I2C */ 83 #define CONFIG_SYS_I2C 84 85 #define CONFIG_SYS_NS16550_SERIAL 86 #define CONFIG_SYS_NS16550_REG_SIZE 1 87 #define CONFIG_SYS_NS16550_CLK (get_serial_clock()) 88 89 #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } 90 91 #define CONFIG_SYS_HZ 1000 92 93 #define CONFIG_HWCONFIG 94 #define HWCONFIG_BUFFER_SIZE 128 95 96 #ifndef CONFIG_SPL_BUILD 97 #define BOOT_TARGET_DEVICES(func) \ 98 func(MMC, mmc, 0) \ 99 func(USB, usb, 0) \ 100 func(SCSI, scsi, 0) \ 101 func(DHCP, dhcp, na) 102 #include <config_distro_bootcmd.h> 103 #endif 104 105 /* Initial environment variables */ 106 #define CONFIG_EXTRA_ENV_SETTINGS \ 107 "verify=no\0" \ 108 "loadaddr=0x80100000\0" \ 109 "kernel_addr=0x100000\0" \ 110 "fdt_high=0xffffffffffffffff\0" \ 111 "initrd_high=0xffffffffffffffff\0" \ 112 "kernel_start=0x1000000\0" \ 113 "kernel_load=0xa0000000\0" \ 114 "kernel_size=0x2800000\0" \ 115 116 #undef CONFIG_BOOTCOMMAND 117 #ifdef CONFIG_TFABOOT 118 #define QSPI_NOR_BOOTCOMMAND "pfe stop; sf probe 0:0; sf read $kernel_load "\ 119 "$kernel_start $kernel_size && "\ 120 "bootm $kernel_load" 121 #else 122 #define CONFIG_BOOTCOMMAND "pfe stop; sf probe 0:0; sf read $kernel_load "\ 123 "$kernel_start $kernel_size && "\ 124 "bootm $kernel_load" 125 #endif 126 127 /* Monitor Command Prompt */ 128 #define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */ 129 #define CONFIG_SYS_MAXARGS 64 /* max command args */ 130 131 #define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */ 132 133 #include <asm/arch/soc.h> 134 135 #endif /* __LS1012A_COMMON_H */ 136