1 /*
2  * Copyright 2016 Freescale Semiconductor
3  *
4  * SPDX-License-Identifier:	GPL-2.0+
5  */
6 
7 #ifndef __LS1012A_COMMON_H
8 #define __LS1012A_COMMON_H
9 
10 #define CONFIG_FSL_LAYERSCAPE
11 #define CONFIG_FSL_LSCH2
12 #define CONFIG_LS1012A
13 #define CONFIG_GICV2
14 
15 #define	CONFIG_SYS_HAS_SERDES
16 
17 #include <asm/arch/config.h>
18 #define CONFIG_SYS_NO_FLASH
19 
20 #define CONFIG_SUPPORT_RAW_INITRD
21 
22 #define CONFIG_DISPLAY_BOARDINFO_LATE
23 
24 #define CONFIG_SYS_TEXT_BASE		0x40100000
25 
26 #define CONFIG_SYS_FSL_CLK
27 #define CONFIG_SYS_CLK_FREQ		100000000
28 #define CONFIG_DDR_CLK_FREQ		125000000
29 
30 #define CONFIG_SKIP_LOWLEVEL_INIT
31 #define CONFIG_BOARD_EARLY_INIT_F	1
32 
33 #define CONFIG_SYS_INIT_SP_ADDR		(CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
34 #define CONFIG_SYS_LOAD_ADDR	(CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
35 
36 #define CONFIG_SYS_DDR_SDRAM_BASE	0x80000000
37 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY	0
38 #define CONFIG_SYS_SDRAM_BASE		CONFIG_SYS_DDR_SDRAM_BASE
39 
40 /* Generic Timer Definitions */
41 #define COUNTER_FREQUENCY		CONFIG_SYS_CLK_FREQ/4	/* 25MHz */
42 
43 /* CSU */
44 #define CONFIG_LAYERSCAPE_NS_ACCESS
45 
46 /* Size of malloc() pool */
47 #define CONFIG_SYS_MALLOC_LEN		(CONFIG_ENV_SIZE + 128 * 1024)
48 
49 /*SPI device */
50 #ifdef CONFIG_QSPI_BOOT
51 #define CONFIG_SYS_QE_FW_IN_SPIFLASH
52 #define CONFIG_SYS_FMAN_FW_ADDR		0x400d0000
53 #define CONFIG_ENV_SPI_BUS		0
54 #define CONFIG_ENV_SPI_CS		0
55 #define CONFIG_ENV_SPI_MAX_HZ		1000000
56 #define CONFIG_ENV_SPI_MODE		0x03
57 #define CONFIG_SPI_FLASH_SPANSION
58 #define CONFIG_FSL_SPI_INTERFACE
59 #define CONFIG_SF_DATAFLASH
60 
61 #define CONFIG_FSL_QSPI
62 #define QSPI0_AMBA_BASE		0x40000000
63 #define CONFIG_SPI_FLASH_SPANSION
64 #define CONFIG_SPI_FLASH_BAR
65 
66 #define FSL_QSPI_FLASH_SIZE		(1 << 24)
67 #define FSL_QSPI_FLASH_NUM		2
68 
69 /*
70  * Environment
71  */
72 #define CONFIG_ENV_OVERWRITE
73 
74 #define CONFIG_ENV_IS_IN_SPI_FLASH
75 #define CONFIG_ENV_SIZE			0x40000          /* 256KB */
76 #define CONFIG_ENV_OFFSET		0x200000        /* 2MB */
77 #define CONFIG_ENV_SECT_SIZE		0x40000
78 #endif
79 
80 /* I2C */
81 #define CONFIG_SYS_I2C
82 #define CONFIG_SYS_I2C_MXC
83 #define CONFIG_SYS_I2C_MXC_I2C1		/* enable I2C bus 1 */
84 #define CONFIG_SYS_I2C_MXC_I2C2		/* enable I2C bus 2 */
85 
86 #define CONFIG_CONS_INDEX       1
87 #define CONFIG_SYS_NS16550_SERIAL
88 #define CONFIG_SYS_NS16550_REG_SIZE     1
89 #define CONFIG_SYS_NS16550_CLK          (get_bus_freq(0)/2)
90 
91 #define CONFIG_BAUDRATE			115200
92 #define CONFIG_SYS_BAUDRATE_TABLE	{ 9600, 19200, 38400, 57600, 115200 }
93 
94 /* Command line configuration */
95 #define CONFIG_CMD_ENV
96 #undef CONFIG_CMD_IMLS
97 
98 #define CONFIG_ARCH_EARLY_INIT_R
99 
100 #define CONFIG_SYS_HZ			1000
101 
102 #define CONFIG_HWCONFIG
103 #define HWCONFIG_BUFFER_SIZE		128
104 
105 #define CONFIG_DISPLAY_CPUINFO
106 
107 /* Initial environment variables */
108 #define CONFIG_EXTRA_ENV_SETTINGS		\
109 	"initrd_high=0xffffffff\0"		\
110 	"verify=no\0"				\
111 	"hwconfig=fsl_ddr:bank_intlv=auto\0"	\
112 	"loadaddr=0x80100000\0"			\
113 	"kernel_addr=0x100000\0"		\
114 	"ramdisk_addr=0x800000\0"		\
115 	"ramdisk_size=0x2000000\0"		\
116 	"fdt_high=0xffffffffffffffff\0"		\
117 	"initrd_high=0xffffffffffffffff\0"	\
118 	"kernel_start=0xa00000\0"		\
119 	"kernel_load=0xa0000000\0"		\
120 	"kernel_size=0x2800000\0"		\
121 	"console=ttyAMA0,38400n8\0"
122 
123 #define CONFIG_BOOTARGS		"console=ttyS0,115200 root=/dev/ram0 " \
124 				"earlycon=uart8250,mmio,0x21c0500"
125 #define CONFIG_BOOTCOMMAND		"sf probe 0:0; sf read $kernel_load "\
126 					"$kernel_start $kernel_size && "\
127 					"bootm $kernel_load"
128 
129 /* Monitor Command Prompt */
130 #define CONFIG_SYS_CBSIZE		512	/* Console I/O Buffer Size */
131 #define CONFIG_SYS_PBSIZE		(CONFIG_SYS_CBSIZE + \
132 					sizeof(CONFIG_SYS_PROMPT) + 16)
133 #define CONFIG_SYS_BARGSIZE		CONFIG_SYS_CBSIZE /* Boot args buffer */
134 #define CONFIG_SYS_LONGHELP
135 #define CONFIG_CMDLINE_EDITING		1
136 #define CONFIG_AUTO_COMPLETE
137 #define CONFIG_SYS_MAXARGS		64	/* max command args */
138 
139 #define CONFIG_PANIC_HANG
140 #define CONFIG_SYS_BOOTM_LEN   (64 << 20)      /* Increase max gunzip size */
141 
142 #include <asm/fsl_secure_boot.h>
143 
144 #endif /* __LS1012A_COMMON_H */
145