xref: /openbmc/u-boot/include/configs/draco.h (revision 5ff10aa7)
1 /*
2  * (C) Copyright 2013 Siemens Schweiz AG
3  * (C) Heiko Schocher, DENX Software Engineering, hs@denx.de.
4  *
5  * Based on:
6  * U-Boot file:/include/configs/am335x_evm.h
7  *
8  * Copyright (C) 2011 Texas Instruments Incorporated - http://www.ti.com/
9  *
10  * SPDX-License-Identifier:	GPL-2.0+
11  */
12 
13 #ifndef __CONFIG_DRACO_H
14 #define __CONFIG_DRACO_H
15 
16 #define CONFIG_SIEMENS_DRACO
17 #define MACH_TYPE_DRACO			4314
18 #define CONFIG_SIEMENS_MACH_TYPE	MACH_TYPE_DRACO
19 
20 #include "siemens-am33x-common.h"
21 
22 #define CONFIG_SYS_MPUCLK	275
23 #define DDR_PLL_FREQ	303
24 #undef CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC
25 
26 #define BOARD_DFU_BUTTON_GPIO	27
27 #define BOARD_DFU_BUTTON_LED	64	/* red LED */
28 #define BOARD_STATUS_LED	103	/* green LED */
29 #define GPIO_LAN9303_NRST	88	/* GPIO2_24 = gpio88 */
30 
31 #undef CONFIG_DOS_PARTITION
32 #undef CONFIG_CMD_FAT
33 
34 
35  /* Physical Memory Map */
36 #define CONFIG_MAX_RAM_BANK_SIZE	(1024 << 20)	/* 1GB */
37 
38 /* I2C Configuration */
39 #define CONFIG_SYS_I2C_SPEED		100000
40 
41 #define CONFIG_SYS_I2C_EEPROM_ADDR              0x50
42 #define EEPROM_ADDR_DDR3 0x90
43 #define EEPROM_ADDR_CHIP 0x120
44 
45 #define CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS	0x300
46 
47 #undef CONFIG_SPL_NET_SUPPORT
48 #undef CONFIG_SPL_NET_VCI_STRING
49 #undef CONFIG_SPL_ETH_SUPPORT
50 
51 #undef CONFIG_MII
52 #undef CONFIG_PHY_GIGE
53 #define CONFIG_PHY_SMSC
54 
55 #define CONFIG_FACTORYSET
56 
57 /* Watchdog */
58 #define CONFIG_OMAP_WATCHDOG
59 
60 #ifndef CONFIG_SPL_BUILD
61 
62 /* Default env settings */
63 #define CONFIG_EXTRA_ENV_SETTINGS \
64 	"nand_img_size=0x400000\0" \
65 	"optargs=\0" \
66 	CONFIG_COMMON_ENV_SETTINGS
67 
68 #ifndef CONFIG_RESTORE_FLASH
69 /* set to negative value for no autoboot */
70 #define CONFIG_BOOTDELAY		3
71 
72 #define CONFIG_BOOTCOMMAND \
73 "if dfubutton; then " \
74 	"run dfu_start; " \
75 	"reset; " \
76 "fi;" \
77 "run nand_boot;" \
78 "reset;"
79 
80 
81 #else
82 #define CONFIG_BOOTDELAY		0
83 
84 #define CONFIG_BOOTCOMMAND			\
85 	"setenv autoload no; "			\
86 	"dhcp; "				\
87 	"if tftp 80000000 debrick.scr; then "	\
88 		"source 80000000; "		\
89 	"fi"
90 #endif
91 #endif	/* CONFIG_SPL_BUILD */
92 #endif	/* ! __CONFIG_DRACO_H */
93