1 /* 2 * Embest/Timll DevKit3250 board configuration file 3 * 4 * Copyright (C) 2011-2015 Vladimir Zapolskiy <vz@mleia.com> 5 * 6 * SPDX-License-Identifier: GPL-2.0+ 7 */ 8 9 #ifndef __CONFIG_DEVKIT3250_H__ 10 #define __CONFIG_DEVKIT3250_H__ 11 12 /* SoC and board defines */ 13 #include <linux/sizes.h> 14 #include <asm/arch/cpu.h> 15 16 /* 17 * Define DevKit3250 machine type by hand until it lands in mach-types 18 */ 19 #define MACH_TYPE_DEVKIT3250 3697 20 #define CONFIG_MACH_TYPE MACH_TYPE_DEVKIT3250 21 22 #define CONFIG_SYS_ICACHE_OFF 23 #define CONFIG_SYS_DCACHE_OFF 24 #if !defined(CONFIG_SPL_BUILD) 25 #define CONFIG_SKIP_LOWLEVEL_INIT 26 #endif 27 #define CONFIG_BOARD_EARLY_INIT_F 28 29 /* 30 * Memory configurations 31 */ 32 #define CONFIG_NR_DRAM_BANKS 1 33 #define CONFIG_SYS_MALLOC_LEN SZ_1M 34 #define CONFIG_SYS_SDRAM_BASE EMC_DYCS0_BASE 35 #define CONFIG_SYS_SDRAM_SIZE SZ_64M 36 #define CONFIG_SYS_TEXT_BASE 0x83F00000 37 #define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE + SZ_32K) 38 #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_TEXT_BASE - SZ_1M) 39 40 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + SZ_32K) 41 42 #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_SDRAM_BASE + SZ_4K \ 43 - GENERATED_GBL_DATA_SIZE) 44 45 /* 46 * Serial Driver 47 */ 48 #define CONFIG_SYS_LPC32XX_UART 5 /* UART5 */ 49 #define CONFIG_BAUDRATE 115200 50 51 /* 52 * DMA 53 */ 54 #if !defined(CONFIG_SPL_BUILD) 55 #define CONFIG_DMA_LPC32XX 56 #endif 57 58 /* 59 * I2C 60 */ 61 #define CONFIG_SYS_I2C 62 #define CONFIG_SYS_I2C_LPC32XX 63 #define CONFIG_SYS_I2C_SPEED 100000 64 65 /* 66 * GPIO 67 */ 68 #define CONFIG_LPC32XX_GPIO 69 70 /* 71 * SSP/SPI 72 */ 73 #define CONFIG_LPC32XX_SSP 74 #define CONFIG_LPC32XX_SSP_TIMEOUT 100000 75 76 /* 77 * Ethernet 78 */ 79 #define CONFIG_RMII 80 #define CONFIG_PHY_SMSC 81 #define CONFIG_LPC32XX_ETH 82 #define CONFIG_PHYLIB 83 #define CONFIG_PHY_ADDR 0x1F 84 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 85 86 /* 87 * NOR Flash 88 */ 89 #define CONFIG_SYS_MAX_FLASH_BANKS 1 90 #define CONFIG_SYS_MAX_FLASH_SECT 71 91 #define CONFIG_SYS_FLASH_BASE EMC_CS0_BASE 92 #define CONFIG_SYS_FLASH_SIZE SZ_4M 93 #define CONFIG_SYS_FLASH_CFI 94 95 /* 96 * NAND controller 97 */ 98 #define CONFIG_NAND_LPC32XX_SLC 99 #define CONFIG_SYS_NAND_BASE SLC_NAND_BASE 100 #define CONFIG_SYS_MAX_NAND_DEVICE 1 101 #define CONFIG_SYS_NAND_BASE_LIST { CONFIG_SYS_NAND_BASE } 102 103 /* 104 * NAND chip timings 105 */ 106 #define CONFIG_LPC32XX_NAND_SLC_WDR_CLKS 14 107 #define CONFIG_LPC32XX_NAND_SLC_WWIDTH 66666666 108 #define CONFIG_LPC32XX_NAND_SLC_WHOLD 200000000 109 #define CONFIG_LPC32XX_NAND_SLC_WSETUP 50000000 110 #define CONFIG_LPC32XX_NAND_SLC_RDR_CLKS 14 111 #define CONFIG_LPC32XX_NAND_SLC_RWIDTH 66666666 112 #define CONFIG_LPC32XX_NAND_SLC_RHOLD 200000000 113 #define CONFIG_LPC32XX_NAND_SLC_RSETUP 50000000 114 115 #define CONFIG_SYS_NAND_BLOCK_SIZE 0x20000 116 #define CONFIG_SYS_NAND_PAGE_SIZE NAND_LARGE_BLOCK_PAGE_SIZE 117 #define CONFIG_SYS_NAND_USE_FLASH_BBT 118 119 #define CONFIG_CMD_JFFS2 120 #define CONFIG_CMD_NAND 121 122 /* 123 * USB 124 */ 125 #define CONFIG_USB_OHCI_LPC32XX 126 #define CONFIG_USB_ISP1301_I2C_ADDR 0x2d 127 #define CONFIG_USB_STORAGE 128 129 /* 130 * U-Boot General Configurations 131 */ 132 #define CONFIG_SYS_LONGHELP 133 #define CONFIG_SYS_CBSIZE 1024 134 #define CONFIG_SYS_PBSIZE \ 135 (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16) 136 #define CONFIG_SYS_MAXARGS 16 137 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE 138 139 #define CONFIG_AUTO_COMPLETE 140 #define CONFIG_CMDLINE_EDITING 141 #define CONFIG_VERSION_VARIABLE 142 #define CONFIG_DISPLAY_CPUINFO 143 #define CONFIG_DOS_PARTITION 144 145 /* 146 * Pass open firmware flat tree 147 */ 148 149 /* 150 * Environment 151 */ 152 #define CONFIG_ENV_IS_IN_NAND 1 153 #define CONFIG_ENV_SIZE SZ_128K 154 #define CONFIG_ENV_OFFSET 0x000A0000 155 156 #define CONFIG_BOOTCOMMAND \ 157 "dhcp; " \ 158 "tftp ${loadaddr} ${serverip}:${tftpdir}/${bootfile}; " \ 159 "tftp ${dtbaddr} ${serverip}:${tftpdir}/devkit3250.dtb; " \ 160 "setenv nfsargs ip=dhcp root=/dev/nfs nfsroot=${serverip}:${nfsroot},tcp; " \ 161 "setenv bootargs ${bootargs} ${nfsargs} ${userargs}; " \ 162 "bootm ${loadaddr} - ${dtbaddr}" 163 164 #define CONFIG_EXTRA_ENV_SETTINGS \ 165 "autoload=no\0" \ 166 "ethaddr=00:01:90:00:C0:81\0" \ 167 "dtbaddr=0x81000000\0" \ 168 "nfsroot=/opt/projects/images/vladimir/oe/devkit3250/rootfs\0" \ 169 "tftpdir=vladimir/oe/devkit3250\0" \ 170 "userargs=oops=panic\0" 171 172 /* 173 * U-Boot Commands 174 */ 175 176 /* 177 * Boot Linux 178 */ 179 #define CONFIG_CMDLINE_TAG 180 #define CONFIG_SETUP_MEMORY_TAGS 181 #define CONFIG_ZERO_BOOTDELAY_CHECK 182 183 #define CONFIG_BOOTFILE "uImage" 184 #define CONFIG_BOOTARGS "console=ttyS0,115200n8" 185 #define CONFIG_LOADADDR 0x80008000 186 187 /* 188 * SPL specific defines 189 */ 190 /* SPL will be executed at offset 0 */ 191 #define CONFIG_SPL_TEXT_BASE 0x00000000 192 193 /* SPL will use SRAM as stack */ 194 #define CONFIG_SPL_STACK 0x0000FFF8 195 #define CONFIG_SPL_BOARD_INIT 196 197 /* Use the framework and generic lib */ 198 #define CONFIG_SPL_FRAMEWORK 199 #define CONFIG_SPL_LIBGENERIC_SUPPORT 200 #define CONFIG_SPL_LIBCOMMON_SUPPORT 201 202 /* SPL will use serial */ 203 #define CONFIG_SPL_SERIAL_SUPPORT 204 205 /* SPL loads an image from NAND */ 206 #define CONFIG_SPL_NAND_SIMPLE 207 #define CONFIG_SPL_NAND_RAW_ONLY 208 #define CONFIG_SPL_NAND_SUPPORT 209 #define CONFIG_SPL_NAND_DRIVERS 210 211 #define CONFIG_SPL_NAND_ECC 212 #define CONFIG_SPL_NAND_SOFTECC 213 214 #define CONFIG_SPL_MAX_SIZE 0x20000 215 #define CONFIG_SPL_PAD_TO CONFIG_SPL_MAX_SIZE 216 217 /* U-Boot will be 0x60000 bytes, loaded and run at CONFIG_SYS_TEXT_BASE */ 218 #define CONFIG_SYS_NAND_U_BOOT_OFFS 0x40000 219 #define CONFIG_SYS_NAND_U_BOOT_SIZE 0x60000 220 221 #define CONFIG_SYS_NAND_U_BOOT_START CONFIG_SYS_TEXT_BASE 222 #define CONFIG_SYS_NAND_U_BOOT_DST CONFIG_SYS_TEXT_BASE 223 224 /* See common/spl/spl.c spl_set_header_raw_uboot() */ 225 #define CONFIG_SYS_MONITOR_LEN CONFIG_SYS_NAND_U_BOOT_SIZE 226 227 /* 228 * Include SoC specific configuration 229 */ 230 #include <asm/arch/config.h> 231 232 #endif /* __CONFIG_DEVKIT3250_H__*/ 233