xref: /openbmc/u-boot/include/configs/devkit3250.h (revision 00a457b2)
1 /*
2  * Embest/Timll DevKit3250 board configuration file
3  *
4  * Copyright (C) 2011-2015 Vladimir Zapolskiy <vz@mleia.com>
5  *
6  * SPDX-License-Identifier:	GPL-2.0+
7  */
8 
9 #ifndef __CONFIG_DEVKIT3250_H__
10 #define __CONFIG_DEVKIT3250_H__
11 
12 /* SoC and board defines */
13 #include <linux/sizes.h>
14 #include <asm/arch/cpu.h>
15 
16 /*
17  * Define DevKit3250 machine type by hand until it lands in mach-types
18  */
19 #define MACH_TYPE_DEVKIT3250		3697
20 #define CONFIG_MACH_TYPE		MACH_TYPE_DEVKIT3250
21 
22 #define CONFIG_SYS_ICACHE_OFF
23 #define CONFIG_SYS_DCACHE_OFF
24 #if !defined(CONFIG_SPL_BUILD)
25 #define CONFIG_SKIP_LOWLEVEL_INIT
26 #endif
27 #define CONFIG_BOARD_EARLY_INIT_F
28 
29 /*
30  * Memory configurations
31  */
32 #define CONFIG_NR_DRAM_BANKS		1
33 #define CONFIG_SYS_MALLOC_LEN		SZ_1M
34 #define CONFIG_SYS_SDRAM_BASE		EMC_DYCS0_BASE
35 #define CONFIG_SYS_SDRAM_SIZE		SZ_64M
36 #define CONFIG_SYS_TEXT_BASE		0x83FA0000
37 #define CONFIG_SYS_MEMTEST_START	(CONFIG_SYS_SDRAM_BASE + SZ_32K)
38 #define CONFIG_SYS_MEMTEST_END		(CONFIG_SYS_TEXT_BASE - SZ_1M)
39 
40 #define CONFIG_SYS_LOAD_ADDR		(CONFIG_SYS_SDRAM_BASE + SZ_32K)
41 
42 #define CONFIG_SYS_INIT_SP_ADDR		(CONFIG_SYS_SDRAM_BASE + SZ_4K \
43 					 - GENERATED_GBL_DATA_SIZE)
44 
45 /*
46  * Serial Driver
47  */
48 #define CONFIG_SYS_LPC32XX_UART		5   /* UART5 */
49 #define CONFIG_BAUDRATE			115200
50 
51 /*
52  * I2C
53  */
54 #define CONFIG_SYS_I2C
55 #define CONFIG_SYS_I2C_LPC32XX
56 #define CONFIG_SYS_I2C_SPEED		100000
57 #define CONFIG_CMD_I2C
58 
59 /*
60  * GPIO
61  */
62 #define CONFIG_LPC32XX_GPIO
63 
64 /*
65  * SSP/SPI
66  */
67 #define CONFIG_LPC32XX_SSP
68 #define CONFIG_LPC32XX_SSP_TIMEOUT	100000
69 #define CONFIG_CMD_SPI
70 
71 /*
72  * Ethernet
73  */
74 #define CONFIG_RMII
75 #define CONFIG_PHY_SMSC
76 #define CONFIG_LPC32XX_ETH
77 #define CONFIG_PHYLIB
78 #define CONFIG_PHY_ADDR			0x1F
79 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
80 #define CONFIG_CMD_MII
81 #define CONFIG_CMD_PING
82 #define CONFIG_CMD_DHCP
83 
84 /*
85  * NOR Flash
86  */
87 #define CONFIG_SYS_MAX_FLASH_BANKS	1
88 #define CONFIG_SYS_MAX_FLASH_SECT	71
89 #define CONFIG_SYS_FLASH_BASE		EMC_CS0_BASE
90 #define CONFIG_SYS_FLASH_SIZE		SZ_4M
91 #define CONFIG_SYS_FLASH_CFI
92 
93 /*
94  * NAND controller
95  */
96 #define CONFIG_NAND_LPC32XX_SLC
97 #define CONFIG_SYS_NAND_BASE		SLC_NAND_BASE
98 #define CONFIG_SYS_MAX_NAND_DEVICE	1
99 #define CONFIG_SYS_NAND_BASE_LIST	{ CONFIG_SYS_NAND_BASE }
100 
101 /*
102  * NAND chip timings
103  */
104 #define CONFIG_LPC32XX_NAND_SLC_WDR_CLKS	14
105 #define CONFIG_LPC32XX_NAND_SLC_WWIDTH		66666666
106 #define CONFIG_LPC32XX_NAND_SLC_WHOLD		200000000
107 #define CONFIG_LPC32XX_NAND_SLC_WSETUP		50000000
108 #define CONFIG_LPC32XX_NAND_SLC_RDR_CLKS	14
109 #define CONFIG_LPC32XX_NAND_SLC_RWIDTH		66666666
110 #define CONFIG_LPC32XX_NAND_SLC_RHOLD		200000000
111 #define CONFIG_LPC32XX_NAND_SLC_RSETUP		50000000
112 
113 #define CONFIG_SYS_NAND_BLOCK_SIZE		0x20000
114 #define CONFIG_SYS_NAND_PAGE_SIZE		NAND_LARGE_BLOCK_PAGE_SIZE
115 #define CONFIG_SYS_NAND_USE_FLASH_BBT
116 
117 #define CONFIG_CMD_NAND
118 
119 /*
120  * U-Boot General Configurations
121  */
122 #define CONFIG_SYS_LONGHELP
123 #define CONFIG_SYS_CBSIZE		1024
124 #define CONFIG_SYS_PBSIZE		\
125 	(CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
126 #define CONFIG_SYS_MAXARGS		16
127 #define CONFIG_SYS_BARGSIZE		CONFIG_SYS_CBSIZE
128 
129 #define CONFIG_AUTO_COMPLETE
130 #define CONFIG_CMDLINE_EDITING
131 #define CONFIG_VERSION_VARIABLE
132 #define CONFIG_DISPLAY_CPUINFO
133 #define CONFIG_DOS_PARTITION
134 
135 /*
136  * Pass open firmware flat tree
137  */
138 #define CONFIG_OF_LIBFDT
139 
140 /*
141  * Environment
142  */
143 #define CONFIG_ENV_IS_IN_NAND		1
144 #define CONFIG_ENV_SIZE			SZ_128K
145 #define CONFIG_ENV_OFFSET		0x000A0000
146 
147 #define CONFIG_BOOTCOMMAND			\
148 	"dhcp; "				\
149 	"tftp ${loadaddr} ${serverip}:${tftpdir}/${bootfile}; "		\
150 	"tftp ${dtbaddr} ${serverip}:${tftpdir}/devkit3250.dtb; "	\
151 	"setenv nfsargs ip=dhcp root=/dev/nfs nfsroot=${serverip}:${nfsroot},tcp; "	\
152 	"setenv bootargs ${bootargs} ${nfsargs} ${userargs}; "			\
153 	"bootm ${loadaddr} - ${dtbaddr}"
154 
155 #define CONFIG_EXTRA_ENV_SETTINGS		\
156 	"autoload=no\0"				\
157 	"ethaddr=00:01:90:00:C0:81\0"		\
158 	"dtbaddr=0x81000000\0"			\
159 	"nfsroot=/opt/projects/images/vladimir/oe/devkit3250/rootfs\0"	\
160 	"tftpdir=vladimir/oe/devkit3250\0"	\
161 	"userargs=oops=panic\0"
162 
163 /*
164  * U-Boot Commands
165  */
166 #define CONFIG_CMD_CACHE
167 
168 /*
169  * Boot Linux
170  */
171 #define CONFIG_CMDLINE_TAG
172 #define CONFIG_SETUP_MEMORY_TAGS
173 #define CONFIG_ZERO_BOOTDELAY_CHECK
174 #define CONFIG_BOOTDELAY		1
175 
176 #define CONFIG_BOOTFILE			"uImage"
177 #define CONFIG_BOOTARGS			"console=ttyS0,115200n8"
178 #define CONFIG_LOADADDR			0x80008000
179 
180 /*
181  * SPL specific defines
182  */
183 /* SPL will be executed at offset 0 */
184 #define CONFIG_SPL_TEXT_BASE		0x00000000
185 
186 /* SPL will use SRAM as stack */
187 #define CONFIG_SPL_STACK		0x0000FFF8
188 #define CONFIG_SPL_BOARD_INIT
189 
190 /* Use the framework and generic lib */
191 #define CONFIG_SPL_FRAMEWORK
192 #define CONFIG_SPL_LIBGENERIC_SUPPORT
193 #define CONFIG_SPL_LIBCOMMON_SUPPORT
194 
195 /* SPL will use serial */
196 #define CONFIG_SPL_SERIAL_SUPPORT
197 
198 /* SPL loads an image from NAND */
199 #define CONFIG_SPL_NAND_SIMPLE
200 #define CONFIG_SPL_NAND_RAW_ONLY
201 #define CONFIG_SPL_NAND_SUPPORT
202 #define CONFIG_SPL_NAND_DRIVERS
203 
204 #define CONFIG_SPL_NAND_ECC
205 #define CONFIG_SPL_NAND_SOFTECC
206 
207 #define CONFIG_SPL_MAX_SIZE		0x20000
208 #define CONFIG_SPL_PAD_TO		CONFIG_SPL_MAX_SIZE
209 
210 /* U-Boot will be 0x60000 bytes, loaded and run at CONFIG_SYS_TEXT_BASE */
211 #define CONFIG_SYS_NAND_U_BOOT_OFFS	0x40000
212 #define CONFIG_SYS_NAND_U_BOOT_SIZE	0x60000
213 
214 #define CONFIG_SYS_NAND_U_BOOT_START	CONFIG_SYS_TEXT_BASE
215 #define CONFIG_SYS_NAND_U_BOOT_DST	CONFIG_SYS_TEXT_BASE
216 
217 /* See common/spl/spl.c  spl_set_header_raw_uboot() */
218 #define CONFIG_SYS_MONITOR_LEN		CONFIG_SYS_NAND_U_BOOT_SIZE
219 
220 /*
221  * Include SoC specific configuration
222  */
223 #include <asm/arch/config.h>
224 
225 #endif  /* __CONFIG_DEVKIT3250_H__*/
226