xref: /openbmc/u-boot/include/configs/apalis-tk1.h (revision 0ab5433d)
1 /*
2  * Copyright (c) 2017 Toradex, Inc.
3  *
4  * Configuration settings for the Toradex Apalis TK1 modules.
5  *
6  * SPDX-License-Identifier:	GPL-2.0+
7  */
8 
9 #ifndef __CONFIG_H
10 #define __CONFIG_H
11 
12 #include <linux/sizes.h>
13 
14 #include "tegra124-common.h"
15 
16 #define CONFIG_ARCH_MISC_INIT
17 
18 /* High-level configuration options */
19 #define CONFIG_DISPLAY_BOARDINFO_LATE	/* Calls show_board_info() */
20 
21 /* Board-specific serial config */
22 #define CONFIG_TEGRA_ENABLE_UARTA
23 #define CONFIG_SYS_NS16550_COM1		NV_PA_APB_UARTA_BASE
24 
25 /* I2C */
26 #define CONFIG_SYS_I2C_TEGRA
27 
28 /* SD/MMC support */
29 #define CONFIG_SUPPORT_EMMC_BOOT	/* eMMC specific */
30 
31 /* Environment in eMMC, before config block at the end of 1st "boot sector" */
32 #define CONFIG_ENV_IS_IN_MMC
33 #define CONFIG_ENV_OFFSET		(-CONFIG_ENV_SIZE + \
34 					 CONFIG_TDX_CFG_BLOCK_OFFSET)
35 #define CONFIG_SYS_MMC_ENV_DEV		0
36 #define CONFIG_SYS_MMC_ENV_PART		1
37 
38 /* USB host support */
39 #define CONFIG_USB_EHCI
40 #define CONFIG_USB_EHCI_TEGRA
41 
42 /* PCI host support */
43 #undef CONFIG_PCI_SCAN_SHOW
44 #define CONFIG_CMD_PCI
45 
46 /* PCI networking support */
47 #define CONFIG_E1000_NO_NVM
48 
49 /* General networking support */
50 #define CONFIG_IP_DEFRAG
51 #define CONFIG_TFTP_BLOCKSIZE		16352
52 #define CONFIG_TFTP_TSIZE
53 
54 /* Miscellaneous commands */
55 #define CONFIG_FAT_WRITE
56 
57 #undef CONFIG_IPADDR
58 #define CONFIG_IPADDR		192.168.10.2
59 #define CONFIG_NETMASK		255.255.255.0
60 #undef CONFIG_SERVERIP
61 #define CONFIG_SERVERIP		192.168.10.1
62 
63 #define CONFIG_BOOTCOMMAND \
64 	"run emmcboot; setenv fdtfile ${soc}-apalis-${fdt_board}.dtb && " \
65 		"run distro_bootcmd"
66 
67 #define DFU_ALT_EMMC_INFO	"apalis-tk1.img raw 0x0 0x500 mmcpart 1; " \
68 				"boot part 0 1 mmcpart 0; " \
69 				"rootfs part 0 2 mmcpart 0; " \
70 				"uImage fat 0 1 mmcpart 0; " \
71 				"tegra124-apalis-eval.dtb fat 0 1 mmcpart 0"
72 
73 #define EMMC_BOOTCMD \
74 	"emmcargs=ip=off root=/dev/mmcblk0p2 rw rootfstype=ext3 rootwait\0" \
75 	"emmcboot=run setup; setenv bootargs ${defargs} ${emmcargs} " \
76 		"${setupargs} ${vidargs}; echo Booting from internal eMMC " \
77 		"chip...; run emmcdtbload; load mmc 0:1 ${kernel_addr_r} " \
78 		"${boot_file} && run fdt_fixup && " \
79 		"bootm ${kernel_addr_r} - ${dtbparam}\0" \
80 	"emmcdtbload=setenv dtbparam; load mmc 0:1 ${fdt_addr_r} " \
81 		"${soc}-apalis-${fdt_board}.dtb && " \
82 		"setenv dtbparam ${fdt_addr_r}\0"
83 
84 #define NFS_BOOTCMD \
85 	"nfsargs=ip=:::::eth0:on root=/dev/nfs rw\0" \
86 	"nfsboot=pci enum; run setup; setenv bootargs ${defargs} ${nfsargs} " \
87 		"${setupargs} ${vidargs}; echo Booting via DHCP/TFTP/NFS...; " \
88 		"run nfsdtbload; dhcp ${kernel_addr_r} " \
89 		"&& run fdt_fixup && bootm ${kernel_addr_r} - ${dtbparam}\0" \
90 	"nfsdtbload=setenv dtbparam; tftp ${fdt_addr_r} " \
91 		"${soc}-apalis-${fdt_board}.dtb " \
92 		"&& setenv dtbparam ${fdt_addr_r}\0"
93 
94 #define SD_BOOTCMD \
95 	"sdargs=ip=off root=/dev/mmcblk1p2 rw rootfstype=ext3 rootwait\0" \
96 	"sdboot=run setup; setenv bootargs ${defargs} ${sdargs} ${setupargs} " \
97 		"${vidargs}; echo Booting from SD card in 8bit slot...; " \
98 		"run sddtbload; load mmc 1:1 ${kernel_addr_r} " \
99 		"${boot_file} && run fdt_fixup && " \
100 		"bootm ${kernel_addr_r} - ${dtbparam}\0" \
101 	"sddtbload=setenv dtbparam; load mmc 1:1 ${fdt_addr_r} " \
102 		"${soc}-apalis-${fdt_board}.dtb " \
103 		"&& setenv dtbparam ${fdt_addr_r}\0"
104 
105 #define USB_BOOTCMD \
106 	"usbargs=ip=off root=/dev/sda2 rw rootfstype=ext3 rootwait\0" \
107 	"usbboot=run setup; setenv bootargs ${defargs} ${setupargs} " \
108 		"${usbargs} ${vidargs}; echo Booting from USB stick...; " \
109 		"usb start && run usbdtbload; load usb 0:1 ${kernel_addr_r} " \
110 		"${boot_file} && run fdt_fixup && " \
111 		"bootm ${kernel_addr_r} - ${dtbparam}\0" \
112 	"usbdtbload=setenv dtbparam; load usb 0:1 ${fdt_addr_r} " \
113 		"${soc}-apalis-${fdt_board}.dtb " \
114 		"&& setenv dtbparam ${fdt_addr_r}\0"
115 
116 #define BOARD_EXTRA_ENV_SETTINGS \
117 	"boot_file=uImage\0" \
118 	"console=ttyS0\0" \
119 	"defargs=lp0_vec=2064@0xf46ff000 core_edp_mv=1150 core_edp_ma=4000 " \
120 		"usb_port_owner_info=2 lane_owner_info=6 emc_max_dvfs=0\0" \
121 	"dfu_alt_info=" DFU_ALT_EMMC_INFO "\0" \
122 	EMMC_BOOTCMD \
123 	"fdt_board=eval\0" \
124 	"fdt_fixup=;\0" \
125 	NFS_BOOTCMD \
126 	SD_BOOTCMD \
127 	"setethupdate=if env exists ethaddr; then; else setenv ethaddr " \
128 		"00:14:2d:00:00:00; fi; pci enum && tftpboot ${loadaddr} " \
129 		"flash_eth.img && source ${loadaddr}\0" \
130 	"setsdupdate=setenv interface mmc; setenv drive 1; mmc rescan; " \
131 		"load ${interface} ${drive}:1 ${loadaddr} flash_blk.img " \
132 		"|| setenv drive 2; mmc rescan; load ${interface} ${drive}:1 " \
133 		"${loadaddr} flash_blk.img && " \
134 		"source ${loadaddr}\0" \
135 	"setup=setenv setupargs igb_mac=${ethaddr} " \
136 		"consoleblank=0 no_console_suspend=1 console=tty1 " \
137 		"console=${console},${baudrate}n8 debug_uartport=lsport,0 " \
138 		"${memargs}\0" \
139 	"setupdate=run setsdupdate || run setusbupdate || run setethupdate\0" \
140 	"setusbupdate=usb start && setenv interface usb; setenv drive 0; " \
141 		"load ${interface} ${drive}:1 ${loadaddr} flash_blk.img && " \
142 		"source ${loadaddr}\0" \
143 	USB_BOOTCMD \
144 	"vidargs=video=tegrafb0:640x480-16@60 fbcon=map:1\0"
145 
146 /* Increase console I/O buffer size */
147 #undef CONFIG_SYS_CBSIZE
148 #define CONFIG_SYS_CBSIZE		1024
149 
150 /* Increase arguments buffer size */
151 #undef CONFIG_SYS_BARGSIZE
152 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
153 
154 /* Increase print buffer size */
155 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
156 
157 /* Increase maximum number of arguments */
158 #undef CONFIG_SYS_MAXARGS
159 #define CONFIG_SYS_MAXARGS		32
160 
161 #define CONFIG_CMD_TIME
162 
163 #define CONFIG_SUPPORT_RAW_INITRD
164 #define CONFIG_SYS_BOOT_RAMDISK_HIGH
165 
166 #include "tegra-common-usb-gadget.h"
167 #include "tegra-common-post.h"
168 
169 /* Reserve top 1M for secure RAM */
170 #define CONFIG_ARMV7_SECURE_BASE		0xfff00000
171 #define CONFIG_ARMV7_SECURE_RESERVE_SIZE	0x00100000
172 
173 #endif /* __CONFIG_H */
174