xref: /openbmc/u-boot/include/configs/ap_sh4a_4a.h (revision 15809705)
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Configuation settings for the Alpha Project AP-SH4A-4A board
4  *
5  * Copyright (C) 2012 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com>
6  */
7 
8 #ifndef __AP_SH4A_4A_H
9 #define __AP_SH4A_4A_H
10 
11 #define CONFIG_CPU_SH7734	1
12 #define CONFIG_400MHZ_MODE	1
13 
14 #define CONFIG_DISPLAY_BOARDINFO
15 #undef  CONFIG_SHOW_BOOT_PROGRESS
16 
17 /* Ether */
18 #define CONFIG_SH_ETHER_USE_PORT (0)
19 #define CONFIG_SH_ETHER_PHY_ADDR (0x0)
20 #define CONFIG_SH_ETHER_PHY_MODE (PHY_INTERFACE_MODE_GMII)
21 #define CONFIG_SH_ETHER_SH7734_MII (0x02) /* GMII */
22 #define CONFIG_BITBANGMII
23 #define CONFIG_BITBANGMII_MULTI
24 
25 /* undef to save memory	*/
26 /* Monitor Command Prompt */
27 /* Buffer size for Console output */
28 #define CONFIG_SYS_PBSIZE		256
29 /* List of legal baudrate settings for this board */
30 #define CONFIG_SYS_BAUDRATE_TABLE	{ 115200 }
31 
32 /* SCIF */
33 #define CONFIG_SCIF			1
34 #define CONFIG_CONS_SCIF4	1
35 
36 /* Suppress display of console information at boot */
37 
38 /* SDRAM */
39 #define CONFIG_SYS_SDRAM_BASE	(0x88000000)
40 #define CONFIG_SYS_SDRAM_SIZE	(64 * 1024 * 1024)
41 #define CONFIG_SYS_LOAD_ADDR	(CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024)
42 
43 #define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE)
44 #define CONFIG_SYS_MEMTEST_END	 (CONFIG_SYS_MEMTEST_START + CONFIG_SYS_SDRAM_SIZE)
45 /* Enable alternate, more extensive, memory test */
46 /* Scratch address used by the alternate memory test */
47 #undef  CONFIG_SYS_MEMTEST_SCRATCH
48 
49 /* Enable temporary baudrate change while serial download */
50 #undef  CONFIG_SYS_LOADS_BAUD_CHANGE
51 
52 /* FLASH */
53 #undef  CONFIG_SYS_FLASH_QUIET_TEST
54 #define CONFIG_SYS_FLASH_EMPTY_INFO
55 #define CONFIG_SYS_FLASH_BASE	(0xA0000000)
56 #define CONFIG_SYS_MAX_FLASH_SECT	512
57 
58 /* if you use all NOR Flash , you change dip-switch. Please see Manual. */
59 #define CONFIG_SYS_MAX_FLASH_BANKS	1
60 #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE }
61 
62 /* Timeout for Flash erase operations (in ms) */
63 #define CONFIG_SYS_FLASH_ERASE_TOUT	(3 * 1000)
64 /* Timeout for Flash write operations (in ms) */
65 #define CONFIG_SYS_FLASH_WRITE_TOUT	(3 * 1000)
66 /* Timeout for Flash set sector lock bit operations (in ms) */
67 #define CONFIG_SYS_FLASH_LOCK_TOUT	(3 * 1000)
68 /* Timeout for Flash clear lock bit operations (in ms) */
69 #define CONFIG_SYS_FLASH_UNLOCK_TOUT	(3 * 1000)
70 
71 /*
72  * Use hardware flash sectors protection instead
73  * of U-Boot software protection
74  */
75 #undef  CONFIG_SYS_DIRECT_FLASH_TFTP
76 
77 /* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */
78 #define CONFIG_SYS_MONITOR_BASE	(CONFIG_SYS_FLASH_BASE)
79 /* Monitor size */
80 #define CONFIG_SYS_MONITOR_LEN	(256 * 1024)
81 /* Size of DRAM reserved for malloc() use */
82 #define CONFIG_SYS_MALLOC_LEN	(256 * 1024)
83 #define CONFIG_SYS_BOOTMAPSZ	(8 * 1024 * 1024)
84 
85 /* ENV setting */
86 #define CONFIG_ENV_OVERWRITE	1
87 #define CONFIG_ENV_SECT_SIZE	(128 * 1024)
88 #define CONFIG_ENV_SIZE		(CONFIG_ENV_SECT_SIZE)
89 #define CONFIG_ENV_ADDR		(CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN)
90 /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */
91 #define CONFIG_ENV_OFFSET	(CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE)
92 #define CONFIG_ENV_SIZE_REDUND	(CONFIG_ENV_SECT_SIZE)
93 
94 /* Board Clock */
95 #if defined(CONFIG_400MHZ_MODE)
96 #define CONFIG_SYS_CLK_FREQ 50000000
97 #else
98 #define CONFIG_SYS_CLK_FREQ 44444444
99 #endif
100 #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ
101 
102 #endif	/* __AP_SH4A_4A_H */
103