1 /* 2 * Configuation settings for the Alpha Project AP-SH4A-4A board 3 * 4 * Copyright (C) 2012 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com> 5 * 6 * SPDX-License-Identifier: GPL-2.0+ 7 */ 8 9 #ifndef __AP_SH4A_4A_H 10 #define __AP_SH4A_4A_H 11 12 #define CONFIG_CPU_SH7734 1 13 #define CONFIG_400MHZ_MODE 1 14 15 #define CONFIG_DISPLAY_BOARDINFO 16 #undef CONFIG_SHOW_BOOT_PROGRESS 17 18 /* Ether */ 19 #define CONFIG_SH_ETHER_USE_PORT (0) 20 #define CONFIG_SH_ETHER_PHY_ADDR (0x0) 21 #define CONFIG_SH_ETHER_PHY_MODE (PHY_INTERFACE_MODE_GMII) 22 #define CONFIG_SH_ETHER_SH7734_MII (0x02) /* GMII */ 23 #define CONFIG_BITBANGMII 24 #define CONFIG_BITBANGMII_MULTI 25 26 /* undef to save memory */ 27 #define CONFIG_SYS_LONGHELP 28 /* Monitor Command Prompt */ 29 /* Buffer size for Console output */ 30 #define CONFIG_SYS_PBSIZE 256 31 /* List of legal baudrate settings for this board */ 32 #define CONFIG_SYS_BAUDRATE_TABLE { 115200 } 33 34 /* SCIF */ 35 #define CONFIG_SCIF 1 36 #define CONFIG_CONS_SCIF4 1 37 38 /* Suppress display of console information at boot */ 39 40 /* SDRAM */ 41 #define CONFIG_SYS_SDRAM_BASE (0x88000000) 42 #define CONFIG_SYS_SDRAM_SIZE (64 * 1024 * 1024) 43 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024) 44 45 #define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE) 46 #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + CONFIG_SYS_SDRAM_SIZE) 47 /* Enable alternate, more extensive, memory test */ 48 #undef CONFIG_SYS_ALT_MEMTEST 49 /* Scratch address used by the alternate memory test */ 50 #undef CONFIG_SYS_MEMTEST_SCRATCH 51 52 /* Enable temporary baudrate change while serial download */ 53 #undef CONFIG_SYS_LOADS_BAUD_CHANGE 54 55 /* FLASH */ 56 #define CONFIG_FLASH_CFI_DRIVER 1 57 #define CONFIG_SYS_FLASH_CFI 58 #undef CONFIG_SYS_FLASH_QUIET_TEST 59 #define CONFIG_SYS_FLASH_EMPTY_INFO 60 #define CONFIG_SYS_FLASH_BASE (0xA0000000) 61 #define CONFIG_SYS_MAX_FLASH_SECT 512 62 63 /* if you use all NOR Flash , you change dip-switch. Please see Manual. */ 64 #define CONFIG_SYS_MAX_FLASH_BANKS 1 65 #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE } 66 67 /* Timeout for Flash erase operations (in ms) */ 68 #define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000) 69 /* Timeout for Flash write operations (in ms) */ 70 #define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000) 71 /* Timeout for Flash set sector lock bit operations (in ms) */ 72 #define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000) 73 /* Timeout for Flash clear lock bit operations (in ms) */ 74 #define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000) 75 76 /* 77 * Use hardware flash sectors protection instead 78 * of U-Boot software protection 79 */ 80 #undef CONFIG_SYS_FLASH_PROTECTION 81 #undef CONFIG_SYS_DIRECT_FLASH_TFTP 82 83 /* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */ 84 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE) 85 /* Monitor size */ 86 #define CONFIG_SYS_MONITOR_LEN (256 * 1024) 87 /* Size of DRAM reserved for malloc() use */ 88 #define CONFIG_SYS_MALLOC_LEN (256 * 1024) 89 #define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024) 90 91 /* ENV setting */ 92 #define CONFIG_ENV_OVERWRITE 1 93 #define CONFIG_ENV_SECT_SIZE (128 * 1024) 94 #define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE) 95 #define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN) 96 /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */ 97 #define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE) 98 #define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE) 99 100 /* Board Clock */ 101 #if defined(CONFIG_400MHZ_MODE) 102 #define CONFIG_SYS_CLK_FREQ 50000000 103 #else 104 #define CONFIG_SYS_CLK_FREQ 44444444 105 #endif 106 #define CONFIG_SH_TMU_CLK_FREQ CONFIG_SYS_CLK_FREQ 107 #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ 108 #define CONFIG_SYS_TMU_CLK_DIV 4 109 110 #endif /* __AP_SH4A_4A_H */ 111